The DOI matches its Crossref record.
Contribution to the Transient Plane Source Method for Measuring Thermophysical Properties of Solids
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
Error in TPS measurement comes from two sources: (1) uncertainty in experimental data and selection of time interval for analysis, and (2) deviation of the original idealized analytical heat transfer model from the practical measurement scenario.
“Error in the TPS measurement 20-31 comes from two sources: (1) uncertainty in the experimental data and the selection of time interval for analysis, and (2) deviation of the original idealized analytical heat transfer model 3, 32 from the practical measurement scenario.”
From Analysis and improvement of the hot disk transient plane source method for low thermal conductivity materials (2020) · cites this paper as [24]
Previous works on the uncertainty in experimental data and time interval selection focused on sensitivity of input parameters and data fitting procedure based on the original analytical model, but could not explain the overestimation of k in thermal insulation materials.
“Previous works on the former aspect focused on the sensitivity of the input parameters and the data fitting procedure based on the original analytical model, but could not explain the overestimation of k in TI materials. 21-26”
From Analysis and improvement of the hot disk transient plane source method for low thermal conductivity materials (2020) · cites this paper as [24]
The new analytical model overcomes the known divergence issue near t = 0 in the original solution and involves no diverging term at any time.
“This model better mimics the real sensor and involves no diverging term at any time.”
From Analysis and improvement of the hot disk transient plane source method for low thermal conductivity materials (2020) · cites this paper as [24]
The traditional model's diverging issue was dealt with in literature by setting a cutoff time for the lower limit of the integral (τc > 0.03) and concatenating the result to a 1D heat transfer approximation model at τc < 0.03.
“It is not mentioned how this issue was dealt with in the standard, 9 but in literature, a cutoff time for the lower limit of the integral in Eq. 4 was set (such that τc > 0.03) and the result is concatenated to a 1D heat transfer approximation model at τc < 0.03. 24”
From Analysis and improvement of the hot disk transient plane source method for low thermal conductivity materials (2020) · cites this paper as [24]
Citations
Cites
No references could be resolved yet.
Research works printed but not linked: 8
- L’. Kubičár, V. Boháč, in Proceedings of 24th International Conference on Thermal Conductivity/12th International Thermal Expansion Symposium, ed. by P.S. Gaal, D.E. Apostolescu (Technomic Pub., Lancaster, PA, 1999), p. 135
- S.E. Gustafsson, Rev. Sci. Instrum. 62, 797 (1991) · DOI · Paper page
- Y. Jannot, Z. Acem, Meas. Sci. Technol. 18, 1229 (2007) · DOI
- E. Karawacki, B.M. Suleiman, I. ul-Haq, B. Nhi, Rev. Sci. Instrum. 63, 4390 (1992) · DOI
- V. Boháč, M.K. Gustavsson, L’. Kubičár, S.E. Gustafsson, Rev. Sci. Instrum. 71, 2452 (2000) · DOI · Paper page
- J.V. Beck, K.J. Arnold, Parameter Estimation in Engineering and Science (Wiley, New York, 1977)
- S. Malinarič, P. Ďuríšek, Acta Phys. Slovaca 55, 165 (2005)
- S. Malinarič, Int. J. Thermophys. 28, 20 (2007) · DOI · Paper page
Cited by
Sorted by citations
Zheng, Q., Kaur, S., Dames, C., & Prasher, R. S. (2020) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2020.119331 · Cited by 162
Metadata
- Authors
- Malinarič, S.
- Affiliations
- Constantine the Philosopher University in Nitra (SK)
- Corresponding author
- Malinarič, Svetozár
- ORCID
- Malinarič, Svetozár
- Venue
- International Journal of Thermophysics
- Published
- 2013-08-27
- Volume
- 34
- Issue
- 10
- Pages
- 1953-1961
- ISSN
- 0195-928X (ISSN-L)
- 1572-9567
- OpenAlex
- W2005369866
- Cited by
- 18
- References
- 0
- Citations by year
- 2025: 1 · 2023: 1 · 2022: 3 · 2021: 2 · 2020: 3 · 2018: 2 · 2017: 2 · 2016: 2 · 2015: 1 · 2014: 1
- FWCI
- 0.60
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- www.springer.com/tdm (tdm)
- Locations
- International Journal of Thermophysics (publishedVersion)
- Topics
- Physical Sciences › Materials Science › Materials Chemistry › Thermal properties of materials
- Physical Sciences › Engineering › Mechanics of Materials › Thermography and Photoacoustic Techniques
- Physical Sciences › Engineering › Computational Mechanics › Heat Transfer and Numerical Methods
- Keywords
- transient plane source method, thermal conductivity, thermal diffusivity, temperature measurement uncertainty, poly(methyl methacrylate), error propagation
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
