Thermal characterisation of compact heat exchangers for air heating and cooling in electric vehicles
Open accessThe claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
Many previous models assumed uniform humidity and temperature distribution along the fin height, an adiabatic fin tip at half fin height, and did not consider partial dehumidification scenarios.
“However, many of these models assumed (1) uniform humidity and temperature distribution along the fin height, (2) adiabatic fin tip at half fin height, and (3) did not consider partial dehumidification scenarios.”
From Thermal-hydraulic and drainage performance of microchannel heat exchangers for refrigeration and heat pump systems under frosting, defrosting, and wet conditions: A comprehensive review (2023) · cites this paper as [111]
The Introduction says the traditional effectiveness approach is inaccurate when the boundary between dry and wet surfaces moves, and presents intentional analysis of partially wet conditions as a novelty. That lends limited support to the point about earlier treatment of partial dehumidification, but it does not establish that many previous models omitted it. Neither the Introduction nor the model passages describe earlier models assuming uniform conditions along fin height or an adiabatic tip at half fin height; page numbers are unavailable in our copy. (LLM, conf=0.72)
Experimental — accuracy not yet measured
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Cites
Xu, B., Zhang, C., Wang, Y., Chen, J., Xu, K., Li, F., & Wang, N. (2015) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2015.06.037 · Cited by 69 · see citing works
Flagged first, then by citations
Research works printed but not linked: 19
- Afram, A., and Janabi-Sharifi, F., 2014, Review of Modeling Methods for HVAC Systems, Appl. Therm. Eng., Vol. 67, pp. 507-519.
- Bjurling, F., Corberán, J. M., Payá, J., and Torregrosa-Jaime, B., 2014, Control Strategies for the Air- Conditioning in Electric Vehicles, Proc. VII Congreso Ibérico y V Congreso Iberoamericano de Ciencias y Técnicas del Frío, CYTEF 2014, Tarragona, Spain, Vol. 7, pp. 769-777.
- Braun, J. E., Klein, S. A., and Mitchell, J. W., 1989, Effectiveness Models for Cooling Towers and Cooling Coils, ASHRAE Transactions, Vol. 95, pp. 164-174.
- ESDU 86018, 1991, Engineering Science Data Unit 86018 with Amendment A, July 1991, ESDU International plc, London, pp. 92-107.
- Hewitt, G.F. (Ed.), 1998, Heat Exchanger Design Handbook 1998, Begell House Inc., New York, p. 1.5-3.
- Jin, G.Y., Cai, W. J., Wang, Y. W., and Yao, Y., 2006, A Simple Dynamic Model of Cooling Coil Unit, Energy Convers. Manage., Vol. 47, pp. 2659-2672.
- Jokar, A., Eckels, S. J., and Hosni, M. H., 2010, Single-Phase Flow in Meso-Channel Compact Heat Exchangers for Air Conditioning Applications, Heat Transfer Eng., Vol. 31, pp. 3-16.
- Kowsky, C., Wolfe, E., Leitzel, L., and Oddi, F., 2012, Unitary HPAC System, SAE Int. J. Passeng. Cars - Mech. Syst., Vol. 5, pp. 1016-1025.
- Leighton, D., 2015, Combined Fluid Loop Thermal Management for Electric Drive Vehicle Range Improvement, SAE Int. J. Passeng. Cars -Mech. Syst., Vol. 8, pp. 711-720.
- Liang, Y. Y., Liu, C. C., Li, C. Z., and Chen, J. P., 2015, Experimental and Simulation Study on the Air Side Thermal Hydraulic Performance of Automotive Heat Exchangers, App. Therm. Eng., Vol. 87, pp. 305-315.
- Oliet, C., Pérez-Segarra, C. D., Danov, S., and Oliva, A., 2007, Numerical Simulation of Dehumidifying Fin- and-Tube Heat Exchangers: Semi-Analytical Modelling and Experimental Comparison, Int. J. Refrig., Vol. 30, pp. 1266-1277.
- Park, Y. G., and Jacobi, A. M., 2009a, Air-Side Heat Transfer and Friction Correlations for Flat-Tube Louver- Fin Heat Exchangers, J. Heat Transf., Vol. 131, 021801.
- Park, Y. G., and Jacobi, A. M., 2009b, The Air-Side Thermal-Hydraulic Performance of Flat-Tube Heat Exchangers with Louvered, Wavy, and Plain Fins Under Dry and Wet Conditions, J. Heat Transf., Vol. 131, 061801.
- Qi, Z., 2014, Advances on Air Conditioning and Heat Pump System in Electric Vehicles -A Review, Renew. Sust. Energ. Rev., Vol. 38, pp. 754-764.
- Torregrosa-Jaime, B., Payá, J., and Corberán, J.M., 2013a, Design of Efficient Air-Conditioning Systems for Electric Vehicles, SAE Int. J. Alt. Power., Vol. 2, pp. 291-303.
- Vaisi, A., Esmaeilpour, M., and Taherian, H., 2011, Experimental Investigation of Geometry Effects on the Performance of a Compact Louvered Heat Exchanger, App. Therm. Eng, Vol. 31, pp. 3337-3346.
- VDI, 2010, VDI Heat Atlas, 2nd ed., Springer, Düsseldorf, pp. 707-708.
- Wang, C. C., 1999, On the Airside Performance of Fin-and-Tube Heat Exchangers, in Heat Transfer Enhancement of Heat Exchangers, eds. S. Kakaç, A. E. Bergles, F. Mayinger and H. Yüncü, Springer, Netherlands, Vol. 355, pp. 141-162.
- Webb, R. L., and Kim, N. H., 2005, Principles of Enhanced Heat Transfer, 2nd ed., Taylor & Francis, New York, pp. 101.
Cited by
Sorted by citations
Xiong, T., Liu, G., Gao, Q., Yan, G., & Yu, J. (2023) · Journal of Building Engineering · doi:10.1016/j.jobe.2022.105654 · Cited by 26 · see citing works
- Authors
- Torregrosa-Jaime, B., Corberán, J. M., Payá, J., & Delamarche, J. L.
- Affiliations
- Universitat Politècnica de València (ES)
- Corresponding author
- Torregrosa-Jaime, B.
- Venue
- Applied Thermal Engineering
- Publisher
- Elsevier BV
- Published
- 2017-03
- Volume
- 115
- Pages
- 774-781
- ISSN
- 1359-4311 (ISSN-L)
- OpenAlex
- W2570094357
- Cited by
- 25
- References
- 1
- Citations by year
- 2026: 2 · 2025: 6 · 2024: 1 · 2023: 3 · 2022: 1 · 2021: 1 · 2020: 2 · 2019: 3 · 2018: 3 · 2017: 3
- FWCI
- 2.34
- Type
- journal article
- Language
- en
- Open access
- bronze
- doi.org
- Locations
- Applied Thermal Engineering (publishedVersion)
- RiuNet (Universitat Politècnica de València) (submittedVersion, cc-by-nc-nd)
- Funders
- European Commission (265434)
- Ministerio de Educación, Cultura y Deporte (AP2010-2160)
- Ministry of Culture and Sport
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer and Optimization
- Physical Sciences › Engineering › Mechanical Engineering › Refrigeration and Air Conditioning Technologies
- Physical Sciences › Engineering › Automotive Engineering › Advanced Battery Technologies Research
- Keywords
- compact heat exchangers, heater core, electric vehicle air conditioning, global heat transfer coefficient, semi-empirical correlation, dehumidification, thermal characterization, battery thermal management, energy consumption reduction
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
