CoChat
Sign Up
Cited by 68High-Temperature Coating BehaviorsIntermetallics and Advanced Alloy PropertiesHigh Temperature Alloys and Creep

The DOI matches its Crossref record.

Preparation and hot corrosion behaviour of two Co modified NiAl coatings on a Ni-based superalloy

Fan, Q.X., Jiang, S.M., Wu, D.L., Gong, J., Sun, C.·2013·Corrosion Science
DOI 10.1016/j.corsci.2013.07.008
Open this paper in CoChat — free account

Overview

Integrity signals

Registry

Crossref · 10.1016/j.corsci.2013.07.008

Cites

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

We couldn’t retrieve this paper’s full text, so its claims and self-check weren’t run. The registry and citation checks still apply.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

  • The presence of Co accelerates the degradation of NiAl coatings in fused chloride salts.

    “However, the presence of Co accelerates the degradation of NiAl coatings in fused chloride salts [36].”

    From A review on molten sulfate salts induced hot corrosion (2021) · cites this paper as [36]

  • The addition of cobalt in NiAl coatings promotes the formation of protective Al2O3 scale, enhancing its corrosion resistance in molten sulfate salts.

    “Both Fan at al. and Qiao et al. found that the addition of cobalt in NiAl coatings promotes the formation of protective Al2O3 scale, enhancing its corrosion resistance in molten sulfate salts [36, 130].”

    From A review on molten sulfate salts induced hot corrosion (2021) · cites this paper as [36]

Citations

Cites

No references could be resolved yet.

