The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Phosphate removal from aqueous solutions using raw and activated red mud and fly ash
Open accessAbstract
The effect of acidification and heat treatment of raw red mud (RM) and fly ash (FA) on the sorption of phosphate was studied in parallel experiments. The result shows that a higher efficiency of phosphate removal was acquired by the activated samples than by the raw ones. The sample prepared by using the RM stirred with 0.25 M HCl for 2h (RM0.25), as well as another sample prepared by heating the RM at 700 degrees C for 2h (RM700), registered the maximum removal of phosphate (99% removal of phosphate). This occurred when they were used in the phosphate sorption studies conducted at pH 7.0 and 25 degrees C with the initial PO(4)(3-) concentration of 155 mg P/l. The FA samples treated in the same way described above can achieve 7.0 and 8.2 mg P/l phosphate removal for FA0.25 and FA700 respectively, corresponding to 45.2% and 52.9% removal. The activated materials performed higher phosphate removal over broader pH range compared with the raw ones. The influences of various factors, such as initial pH and initial phosphate concentration on the sorption capacity were also studied in batch equilibration technique. Solution pH significantly influenced the sorption. Each sample achieved the maximal removal of phosphate at pH 7.0. The amount of phosphate removal increased with the solute concentration. The Freundlich and Langmuir models were used to simulate the sorption equilibrium. The results indicate that the Langmuir model has a better correlation with the experimental data than the Freundlich model.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Standard methods: For the examination of water and waste water
(1990) · Analytical Biochemistry · doi:10.1016/0003-2697(90)90598-4 · Cited by 72,091
Standard Methods for the Examination of Water and Wastewater
Jenkins, S. H. (1982) · Water Research · doi:10.1016/0043-1354(82)90249-4 · Cited by 30,002
Non-conventional low-cost adsorbents for dye removal: A review
CRINI, G. (2006) · Bioresource Technology · doi:10.1016/j.biortech.2005.05.001 · Cited by 4,508
The Iron Oxides: Structure, Properties, Reactions, Occurences and Uses
Cornell, R. M., & Schwertmann, U. (2003) · doi:10.1002/3527602097 · Cited by 4,422
Chemistry of the solid-water interface
Stumm, W. (1992) · Cited by 1,644
Standard methods for the examination of water and wastewater: 20th ed
(2000) · Choice Reviews Online · doi:10.5860/choice.37-2792 · Cited by 1,466
Chemistry of the solid-water interface
Sposito, G. (1993) · Marine Chemistry · doi:10.1016/0304-4203(93)90021-f · Cited by 1,453
Removal of dyes from aqueous solution using fly ash and red mud
Wang, S., Boyjoo, Y., Choueib, A., & Zhu, Z. H. (2005) · Water Research · doi:10.1016/j.watres.2004.09.011 · Cited by 924
Removal of PCBs from wastewater using fly ash
Nollet, H., Roels, M., Lutgen, P., Van der Meeren, P., & Verstraete, W. (2003) · Chemosphere · doi:10.1016/s0045-6535(03)00517-4 · Cited by 526
Adsorption of Arsenic from Water Using Activated Neutralized Red Mud
Genç-Fuhrman, H., Tjell, J. C., & McConchie, D. (2004) · Environmental Science & Technology · doi:10.1021/es035207h · Cited by 375
Adsorbent properties of red mud and its use for wastewater treatment
López, E., Soto, B., Arias, M., Núñez, A., Rubinos, D., & Barral, M. T. (1998) · Water Research · doi:10.1016/s0043-1354(97)00326-6 · Cited by 348
SINGH, T., & PANT, K. (2006) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2005.06.046 · Cited by 253
Adsorption of Hexavalent Chromium from Aqueous Solution by Using Activated Red Mud
