The DOI matches its Crossref record.
Enhanced performance and durability of low catalyst loading PEM water electrolyser based on a short-side chain perfluorosulfonic ionomer
Open accessAbstract
Water electrolysis supplied by renewable energy is the foremost technology for producing “green” hydrogen for fuel cell vehicles. In addition, the ability to rapidly follow an intermittent load makes electrolysis an ideal solution for grid-balancing caused by differences in supply and demand for energy generation and consumption. Membrane-electrode assemblies (MEAs) designed for polymer electrolyte membrane (PEM) water electrolysis, based on a novel short-side chain (SSC) perfluorosulfonic acid (PFSA) membrane, Aquivion®, with various cathode and anode noble metal loadings, were investigated in terms of both performance and durability. Utilizing a nanosized Ir 0.7 Ru 0.3 O x solid solution anode catalyst and a supported Pt/C cathode catalyst, in combination with the Aquivion® membrane, gave excellent electrolysis performances exceeding 3.2 A·cm −2 at 1.8 V terminal cell voltage (∼80% efficiency) at 90 °C in the presence of a total catalyst loading of 1.6 mg⋅cm −2 . A very small loss of efficiency, corresponding to 30 mV voltage increase, was recorded at 3 A⋅cm −2 using a total noble metal catalyst loading of less than 0.5 mg·cm −2 (compared to the industry standard of 2 mg·cm −2 ). Steady-state durability tests, carried out for 1000 h at 1 A⋅cm −2 , showed excellent stability for the MEA with total noble metal catalyst loading of 1.6 mg·cm −2 (cell voltage increase ∼5 μV/h). Moderate degradation rate (cell voltage increase ∼15 μV/h) was recorded for the low loading 0.5 mg·cm −2 , MEA. Similar stability characteristics were observed in durability tests at 3 A·cm −2 . These high performance and stability characteristics were attributed to the enhanced proton conductivity and good stability of the novel membrane, the optimized structural properties of the Ir and Ru oxide solid solution and the enrichment of Ir species on the surface for the anodic catalyst.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Recent advances in solid oxide cell technology for electrolysis
Hauch, A., Küngas, R., Blennow, P., Hansen, A. B., Hansen, J. B., Mathiesen, B. V., & Mogensen, M. B. (2020) · Science · doi:10.1126/science.aba6118 · Cited by 1,371
Feng, Q., Yuan, X., Liu, G., Wei, B., Zhang, Z., Li, H., & Wang, H. (2017) · Journal of Power Sources · doi:10.1016/j.jpowsour.2017.09.006 · Cited by 776
Recent advances in proton exchange membrane water electrolysis
Liu, R.-T., Xu, Z.-L., Li, F.-M., Chen, F.-Y., Yu, J.-Y., Yan, Y., Chen, Y., & Xia, B. Y. (2023) · Chemical Society Reviews · doi:10.1039/d2cs00681b · Cited by 701
Status and perspectives of key materials for PEM electrolyzer
Zhang, K., Liang, X., Wang, L., Sun, K., Wang, Y., Xie, Z., Wu, Q., Bai, X., Hamdy, M. S., Chen, H., et al. (2022) · Nano Research Energy · doi:10.26599/nre.2022.9120032 · Cited by 497
Water Electrolysis toward Elevated Temperature: Advances, Challenges and Frontiers
Zhang, W., Liu, M., Gu, X., Shi, Y., Deng, Z., & Cai, N. (2023) · Chemical Reviews · doi:10.1021/acs.chemrev.2c00573 · Cited by 441
Metadata
- Authors
- Siracusano, S., Baglio, V., Van Dijk, N., Merlo, L., & Aricò, A. S.
- Venue
- Applied Energy
- Publisher
- Elsevier BV
- Published
- 2017-04
- Volume
- 192
- Pages
- 477-489
- ISSN
- 0306-2619 (ISSN-L)
- OpenAlex
- W2519007791
- Cited by
- 221
- References
- 0
- FWCI
- 5.49
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Enhanced performance and durability of low catalyst loading PEM water electrolyser based on a short-side chain perfluorosulfonic ionomer. https://app.cochat.ai/papers/10.1016/j.apenergy.2016.09.011
- The paper
- Siracusano, S., Baglio, V., Van Dijk, N., Merlo, L., & Aricò, A. S. (2017). Enhanced performance and durability of low catalyst loading PEM water electrolyser based on a short-side chain perfluorosulfonic ionomer. Applied Energy. https://doi.org/10.1016/j.apenergy.2016.09.011
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.