The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Effect of hydrostatic pressure on the deformation behavior of polyethylene and polycarbonate in tension and in compression
Abstract
The stress‐strain response of crystalline high density polyethylene and of amorphous polycarbonate has been determined in tension and in compression at superimposed pressures up to 1104 MPa(160 ksi). Strain softening occurred in the polycarbonate at low pressures but was inhibited by pressure. Tensile necking occurred in both materials, but was promoted by pressure in polyethylene and inhibited in polycarbonate. The initial modulus, E , and the flow stress, σ, at a given offset strain varied linearly with the mean pressure, P , with essentially the same pressure coefficient, α. Thus, E = (1+α P ) E 0 and σ = (1+α P )σ 0 , where E 0 and σ 0 are values at zero mean pressure. In polyethylene, the coefficient, σ 0 , was the same in tension and compression, indicating that the strength differential between tension and compression was a simple manifestation of pressure‐dependent yielding. In polycarbonate the coefficient, σ 0 , was different in tension and in compression, implying an effect due to the third stress invariant or to anisotropy. The results suggest a constitutive model for polymers in which the flow stress is linearly dependent on mean pressure, but in which inelastic volume change is negligible. The results also suggest that the pressure dependence of flow stress in polymers is the same as that of the initial modulus.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A theory for the low-temperature plastic deformation of glassy polymers
Argon, A. S. (1973) · Philosophical Magazine · doi:10.1080/14786437308220987 · Cited by 801
Cited by
Large inelastic deformation of glassy polymers. part I: rate dependent constitutive model
Boyce, M. C., Parks, D. M., & Argon, A. S. (1988) · Mechanics of Materials · doi:10.1016/0167-6636(88)90003-8 · Cited by 1,110
Richeton, J., Ahzi, S., Vecchio, K. S., Jiang, F. C., & Adharapurapu, R. R. (2006) · International Journal of Solids and Structures · doi:10.1016/j.ijsolstr.2005.06.040 · Cited by 570
Boyce, M. C., & Arruda, E. M. (1990) · Polymer Engineering & Science · doi:10.1002/pen.760302005 · Cited by 253
Richeton, J., Schlatter, G., Vecchio, K. S., Rémond, Y., & Ahzi, S. (2005) · Polymer · doi:10.1016/j.polymer.2005.06.103 · Cited by 189
Metadata
- Authors
- Spitzig, W. A., & Richmond, O.
- Venue
- Polymer Engineering & Science
- Publisher
- Wiley
- Published
- 1979-12
- Volume
- 19
- Issue
- 16
- Pages
- 1129-1139
- ISSN
- 0032-3888 (ISSN-L)
- 1548-2634
- OpenAlex
- W2006254524
- Cited by
- 220
- References
- 1
- FWCI
- 1.10
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.