The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Heat transfer and pressure drop characteristics of a flat plate manifold microchannel heat exchanger in counter flow configuration
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“The high pressure drop in microchannel heat exchangers is mainly caused by two issues; the maldistribution of flow in the microchannels and the small flow area along the flow-path [5].”
From Compact and microchannel heat exchangers: A comprehensive review of air-side friction factor and heat transfer correlations (2018) · cites this paper as [5]
In the citing paper
“Some researchers used water as working fluid instead of air for manifold microchannel heat exchangers [5, 131].”
From Compact and microchannel heat exchangers: A comprehensive review of air-side friction factor and heat transfer correlations (2018) · cites this paper as [5]
In the citing paper
“The manifolds can solve these issues by reducing the flow misdistribution and distributing the flow along entire length of the microchannel via dividing the flow-path into smaller flow regions, as shown in Figure 12”
From Compact and microchannel heat exchangers: A comprehensive review of air-side friction factor and heat transfer correlations (2018) · cites this paper as [5]
Citations
Cites
Forced air cooling by using manifold microchannel heat sinks
Kim, Y. H., Chun, W. C., Kim, J. T., Pak, B. C., & Baek, B. J. (1998) · KSME International Journal · doi:10.1007/bf02945732 · Cited by 58
Research works printed but not linked: 33
- Vali, 2009, Numerical model and effectiveness correlations for a run-around heat recovery system with combined counter and cross flow exchangers, Int. J. Heat Mass Transf, 52, 5827, 10.1016/j.ijheatmasstransfer.2009.07.020 · DOI
- Zhan, 2011, Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling – paving the path toward sustainable cooling of buildings, Energy, 36, 6790, 10.1016/j.energy.2011.10.019 · DOI
- Kays, 1968, The effectiveness of a counter-flow heat exchanger with cross-flow headers, Int. J. Heat Mass Transf, 772, 10.1016/0017-9310(68)90078-1 · DOI
- Tuckerman, 1981, High-performance heat sinking for VLSI, Elect. Dev. Lett, EDL-2, 126, 10.1109/EDL.1981.25367 · DOI
- Samalam, 1989, Convective heat transfer in microchannels, J. Elect. Mater, 18, 611, 10.1007/BF02657475 · DOI
- Adams, 1999, Applicability of traditional turbulent single-phase forced convection correlations to non-circular microchannels, Int. J. Heat Mass Transf, 42, 4411, 10.1016/S0017-9310(99)00102-7 · DOI
- Adams, 1998, An experimental investigation of single-phase forced convection in microchannels, Int. J. Heat Mass Transf, 41, 851, 10.1016/S0017-9310(97)00180-4 · DOI
- Gnielinski, 1976, New equations for heat and mass transfer in turbulent pipe and channel flow, Int. Chem. Eng, 16, 359
- Rahman, 2000, Measurements of heat transfer in microchannel heat sinks, Int. Commun. Heat Mass, 27, 495, 10.1016/S0735-1933(00)00132-9 · DOI
- Harms, 1999, Developing convective heat transfer in deep rectangular microchannels, Int. J. Heat Fluid Fl, 20, 149, 10.1016/S0142-727X(98)10055-3 · DOI
- Grigull, 1965, Thermischer einlauf in ausgebildeter laminarer rohrströmung, Int. J. Heat Mass Transf, 8, 669, 10.1016/0017-9310(65)90016-5 · DOI
- Owhaib, 2004, Experimental investigation of single-phase convective heat transfer in circular microchannels, Exp. Therm. Fluid Sci, 28, 105, 10.1016/S0894-1777(03)00028-1 · DOI
- Kandlikar, 2013, Heat transfer in microchannels—2012 status and research needs, J. Heat Transfer, 135, 91001, 10.1115/1.4024354 · DOI
- Palm, 2001, Heat transfer in microchannels, Microsc. Thermophys. Eng, 5, 155, 10.1080/108939501753222850 · DOI
- Sobhan, 2001, A comparative analysis of studies on heat transfer and fluid flow in microchannels, Microsc. Thermophys. Eng, 5, 293, 10.1080/10893950152646759 · DOI
- Wang, 1994, Experimental investigation on liquid forced-convection heat transfer through microchannels, Int. J. Heat Mass Transf, 37, 73, 10.1016/0017-9310(94)90011-6 · DOI
- Chen, 2002, Heat transfer and pressure drop in fractal tree-like microchannel nets, Int. J. Heat Mass Transf, 45, 2643, 10.1016/S0017-9310(02)00013-3 · DOI
- Bejan, 2000, Convective trees of fluid channels for volumetric cooling, Int. J. Heat Mass Transf, 43, 3105, 10.1016/S0017-9310(99)00353-1 · DOI
- Wang, 2006, Thermal characteristics of tree-shaped microchannel nets for cooling of a rectangular heat sink, Int. J. Therm. Sci, 45, 1103, 10.1016/j.ijthermalsci.2006.01.010 · DOI
