The DOI matches its Crossref record; 12 of the 12 references it cites were found in a registry or an index.
A multi-technique investigation of the nanoporosity of cement paste
Open accessAbstract
The nanometer-scale structure of cement paste, which is dominated by the colloidal-scale porosity within the C-S-H gel phase, has a controlling effect on concrete properties but is difficult to study due to its delicate structure and lack of long-range order. Here we present results from three experimental techniques that are particularly suited to analyzing disordered nanoporous materials: small-angle neutron scattering (SANS), weight and length changes during equilibrium drying, and nanoindentation. Particular attention is paid to differences between pastes of different ages and cured at different temperatures. The SANS and equilibrium drying results indicate that hydration of cement paste at 20 °C forms a low-density (LD) C-S-H gel structure with a range of gel pore sizes and a relatively low packing fraction of solid particles. This fine structure may persist indefinitely under saturated conditions. However, if the paste is dried or is cured at elevated temperatures (60 °C or greater) the structure collapses toward a denser (less porous) and more stable configuration with fewer large gel pores, resulting in a greater amount of capillary porosity. Nanoindentation measurements of pastes cured at different temperatures demonstrate in all cases the existence of two C-S-H structures with different characteristic values of the indentation modulus. The average value of the modulus of the LD C-S-H is the same for all pastes tested to date, and a micromechanical analysis indicates that this value corresponds to the denser and more stable configuration of LD C-S-H. The experimental results presented here are interpreted in terms of a previously proposed quantitative “colloid” model of C-S-H gel, resulting in an improved understanding of the microstructural changes associated with drying and heat curing.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
1 retracted
Analysis of C–S–H gel and cement paste by small-angle neutron scattering
Allen, A. J., & Thomas, J. J. (2006) · Cement and Concrete Research · doi:10.1016/j.cemconres.2006.09.002 · Cited by 140
Self-citationRetractedOliver, W. C., & Pharr, G. M. (2004) · Journal of materials research/Pratt's guide to venture capital sources · doi:10.1557/jmr.2004.0002 · Cited by 8,190
Sneddon, I. N. (1965) · International Journal of Engineering Science · doi:10.1016/0020-7225(65)90019-4 · Cited by 4,346
Constantinides, G., & Ulm, F.-J. (2004) · Cement and Concrete Research · doi:10.1016/s0008-8846(03)00230-8 · Cited by 1,226
Self-citationRichardson, I. G. (2004) · Cement and Concrete Research · doi:10.1016/j.cemconres.2004.05.034 · Cited by 1,082
Scaling, dimensional analysis, and indentation measurements
Cheng, Y.-T., & Cheng, C.-M. (2004) · Materials Science and Engineering: R: Reports · doi:10.1016/j.mser.2004.05.001 · Cited by 1,061
A model for the microstructure of calcium silicate hydrate in cement paste
Jennings, H. M. (2000) · Cement and Concrete Research · doi:10.1016/s0008-8846(99)00209-4 · Cited by 1,006
Self-citationThe structure and stoichiometry of C-S-H
Nonat, A. (2004) · Cement and Concrete Research · doi:10.1016/j.cemconres.2004.04.035 · Cited by 603
On the use of nanoindentation for cementitious materials
Constantinides, G., Ulm, F. J., & Van Vliet, K. (2003) · Materials and Structures · doi:10.1007/bf02479557 · Cited by 367
Self-citationIs concrete a poromechanics material? - A multiscale investigation of poroelastic properties
