The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.
Properties and microstructure of alkali-activated red clay brick waste
Open accessAbstract
Abstract Sintered red clay ceramic is used to produce hollow bricks which are manufactured in enormous quantities in Spain. They also constitute a major fraction of construction and demolition waste. The aim of this research was to investigate the properties and microstructure of alkali-activated cement pastes and mortars produced using red clay brick waste. The work shows that the type and concentration of alkali activator can be optimised to produce mortar samples with compressive strengths up to 50 MPa after curing for 7 days at 65 °C. This demonstrates a new potential added value reuse application for this important waste material.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Geopolymer technology: The current state of the art
Duxson, P., Fernández-Jiménez, A., Provis, J. L., Lukey, G. C., Palomo, A., & van Deventer, J. S. J. (2007) · Journal of Materials Science · doi:10.1007/s10853-006-0637-z · Cited by 4,742
Palomo, A., Grutzeck, M. W., & Blanco, M. T. (1999) · Cement and Concrete Research · doi:10.1016/s0008-8846(98)00243-9 · Cited by 2,319
Alkali-activated binders: A review
Pacheco-Torgal, F., Castro-Gomes, J., & Jalali, S. (2008) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2007.10.015 · Cited by 989
Geopolymerisation: A review and prospects for the minerals industry
Komnitsas, K., & Zaharaki, D. (2007) · Minerals Engineering · doi:10.1016/j.mineng.2007.07.011 · Cited by 955
Alkali activation of fly ash: Effect of the SiO2/Na2O ratio
Criado, M., Fernández-Jiménez, A., & Palomo, A. (2007) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2007.02.055 · Cited by 705
Reusing ceramic wastes in concrete
Pacheco-Torgal, F., & Jalali, S. (2010) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2009.10.023 · Cited by 519
Alkali-activated binders: A review. Part 2. About materials and binders manufacture
Pacheco-Torgal, F., Castro-Gomes, J., & Jalali, S. (2008) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2007.03.019 · Cited by 519
Mercury porosimetry of hardened cement pastes
Cook, R. A., & Hover, K. C. (1999) · Cement and Concrete Research · doi:10.1016/s0008-8846(99)00083-6 · Cited by 506
Bernal, S. A., de Gutierrez, R. M., Provis, J. L., & Rose, V. (2010) · Cement and Concrete Research · doi:10.1016/j.cemconres.2010.02.003 · Cited by 473
Bernal, S. A., Mejía de Gutiérrez, R., & Provis, J. L. (2012) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2012.01.017 · Cited by 455
Mineralogical and microstructural characterisation of alkali-activated fly ash/slag pastes
Puertas, F., & Fernández-Jiménez, A. (2003) · Cement and Concrete Composites · doi:10.1016/s0958-9465(02)00059-8 · Cited by 452
Geopolymerization process of alkali–metakaolinite characterized by isothermal calorimetry
Yao, X., Zhang, Z., Zhu, H., & Chen, Y. (2009) · Thermochimica Acta · doi:10.1016/j.tca.2009.04.002 · Cited by 439
Attenuated Total Reflectance Fourier Transform Infrared Analysis of Fly Ash Geopolymer Gel Aging
Rees, C. A., Provis, J. L., Lukey, G. C., & van Deventer, J. S. J. (2007) · Langmuir · doi:10.1021/la700713g · Cited by 434
In Situ ATR-FTIR Study of the Early Stages of Fly Ash Geopolymer Gel Formation
Rees, C. A., Provis, J. L., Lukey, G. C., & van Deventer, J. S. J. (2007) · Langmuir · doi:10.1021/la701185g · Cited by 411
Synthesis and heavy metal immobilization behaviors of slag based geopolymer
Yunsheng, Z., Wei, S., Qianli, C., & Lin, C. (2007) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2006.09.033 · Cited by 398
