CoChat

Recycled plastic as bitumen modifier: The role of recycled linear low-density polyethylene in the modification of physical, chemical and rheological properties of bitumen

Nizamuddin, Sabzoi, Jamal, Muhammad, Gravina, Rebecca, Giustozzi, Filippo · 2020 · Journal of Cleaner Production
Cited by 163

The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.

Abstract

The integration of various polymers in bitumen is common practice to reduce its thermal susceptibility. Nowadays, recycled materials are re-purposed in roads to improve the overall pavement performance and durability. Specifically, the use of soft plastics has been increasingly looked after by local governments and road authorities to possibly limit landfill, hence helping with the waste management issues experienced by many countries. This study evaluates the use of a very common and largely available soft plastic - recycled linear low-density polyethylene (R-LLDPE) - for modification of bitumen. To assess its applicability in the road sector, the base bitumen and R-LLDPE modified bitumen blends were compared through physical, chemical, rheological and thermal evaluation. It was observed that due the addition of high concentrations of R-LLDPE the viscosity and softening point were increased from 0.62 Pa s and 44.1 °C up to 5.75 Pa s and 122.3 °C, respectively, whereas the penetration value decreased from 59.3 to 14.3 (0.1 mm). A progressive increase in viscosity with increasing concentration of R-LLDPE indicates substantial reduction in workability due to the greater polymer-dominant phase. An increase in the intensities of peaks and the absence of new peaks during Fourier transform infra-red (FTIR) analysis confirms the successful blending of the recycled polymer into the bitumen matrix. The thermogravimetric analysis (TGA) shows that the modified bitumen had less evaporation and higher thermal stability than base bitumen. The rheological evaluation highlighted how the R-LLDPE addition significantly affected the thermo-susceptibility of the bitumen and improved the resistance to permanent deformation at high temperature and elastic recovery. Based on the overall findings of this study, it can be stated that R-LLDPE – if dosed correctly and sourced from homogeneous sources – can enhance the overall bitumen performance without significant drawbacks. In particular, 3% R-LLDPE is considered a suitable modification for most environmental conditions, whereas 6% R-LLDPE is only ideal for tropical climates. Higher dosage is not recommended.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1016/j.jclepro.2020.121988

Cites

1 of 1 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 163

Metadata

Authors
Nizamuddin, S., Jamal, M., Gravina, R., & Giustozzi, F.
Venue
Journal of Cleaner Production
Publisher
Elsevier BV
Published
2020-09
Volume
266
Pages
121988
ISSN
0959-6526 (ISSN-L)
OpenAlex
W3023025064
Cited by
163
References
1
FWCI
12.67
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.