- Heymann, 2010, Optimization of fractal-like branching microchannel heat sinks for single-phase flows, Int. J. Therm. Sci, 49, 1383, 10.1016/j.ijthermalsci.2010.01.015 · DOI
- Escher, 2009, Efficiency of optimized bifurcating tree-like and parallel microchannel networks in the cooling of electronics, Int. J. Heat Mass Transf, 52, 1421, 10.1016/j.ijheatmasstransfer.2008.07.048 · DOI
- Ghodoossi, 2005, Thermal and hydrodynamic analysis of a fractal microchannel network, Energy Convers. Manag, 46, 771, 10.1016/j.enconman.2004.05.008 · DOI
- Pence, 2010, The simplicity of fractal-like flow networks for effective heat and mass transport, Exp. Therm. Fluid Sci, 34, 474, 10.1016/j.expthermflusci.2009.02.004 · DOI
- Daniels, 2011, Experimental studies of adiabatic flow boiling in fractal-like branching microchannels, Exp. Therm. Fluid Sci, 35, 1, 10.1016/j.expthermflusci.2010.07.016 · DOI
- Senn, 2004, Laminar mixing, heat transfer and pressure drop in tree-like microchannel nets and their application for thermal management in polymer electrolyte fuel cells, J. Power Sources, 130, 178, 10.1016/j.jpowsour.2003.12.025 · DOI
- Copeland, 1997, Manifold microchannel heat sinks: isothermal analysis, IEEE Trans. Compon., Packag., Manuf. Technol. A, 20, 96, 10.1109/95.588554 · DOI
- Ryu, 2003, Three-dimensional numerical optimization of a manifold microchannel heat sink, Int. J. Heat Mass Transf, 46, 1553, 10.1016/S0017-9310(02)00443-X · DOI
- Kermani, 2009, Experimental investigation of heat transfer performance of a manifold microchannel heat sink for cooling of concentrated solar cells, Elect. Compon. Technol. Conf, 453
- Boteler, 2012, Numerical investigation and sensitivity analysis of manifold microchannel coolers, Int. J. Heat Mass Transf, 55, 7698, 10.1016/j.ijheatmasstransfer.2012.07.073 · DOI
- Sarangi, 2014, Manifold microchannel heat sink design using optimization under uncertainty, Int. J. Heat Mass Transf, 69, 92, 10.1016/j.ijheatmasstransfer.2013.09.067 · DOI
- Sharma, 2013, Thermofluidics and energetics of a manifold microchannel heat sink for electronics with recovered hot water as working fluid, Int. J. Heat Mass Transf, 58, 135, 10.1016/j.ijheatmasstransfer.2012.11.012 · DOI
- Jha, 2015, Experimental characterization of a nickel-alloy based manifold-microgroove evaporator, Heat Transfer Eng, 36, 33, 10.1080/01457632.2014.906276 · DOI
- Arie, 2015, Numerical modeling and thermal optimization of a single-phase flow manifold-microchannel plate heat exchanger, Int. J. Heat Mass Transf, 81, 478, 10.1016/j.ijheatmasstransfer.2014.10.022 · DOI
Cited by
Sorted by citations
Qasem, N. A. A., & Zubair, S. M. (2018) · Energy Conversion and Management · doi:10.1016/j.enconman.2018.06.104 · Cited by 134
Metadata
- Authors
- Andhare, R. S., Shooshtari, A., Dessiatoun, S. V., & Ohadi, M. M.
- Affiliations
- University of Maryland, College Park (US)
- Corresponding author
- Ohadi, Michael M.
- Venue
- Applied Thermal Engineering
- Publisher
- Elsevier BV
- Published
- 2016-03
- Volume
- 96
- Pages
- 178-189
- ISSN
- 1359-4311 (ISSN-L)
- OpenAlex
- W2178048403
- Cited by
- 106
- References
- 1
- Citations by year
- 2026: 10 · 2025: 16 · 2024: 11 · 2023: 7 · 2022: 13 · 2021: 9 · 2020: 9 · 2019: 9 · 2018: 9 · 2017: 10 · 2016: 3
- FWCI
- 7.20
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Applied Thermal Engineering (publishedVersion)
- Funders
- Petroleum Institute (Abu Dhabi, United Arab Emirates)
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer and Optimization
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer and Boiling Studies
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer Mechanisms
- Keywords
- microchannel heat exchangers, plate heat exchanger, counter-flow configuration, heat transfer coefficient, pressure drop, microgrooves, low heat flux, water working fluid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Heat transfer and pressure drop characteristics of a flat plate manifold microchannel heat exchanger in counter flow configuration. https://app.cochat.ai/papers/10.1016/j.applthermaleng.2015.10.133
- The paper
- Andhare, R. S., Shooshtari, A., Dessiatoun, S. V., & Ohadi, M. M. (2016). Heat transfer and pressure drop characteristics of a flat plate manifold microchannel heat exchanger in counter flow configuration. Applied Thermal Engineering. https://doi.org/10.1016/j.applthermaleng.2015.10.133