The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
Preparation and characterization of coal gangue geopolymers
Abstract
This paper explores the impacts of sodium hydroxide modulus, alkali lye amount and liquid–solid ratio on the strength and microstructure of coal gangue geopolymer materials, involving a total of five sodium hydroxide moduli, four NH/NS mass ratios and seven liquid–solid ratios. To characterize the morphology and structure of coal gangue geopolymer materials, we carried out XRD, TG-DTG, FT-IR and SEM analysis on the specimens respectively. The results show that NH concentration has no impact on paste fluidity and has significant impact on compressive strength of geopolymers. Both paste fluidity and compressive strength of geopolymers increase with the increase in liquid–solid ratio. However, it should be noted that the compressive strength decreases with the increase in liquid–solid ratio when the liquid–solid ratio is greater than 0.32. The optimal NH/NS mass ratio is 1:1.5 ∼ 1:2. In comparison with P.O42.5 cement specimens, coal gangue geopolymers have higher initial strength and lower 28 d compressive strength. The analytical results of microstructure are consistent with those of compressive strength, which demonstrates that the polymerization products of coal gangue geopolymers are N-A-S-H gels and some other aluminosilicate zeolite crystals.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Geopolymers: Inorganic polymeric new materials
Davidovits, J. (1991) · Journal of Thermal Analysis · doi:10.1007/bf01912193 · Cited by 4,251
Duxson, P., Provis, J. L., Lukey, G. C., Mallicoat, S. W., Kriven, W. M., & van Deventer, J. S. J. (2005) · Colloids and Surfaces A: Physicochemical and Engineering Aspects · doi:10.1016/j.colsurfa.2005.06.060 · Cited by 1,807
Structure of Calcium Silicate Hydrate (C‐S‐H): Near‐, Mid‐, and Far‐Infrared Spectroscopy
Yu, P., Kirkpatrick, R. J., Poe, B., McMillan, P. F., & Cong, X. (1999) · Journal of the American Ceramic Society · doi:10.1111/j.1151-2916.1999.tb01826.x · Cited by 1,640
Ismail, I., Bernal, S. A., Provis, J. L., San Nicolas, R., Hamdan, S., & van Deventer, J. S. J. (2014) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2013.09.006 · Cited by 1,317
Geopolymers and geopolymeric materials
Davidovits, J. (1989) · Journal of Thermal Analysis · doi:10.1007/bf01904446 · Cited by 1,148
Synthesis and characterization of red mud and rice husk ash-based geopolymer composites
He, J., Jie, Y., Zhang, J., Yu, Y., & Zhang, G. (2013) · Cement and Concrete Composites · doi:10.1016/j.cemconcomp.2012.11.010 · Cited by 770
Mid-infrared spectroscopic studies of alkali-activated fly ash structure
Fernández-Jiménez, A., & Palomo, A. (2005) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2005.05.057 · Cited by 625
Role of water in the synthesis of calcined kaolin-based geopolymer
ZUHUA, Z., XIAO, Y., HUAJUN, Z., & YUE, C. (2009) · Applied Clay Science · doi:10.1016/j.clay.2008.09.003 · Cited by 621
The effects of inorganic salt contamination on the strength and durability of geopolymers
Lee, W. K. W., & van Deventer, J. S. J. (2002) · Colloids and Surfaces A: Physicochemical and Engineering Aspects · doi:10.1016/s0927-7757(02)00239-x · Cited by 479
Durability of alkali-activated materials in aggressive environments: A review on recent studies
Zhang, J., Shi, C., Zhang, Z., & Ou, Z. (2017) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2017.07.027 · Cited by 374
AL-MASHHADANI, M. M. M., Canpolat, O., Aygörmez, Y., Uysal, M., & Erdem, S. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2018.02.061 · Cited by 307
Phair, J. W., & Van Deventer, J. S. J. (2002) · International Journal of Mineral Processing · doi:10.1016/s0301-7516(02)00013-3 · Cited by 295
Improving strength of calcinated coal gangue geopolymer mortars via increasing calcium content