Ulm, F., Constantinides, G., & Heukamp, F. H. (2003) · Materials and Structures · doi:10.1007/bf02481626 · Cited by 334
Self-citation
Cited by
Mechanisms of cement hydration
Bullard, J. W., Jennings, H. M., Livingston, R. A., Nonat, A., Scherer, G. W., Schweitzer, J. S., Scrivener, K. L., & Thomas, J. J. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2010.09.011 · Cited by 2,237
Self-citationNanotechnology in concrete – A review
Sanchez, F., & Sobolev, K. (2010) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2010.03.014 · Cited by 1,834
Refinements to colloid model of C-S-H in cement: CM-II
Jennings, H. M. (2008) · Cement and Concrete Research · doi:10.1016/j.cemconres.2007.10.006 · Cited by 1,049
Self-citationThe nanogranular nature of C–S–H
Constantinides, G., & Ulm, F.-J. (2007) · Journal of the Mechanics and Physics of Solids · doi:10.1016/j.jmps.2006.06.003 · Cited by 901
Self-citationInfluence of Nucleation Seeding on the Hydration Mechanisms of Tricalcium Silicate and Cement
Thomas, J. J., Jennings, H. M., & Chen, J. J. (2009) · The Journal of Physical Chemistry C · doi:10.1021/jp809811w · Cited by 810
Self-citationSorelli, L., Constantinides, G., Ulm, F.-J., & Toutlemonde, F. (2008) · Cement and Concrete Research · doi:10.1016/j.cemconres.2008.09.002 · Cited by 636
Self-citationEffect of temperature on the microstructure of calcium silicate hydrate (C-S-H)
Gallucci, E., Zhang, X., & Scrivener, K. L. (2013) · Cement and Concrete Research · doi:10.1016/j.cemconres.2013.06.008 · Cited by 624
Nanogranular packing of C–S–H at substochiometric conditions
Vandamme, M., Ulm, F.-J., & Fonollosa, P. (2010) · Cement and Concrete Research · doi:10.1016/j.cemconres.2009.09.017 · Cited by 409
Self-citationChen, J. J., Sorelli, L., Vandamme, M., Ulm, F., & Chanvillard, G. (2010) · Journal of the American Ceramic Society · doi:10.1111/j.1551-2916.2009.03599.x · Cited by 369
Self-citationA New Approach to Modeling the Nucleation and Growth Kinetics of Tricalcium Silicate Hydration
Thomas, J. J. (2007) · Journal of the American Ceramic Society · doi:10.1111/j.1551-2916.2007.01858.x · Cited by 348
Self-citationTowards ternary binders involving limestone additions — A review
Dhandapani, Y., Santhanam, M., Kaladharan, G., & Ramanathan, S. (2021) · Cement and Concrete Research · doi:10.1016/j.cemconres.2021.106396 · Cited by 335
Multiscale micromechanical analysis of alkali-activated fly ash-slag paste
Fang, G., & Zhang, M. (2020) · Cement and Concrete Research · doi:10.1016/j.cemconres.2020.106141 · Cited by 292
Elastic properties of the main species present in Portland cement pastes
Manzano, H., Dolado, J. S., & Ayuela, A. (2009) · Acta Materialia · doi:10.1016/j.actamat.2008.12.007 · Cited by 277
Quantitative analysis of C–S–H in hydrating alite pastes by in-situ XRD
Bergold, S. T., Goetz-Neunhoeffer, F., & Neubauer, J. (2013) · Cement and Concrete Research · doi:10.1016/j.cemconres.2013.06.001 · Cited by 264
Pichler, C., Saxer, A., & Lackner, R. (2012) · Cement and Concrete Research · doi:10.1016/j.cemconres.2012.02.007 · Cited by 35
A method for calculating the carbonation degree of calcium–silicate–hydrate
Shen, Q., Pan, G., & Bao, B. (2018) · Advances in Cement Research · doi:10.1680/jadcr.16.00086 · Cited by 15
Metadata
- Authors
- Jennings, H. M., Thomas, J. J., Gevrenov, J. S., Constantinides, G., & Ulm, F.-J.
- Venue
- Cement and Concrete Research
- Publisher
- Elsevier BV
- Published
- 2007-03
- Volume
- 37
- Issue
- 3
- Pages
- 329-336
- ISSN
- 0008-8846 (ISSN-L)
- OpenAlex
- W2132834955
- Cited by
- 447
- References
- 12
- FWCI
- 59.42
- Type
- journal article
- Language
- en
- Status
- Retracted
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.