Research works printed but not linked: 29

  1. Basuki, 1997, Interdiffusion behaviour in aluminide-coated René 80H at 1150°C, Mater. Sci. Eng. A, 224, 27, 10.1016/S0921-5093(96)10556-6 · DOI
  2. Du, 1996, The high temperature corrosion behaviour of Hf modified chromo-aluminised coatings produced by a single step process, Surf. Coat. Technol., 86–87, 1, 10.1016/S0257-8972(96)03027-7 · DOI
  3. Liu, 2001, High-temperature oxidation behavior of aluminide coatings on a new cobalt-base superalloy in air, Corros. Sci., 43, 1217, 10.1016/S0010-938X(00)00137-2 · DOI
  4. Ma, 2011, Microstructure and oxidation behaviour of an AlSiY/NiCrAlYSi composite coating at 1150°C, Corros. Sci., 53, 1417, 10.1016/j.corsci.2011.01.004 · DOI
  5. Smialek, 1987, Adherent Al2O3 scales formed on undoped nicrai alloys, Metall. Mater. Trans. A, 18, 164, 10.1007/BF02646237 · DOI
  6. Task, 2011, Compositional effects on the type I hot corrosion of β-NiAl alloys, Surf. Coat. Technol., 206, 1552, 10.1016/j.surfcoat.2011.06.025 · DOI
  7. Lu, 2011, Cyclic oxidation and hot corrosion behavior of Y/Cr-modified aluminide coatings prepared by a hybrid slurry/pack cementation process, Oxid. Met., 76, 67, 10.1007/s11085-010-9228-0 · DOI
  8. Firouzi, 2010, The structure and high temperature corrosion performance of medium-thickness aluminide coatings on nickel-based superalloy GTD-111, Corros. Sci., 52, 3579, 10.1016/j.corsci.2010.06.026 · DOI
  9. Wang, 2004, Hot corrosion behavior of AIP NiCoCrAlY (SiB) coatings on nickel base superalloys, Surf. Coat. Technol., 186, 389, 10.1016/j.surfcoat.2003.12.020 · DOI
  10. Qiao, 2012, Hot corrosion behavior of Co modified NiAl coating on nickel base superalloys, Corros. Sci., 63, 239, 10.1016/j.corsci.2012.06.027 · DOI · Paper page
  11. Costa, 1997, Co-deposited chromium-aluminide coatings. III. Origins of non-equilibrium effects, Surf. Coat. Technol., 88, 165, 10.1016/S0257-8972(96)02921-0 · DOI
  12. Shinagawa, 2008, Phase equilibria and microstructure on γ′ phase in Co–Ni–Al–W system, Mater. Trans., 49, 1474, 10.2320/matertrans.MER2008073 · DOI
  13. Jia, 1994, Partition of alloying elements between γ (A1), γ′ (L1 2), and β (B2) phases in Ni–Al base systems, Metall. Mater. Trans. A, 25, 473, 10.1007/BF02651589 · DOI
  14. Wang, 2008, Synthesis of simple and platinum-modified aluminide coatings on cobalt (Co)-base superalloys via a vapor phase aluminizing process, Surf. Coat. Technol., 203, 256, 10.1016/j.surfcoat.2008.08.072 · DOI
  15. Nijdam, 2005, Promoting exclusive α-Al2O3 growth upon high-temperature oxidation of NiCrAl alloys: experiment versus model predictions, Acta Mater., 53, 1643, 10.1016/j.actamat.2004.12.014 · DOI
  16. Voudouris, 2001, Formation of aluminide coatings on nickel by a fluidised bed CVD process, Surf. Coat. Technol., 141, 275, 10.1016/S0257-8972(01)01193-8 · DOI
  17. John, 2004, A kinetic model for iron aluminide coatings by low-pressure chemical vapor deposition: Part I. Deposition kinetics, Thin Solid Films, 466, 339, 10.1016/j.tsf.2004.02.042 · DOI
  18. Qiao, 2012, Codeposition of Co and Al on nickel base superalloys by pack cementation process, Surf. Coat. Technol., 206, 2899, 10.1016/j.surfcoat.2011.12.019 · DOI
  19. Bao, 2009, Preparation and hot corrosion behaviour of an Al-gradient NiCoCrAlYSiB coating on a Ni-base superalloy, Corros. Sci., 51, 860, 10.1016/j.corsci.2009.01.003 · DOI
  20. Xiang, 2003, Codeposition of Al and Si on nickel base superalloys by pack cementation process, Mater. Sci. Eng. A, 356, 136, 10.1016/S0921-5093(03)00107-2 · DOI
  21. Eliaz, 2002, Hot corrosion in gas turbine components, Eng. Fail. Anal., 9, 31, 10.1016/S1350-6307(00)00035-2 · DOI
  22. Wagner, 1952, Theoretical analysis of the diffusion processes determining the oxidation rate of alloys, J. Electrochem. Soc., 99, 369, 10.1149/1.2779605 · DOI
  23. Carter, 1996, Calculation of precipitate dissolution zone kinetics in oxidising binary two-phase alloys, Acta Mater., 44, 4033, 10.1016/S1359-6454(96)00054-7 · DOI
  24. Ellis, 1993, Hot corrosion of the B2 nickel aluminides, NASA-CR-191082
  25. Gleeson, 1992, The hot-corrosion behavior of novel Co-deposited chromium-modified aluminide coatings, Oxid. Met., 38, 407, 10.1007/BF00665662 · DOI
  26. Goward, 1986, Protective coatings – purpose, role, and design, Mater. Sci. Eng., 2, 194
  27. Zhang, 2011, Hot corrosion behaviour of a cobalt-base super-alloy K40S with and without NiCrAlYSi coating, Corros. Sci., 53, 1990, 10.1016/j.corsci.2011.02.022 · DOI
  28. McKee, 1978, The Effect of SO2 and NaCl on high temperature hot corrosion, J. Electrochem. Soc., 125, 411, 10.1149/1.2131463 · DOI · Paper page
  29. Jiang, 2010, High temperature corrosion behaviour of a gradient NiCoCrAlYSi coating II: oxidation and hot corrosion, Corros. Sci., 52, 2316, 10.1016/j.corsci.2010.03.032 · DOI · Paper page

Cited by

Sorted by citations

Metadata

Authors
Fan, Q. X., Jiang, S. M., Wu, D. L., Gong, J., & Sun, C.
Affiliations
Chinese Academy of Sciences (CN)
Corresponding author
Sun, C.
ORCID
Venue
Corrosion Science
Publisher
Elsevier BV
Published
2013-11
Volume
76
Pages
373-381
ISSN
0010-938X (ISSN-L)
DOI
10.1016/j.corsci.2013.07.008
OpenAlex
W2074358764
Cited by
68
References
0
Citations by year
2026: 6 · 2025: 6 · 2024: 10 · 2023: 3 · 2022: 6 · 2021: 6 · 2020: 2 · 2019: 3 · 2018: 7 · 2017: 4 · 2016: 3 · 2015: 6 · 2014: 6
FWCI
8.04
Type
journal article
Language
en
Open access
closed
Licence
www.elsevier.com/tdm/userlicense/1.0/ (tdm)
Locations
Corrosion Science (publishedVersion)
Topics
  • Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
  • Physical Sciences › Engineering › Mechanical Engineering › Intermetallics and Advanced Alloy Properties
  • Physical Sciences › Engineering › Mechanical Engineering › High Temperature Alloys and Creep
Keywords
NiAl coatings, hot corrosion, nickel-based superalloy, cobalt addition, pack cementation, chemical vapor deposition, coating degradation, corrosion mechanism, coating formation mechanism

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review