Huang, G., Ji, Y., Li, J., Hou, Z., & Dong, Z. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2018.02.005 · Cited by 247
Mechanical and thermal properties of fly ash based geopolymers
Fan, F., Liu, Z., Xu, G., Peng, H., & Cai, C. S. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2017.11.023 · Cited by 224
Mix design factors and strength prediction of metakaolin-based geopolymer
Lahoti, M., Narang, P., Tan, K. H., & Yang, E.-H. (2017) · Ceramics International · doi:10.1016/j.ceramint.2017.06.006 · Cited by 220
Carbonation resistance of fly ash and blast furnace slag based geopolymer concrete
Li, Z., & Li, S. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2017.12.127 · Cited by 202
Performance of fibre reinforced, low density metakaolin geopolymers under simulated fire conditions
Rickard, W. D. A., Vickers, L., & van Riessen, A. (2013) · Applied Clay Science · doi:10.1016/j.clay.2012.10.006 · Cited by 201
Optimization of solids-to-liquid and alkali activator ratios of calcined kaolin geopolymeric powder
Yun-Ming, L., Kamarudin, H., Abdullah, M. M. A. B., Bnhussain, M., Musa, L., Nizar, I. K., Ruzaidi, C. M., & Cheng-Yong, H. (2012) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2012.07.075 · Cited by 158
Feasibility Study of Loess Stabilization with Fly Ash–Based Geopolymer
Liu, Z., Cai, C. S. S., Liu, F., & Fan, F. (2016) · Journal of Materials in Civil Engineering · doi:10.1061/(asce)mt.1943-5533.0001490 · Cited by 146
Improvement on pozzolanic reactivity of coal gangue by integrated thermal and chemical activation
Li, Y., Yao, Y., Liu, X., Sun, H., & Ni, W. (2013) · Fuel · doi:10.1016/j.fuel.2013.03.010 · Cited by 145
Heikal, M., Nassar, M. Y., El-Sayed, G. O., & Ibrahim, S. M. (2014) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2014.07.026 · Cited by 135
Performance of Fly ash Based Geopolymer Mortars in Sulphate Solution
Thokchom, S., Ghosh, P., & Ghosh, S. (2010) · Journal of Engineering Science and Technology Review · doi:10.25103/jestr.031.07 · Cited by 126
Geopolymer concrete for environmental protection
Rangan, B. V. (2014) · eSpace (Curtin University) · Cited by 120
Study on chloride binding capability of coal gangue based cementitious materials
Cheng, Y., Ma, H., Zhu, H., Li, W., Xin, M., Liu, Y., & Guo, Y. (2018) · Construction and Building Materials · doi:10.1016/j.conbuildmat.2018.02.071 · Cited by 106
Self-citationExcitation Effect of Soluble Glass on Composite System with Calcined Coal Gangue and Slag
Han, J. Y., Song, X. Y., & Gao, Z. H. (2012) · Applied Mechanics and Materials · doi:10.4028/www.scientific.net/amm.174-177.30 · Cited by 22
Huynh, T., Hwang, C., & Lin, K. (2016) · Environmental Progress & Sustainable Energy · doi:10.1002/ep.12445 · Cited by 15
Hardening mechanisms of alkali activated burned gangue cementitious material
Li-mei, F. (2004) · Materials Science and Technology · Cited by 10
Early Hydration of the Material of Alkali-activated Coal Gangue
Wang, P. (2008) · Cailiao kexue yu gongcheng xuebao · Cited by 6
Cited by
Preparation and Reaction Mechanism Characterization of Alkali-activated Coal Gangue–Slag Materials
Ma, H., Zhu, H., Yi, C., Fan, J., Chen, H., Xu, X., & Wang, T. (2019) · Materials · doi:10.3390/ma12142250 · Cited by 91
Self-citationSekhohola-Dlamini, L. M., Keshinro, O. M., Masudi, W. L., & Cowan, A. K. (2022) · Minerals · doi:10.3390/min12020111 · Cited by 29
Metadata
- Authors
- Cheng, Y., Hongqiang, M., Hongyu, C., Jiaxin, W., Jing, S., Zonghui, L., & Mingkai, Y.
- Venue
- Construction and Building Materials
- Publisher
- Elsevier BV
- Published
- 2018-10
- Volume
- 187
- Pages
- 318-326
- ISSN
- 0950-0618 (ISSN-L)
- OpenAlex
- W2885928981
- Cited by
- 259
- References
- 28
- FWCI
- 13.02
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.