Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat
Cited by 166

The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.

A dielectric study of molecular relaxation in oxidized and chlorinated polyethylenes

Ashcraft, Charles R., Boyd, Richard H. · 1976 · Journal of Polymer Science: Polymer Physics Edition

Abstract

A study was made of the dielectric relaxation in polyethylenes rendered dielectrically active through oxidation (0.5–1.7 carbonyls/1000 CH 2) and chlorination (14–22 Cl/1000 CH 2). Both linear and branched polymers were studied. All of the relaxations between the melt and −196° were studied in the frequency range 10 Hz to 10kHz (100 kHz in the chlorinated samples). In the linear samples a wide range of crystallinities was studied (55% in quenched specimens to 95% in extended‐chain specimens obtained by crystallization at 5 kbar). As is consistent with its being a crystalline process, the α peak was found to discontinously disappear on melting of the samples and reappear on recrystallizing on cooling. The disappearance of the smaller crystals before the larger ones appeared to be evident in the isothermal loss versus frequency curves. The relaxation strength of the α process increases with crystallinity. The measured relaxation strength is less than that expected on the basis of direct proportionality to the crystalline fraction with full contribution of all dipoles in the crystalline material. However, the intensity is not sufficiently low for the process to be interpreted in terms of reorientation of localized conformational defects in the crystal. The variation of intensity with crystallinity is best interpreted in terms of full participation of crystalline dipoles but with selective partitioning of both carbonyls and chlorines favoring the amorphous domains. A strong correlation of the α loss peak location (Tmax at constant frequency or log fmax at constant T) with crystallinity for both carbonyl and chlorine containing polymers was found. This variation is interpreted in terms of chain rotations in the crystal where the activation free energy depends on crystal thickness. The dependence of log fmax and Tmax on lamellar thickness as well as a comparison with the loss peaks of ketones dissolved in parafins indicates that the chain rotation is not rigid and is accompanied by twisting as the rotation propagates through the crystal. In agreement with previous studies the β process is found to be strong only in the branched polymers but can be detected in the chlorinated linear polymer. The β process was resolved from the α in the branched samples by curve fitting and its activation parameters determined. The γ relaxation peak in oxidized polymers including its high asymmetry (low‐temperature tail) and increasing ε max with increasing frequency and temperature when plotted isochronally can be interpreted in terms of a simple nearly symmetrical relaxation time spectrum that narrows with increasing temperature. No increase in relaxation strength with temperature was found. The chlorinated polymers behave similarly but appear to have some Boltzmann enhancement (450–750 cal/mole) of relaxation strength with temperature. The dependence of relaxation strength on crystallinity indicates that the process is an amorphous one. Further, no evidence of relaxation peak shape changes with crystallinity that could be interpreted in terms of a crystalline component in addition to the amorphous one was found. The comparison of the γ relaxation strength with that expected on the basis of full participation of amorphous dipoles indicates that only a small fraction (∼10% in oxidized linear polymers) of them are involved in the relaxation. Thus it would seem that a glass–rubber transition interpretation is not indicated but rather a localized chain motion. It is suggested that the γ process, including its intensity, width, and activation parameters, can be interpreted in terms of an (unspecified) localized conformational (bond rotation) motion that is perturbed by differing local packing environments. The thermal expansion lessens the effects of variations in packing and leads to narrowing with increasing temperature. The conformational motion itself leads to increase in thermal expansion and hence a transition in the latter property. Some previously proposed localized amorphous phase conformational motions appear to be suitable candidates for the bond rotation motion. A weak relaxation peak found at temperatures below the γ and at 10 kHz may possibly be the dielectric analog of the δ cryogenic peak found previously mechanically at lower frequencies.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1002/pol.1976.180141204

Cites

2 of 2 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 166

Metadata

Authors
Ashcraft, C. R., & Boyd, R. H.
Venue
Journal of Polymer Science: Polymer Physics Edition
Publisher
Wiley
Published
1976-12
Volume
14
Issue
12
Pages
2153-2193
ISSN
  • 0098-1273 (ISSN-L)
  • 1542-9385
OpenAlex
W1989451956
Cited by
166
References
2
FWCI
7.66
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.