The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.
Guidelines for mix proportioning of fly ash/GGBS based alkali activated concretes
Open accessAbstract
The effects of paste volume, water content and precursor blend on consistency, setting time and compressive strength of alkali activated concrete (AAC) produced with fly ash (FA) and ground granulated blast furnace slag (GGBS) have been investigated with the aim of developing a suitable mix design procedure. Paste volumes in the range 30–33% were found not to influence the compressive strength but did influence the consistency of the mixes. The water-to-solid ratio was found to influence compressive strength and setting time. Increasing GGBS content in the binder blend resulted in an increase of the compressive strength, but higher GGBS content caused also early setting which may be undesirable. A mix design procedure has been developed and has been used to determine the constituent mix proportions for three classes of concretes, i.e. (a) a ready-mix concrete with nominal strength 35 MPa, (b) a typical structural concrete with nominal strength 50 MPa, and (c) a high strength concrete for precast applications with nominal strength 70 MPa. Cost analysis was carried out to compare the AAC with Portland cement concretes with similar properties. Normal strength Portland cement concrete (PC), as typically used in ready mix industry has been shown to be less expensive than AAC. However, alkali activated concrete can be competitively priced for high strength concretes. An empirical step-by-step procedure is presented for selecting trial mix proportions for concretes with a range of consistency values, setting times and cube compressive strengths.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The role of inorganic polymer technology in the development of ‘green concrete’
Duxson, P., Provis, J. L., Lukey, G. C., & van Deventer, J. S. J. (2007) · Cement and Concrete Research · doi:10.1016/j.cemconres.2007.08.018 · Cited by 1,998
Nath, P., & Sarker, P. K. (2014) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2014.05.080 · Cited by 1,557
Advances in understanding alkali-activated materials
Provis, J. L., Palomo, A., & Shi, C. (2015) · Cement and Concrete Research · doi:10.1016/j.cemconres.2015.04.013 · Cited by 1,537
Deb, P. S., Nath, P., & Sarker, P. K. (2014) · Materials & Design (1980-2015) · doi:10.1016/j.matdes.2014.05.001 · Cited by 941
Alkali Activated Materials: State-of-the-Art Report, RILEM TC 224-AAM
(2014) · RILEM State-of-the-Art Reports · doi:10.1007/978-94-007-7672-2 · Cited by 906
DEVELOPMENT AND PROPERTIES OF LOW-CALCIUM FLY ASH-BASED GEOPOLYMER CONCRETE
Hardjito, D., & Rangan, B. V. (2005) · eSpace (Curtin University) · Cited by 822
Lee, N. K., & Lee, H. K. (2013) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2013.05.107 · Cited by 754
Handbook of Alkali-Activated Cements, Mortars and Concretes
(2015) · Elsevier eBooks · doi:10.1016/c2013-0-16511-7 · Cited by 688
Effect of binder content on the performance of alkali-activated slag concretes
Bernal, S. A., Mejía de Gutiérrez, R., Pedraza, A. L., Provis, J. L., Rodriguez, E. D., & Delvasto, S. (2011) · Cement and Concrete Research · doi:10.1016/j.cemconres.2010.08.017 · Cited by 537
Engineering properties of inorganic polymer concretes (IPCs)
Sofi, M., van Deventer, J. S. J., Mendis, P. A., & Lukey, G. C. (2007) · Cement and Concrete Research · doi:10.1016/j.cemconres.2006.10.008 · Cited by 522
Puertas, F., & Torres-Carrasco, M. (2014) · Cement and Concrete Research · doi:10.1016/j.cemconres.2013.12.005 · Cited by 420
Influence of aggregate content on the behavior of fly ash based geopolymer concrete
Joseph, B., & Mathew, G. (2012) · Scientia Iranica · doi:10.1016/j.scient.2012.07.006 · Cited by 374
Low-Calcium fly ash-based geopolymer concrete: Long-term properties
Wallah, S. E., & Rangan, B. V. (2006) · eSpace (Curtin University) · Cited by 364
Factors influencing the compressive strength of fly ash based geopolymers
Soutsos, M. N., Boyle, A. P., Vinai, R., Hadjierakleous, A., & Barnett, S. J. (2016) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2015.11.045 · Cited by 326
Self-citationCompressive strength, modulus of elasticity, and water permeability of inorganic polymer concrete
Wongpa, J., Kiattikomol, K., Jaturapitakkul, C., & Chindaprasirt, P. (2010) · Materials & Design · doi:10.1016/j.matdes.2010.05.012 · Cited by 310
A mix design procedure for low calcium alkali activated fly ash-based concretes
Talha Junaid, M., Kayali, O., Khennane, A., & Black, J. (2015) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2015.01.048 · Cited by 219
Some factors affecting early hydration of alkali-slag cements
Shi, C., & Day, R. L. (1996) · Cement and Concrete Research · doi:10.1016/s0008-8846(96)85031-9 · Cited by 187
FACTORS INFLUENCING THE COMPRESSIVE STRENGTH OF FLY ASH-BASED GEOPOLYMER CONCRETE
Hardjito, D., Wallah, S. E., Sumajouw, D. M. J., et al. (2004) · DOAJ (DOAJ: Directory of Open Access Journals) · Cited by 185
Yost, J. R., Radlińska, A., Ernst, S., & Salera, M. (2012) · Materials and Structures · doi:10.1617/s11527-012-9919-x · Cited by 80
Strength and water penetrability of fly ash geopolymer concrete
Olivia, M., & Nikraz, H. (2011) · eSpace (Curtin University) · Cited by 72
Provis, J. L. (2013) · RILEM state-of-the-art reports · doi:10.1007/978-94-007-7672-2_1 · Cited by 66
Sayyad, A. S., & Patankar, S. V. (2013) · Indian Journal of Materials Science · doi:10.1155/2013/357563 · Cited by 51
Analysing the relation between pore structure and permeability of alkali-activated concrete binders
Zhang, Z., & Wang, H. (2015) · Elsevier eBooks · doi:10.1533/9781782422884.2.235 · Cited by 39
Hung, C., & Chang, J. (2013) · Journal of Marine Science and Technology · doi:10.6119/jmst-012-0109-4 · Cited by 24
Cited by
Recent progress in low-carbon binders
Shi, C., Qu, B., & Provis, J. L. (2019) · Cement and Concrete Research · doi:10.1016/j.cemconres.2019.05.009 · Cited by 714
Xie, J., Wang, J., Rao, R., Wang, C., & Fang, C. (2019) · Composites Part B: Engineering · doi:10.1016/j.compositesb.2018.11.067 · Cited by 581
Fang, G., Ho, W. K., Tu, W., & Zhang, M. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2018.04.008 · Cited by 528
A review: Reaction mechanism and strength of slag and fly ash-based alkali-activated materials
Sun, B., Ye, G., & de Schutter, G. (2022) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2022.126843 · Cited by 386
A review on mixture design methods for geopolymer concrete
Li, N., Shi, C., Zhang, Z., Wang, H., & Liu, Y. (2019) · Composites Part B: Engineering · doi:10.1016/j.compositesb.2019.107490 · Cited by 351
Metadata
- Authors
- Rafeet, A., Vinai, R., Soutsos, M., & Sha, W.
- Venue
- Construction and Building Materials
- Publisher
- Elsevier BV
- Published
- 2017-08
- Volume
- 147
- Pages
- 130-142
- ISSN
- 0950-0618 (ISSN-L)
- OpenAlex
- W2609530344
- Cited by
- 258
- References
- 24
- FWCI
- 11.99
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.