Effect of Curing Temperature and Silicate Concentration on Fly-Ash-Based Geopolymerization
Sindhunata, van Deventer, J. S. J., Lukey, G. C., & Xu, H. (2006) · Industrial & Engineering Chemistry Research · doi:10.1021/ie051251p · Cited by 390
Concrete with ceramic waste aggregate
Senthamarai, R., & Manoharan, P. D. (2005) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2005.04.003 · Cited by 365
FERNANDEZJIMENEZ, A., DELATORRE, A., PALOMO, A., LOPEZOLMO, G., ALONSO, M., & ARANDA, M. (2006) · Fuel · doi:10.1016/j.fuel.2005.08.014 · Cited by 262
Ceramic wastes as alternative raw materials for Portland cement clinker production
Puertas, F., García-Díaz, I., Barba, A., Gazulla, M. F., Palacios, M., Gómez, M. P., & Martínez-Ramírez, S. (2008) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2008.06.003 · Cited by 242
Geopolymerisation of low calcium ferronickel slags
Komnitsas, K., Zaharaki, D., & Perdikatsis, V. (2006) · Journal of Materials Science · doi:10.1007/s10853-006-0529-2 · Cited by 232
An alternative method to measure carbonate in soils by FT-IR spectroscopy
Tatzber, M., Stemmer, M., Spiegel, H., Katzlberger, C., Haberhauer, G., & Gerzabek, M. H. (2006) · Environmental Chemistry Letters · doi:10.1007/s10311-006-0079-5 · Cited by 205
Microscopy and microanalysis of inorganic polymer cements. 2: the gel binder
Lloyd, R. R., Provis, J. L., & van Deventer, J. S. J. (2009) · Journal of Materials Science · doi:10.1007/s10853-008-3078-z · Cited by 175
Lloyd, R. R., Provis, J. L., Smeaton, K. J., & van Deventer, J. S. J. (2009) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2009.05.016 · Cited by 158
Hajimohammadi, A., Provis, J. L., & van Deventer, J. S. J. (2011) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2011.02.045 · Cited by 130
Cementitious binder from fly ash and other industrial wastes
Singh, M., & Garg, M. (1999) · Cement and Concrete Research · doi:10.1016/s0008-8846(98)00210-5 · Cited by 126
Image-based characterization of cement pore structure using wood’s metal intrusion
Willis, K. L., Abell, A. B., & Lange, D. A. (1998) · Cement and Concrete Research · doi:10.1016/s0008-8846(98)00159-8 · Cited by 113
Dilatometry of geopolymers as a means of selecting desirable fly ash sources
Provis, J. L., Harrex, R. M., Bernal, S. A., Duxson, P., & van Deventer, J. S. J. (2012) · Journal of Non-Crystalline Solids · doi:10.1016/j.jnoncrysol.2012.06.001 · Cited by 79
Puertas, F., García-Díaz, I., Palacios, M., Gazulla, M. F., Gómez, M. P., & Orduña, M. (2009) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2009.11.011 · Cited by 75
Kourti, I., Rani, D. A., Deegan, D. E., Boccaccini, A. R., & Cheeseman, C. R. (2009) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2009.11.089 · Cited by 66
Self-citationCharacterization of natural chabazite and 5A synthetic zeolites
Stakebake, J. L. (1984) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(84)90083-3 · Cited by 19
Cited by
Tang, Q., Ma, Z., Wu, H., & Wang, W. (2020) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2020.103807 · Cited by 549
Potential use of brick waste as alternate concrete-making materials: A review
Wong, C. L., Mo, K. H., Yap, S. P., Alengaram, U. J., & Ling, T.-C. (2018) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2018.05.193 · Cited by 263
Metadata
- Authors
- Reig, L., Tashima, M. M., Borrachero, M. V., Monzó, J., Cheeseman, C. R., & Payá, J.
- Venue
- Construction and Building Materials
- Publisher
- Elsevier BV
- Published
- 2013-06
- Volume
- 43
- Pages
- 98-106
- ISSN
- 0950-0618 (ISSN-L)
- OpenAlex
- W2030325056
- Cited by
- 366
- References
- 30
- FWCI
- 21.04
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.