Pradhan, J., Das, S. N., & Thakur, R. S. (1999) · Journal of Colloid and Interface Science · doi:10.1006/jcis.1999.6288 · Cited by 241
Agyei, N. M., Strydom, C. A., & Potgieter, J. H. (2002) · Cement and Concrete Research · doi:10.1016/s0008-8846(02)00888-8 · Cited by 227
UGURLU, A. (1998) · Environment International · doi:10.1016/s0160-4120(98)00079-8 · Cited by 217
Adsorption of arsenate from water using neutralized red mud
Genç, H., Tjell, J. C., McConchie, D., & Schuiling, O. (2003) · Journal of Colloid and Interface Science · doi:10.1016/s0021-9797(03)00447-8 · Cited by 199
Phosphorus removal from wastewaters: Experimental and theoretical support for alternative mechanisms
Galarneau, E., & Gehr, R. (1997) · Water Research · doi:10.1016/s0043-1354(96)00256-4 · Cited by 191
Increasing the arsenate adsorption capacity of neutralized red mud (Bauxsol)
Genç-Fuhrman, H., Tjell, J. C., & McConchie, D. (2004) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2003.10.011 · Cited by 159
Adsorption of Phosphate from Aqueous Solution Using Activated Red Mud
Pradhan, J., Das, J., Das, S., & Thakur, R. S. (1998) · Journal of Colloid and Interface Science · doi:10.1006/jcis.1998.5594 · Cited by 148
Altundogan, H. S., & Tümen, F. (2001) · Journal of Chemical Technology & Biotechnology · doi:10.1002/jctb.525 · Cited by 144
Arsenate removal from water using sand–red mud columns
Genç-Fuhrman, H., Bregnhøj, H., & McConchie, D. M. (2005) · Water Research · doi:10.1016/j.watres.2005.04.050 · Cited by 144
An investigation of phosphate ion adsorption from aqueous solution by fly ash and slag
Agyei, N. M., Strydom, C. A., & Potgieter, J. H. (2000) · Cement and Concrete Research · doi:10.1016/s0008-8846(00)00225-8 · Cited by 123
Removal of chlorophenols from aqueous solution by fly ash
Kao, P. (2000) · Journal of Hazardous Materials · doi:10.1016/s0304-3894(00)00201-6 · Cited by 111
Removal of hexavalent chromium by using heat-activated bauxite
Erdem, M., Altundogan, H. S., & Tümen, F. (2004) · Minerals Engineering · doi:10.1016/j.mineng.2004.04.013 · Cited by 96
Baba, A., & Kaya, A. (2004) · Journal of Environmental Management · doi:10.1016/j.jenvman.2004.06.005 · Cited by 90
Sorption of phosphate from solid/liquid interface by fly ash
Oğuz, E. (2005) · Colloids and Surfaces A Physicochemical and Engineering Aspects · doi:10.1016/j.colsurfa.2005.04.016 · Cited by 87
Removal of phosphates from aqueous solutions by using bauxite II: the activation study
Altundogan, H. S., & Tümen, F. (2003) · Journal of Chemical Technology & Biotechnology · doi:10.1002/jctb.860 · Cited by 70
Removal of Cu2+ and Pb2+ in aqueous solutions by fly ash
Erol, M., Küçükbayrak, S., Ersoy‐Meriçboyu, A., & Ulubaş, T. (2004) · Energy Conversion and Management · doi:10.1016/j.enconman.2004.06.033 · Cited by 38
Genç, H., & Tjell, J. C. (2003) · Journal de Physique IV (Proceedings) · doi:10.1051/jp4:20030359 · Cited by 35
Cited by
Filter materials for phosphorus removal from wastewater in treatment wetlands—A review
Vohla, C., Kõiv, M., Bavor, H. J., Chazarenc, F., & Mander, Ü. (2011) · Ecological Engineering · doi:10.1016/j.ecoleng.2009.08.003 · Cited by 797
Removal and Recovery of Phosphate From Water Using Sorption
Loganathan, P., Vigneswaran, S., Kandasamy, J., & Bolan, N. S. (2014) · Critical Reviews in Environmental Science and Technology · doi:10.1080/10643389.2012.741311 · Cited by 678
Bauxite residue issues: II. options for residue utilization
Klauber, C., Gräfe, M., & Power, G. (2011) · Hydrometallurgy · doi:10.1016/j.hydromet.2011.02.007 · Cited by 580
Wang, S., Ang, H. M., & Tadé, M. O. (2008) · Chemosphere · doi:10.1016/j.chemosphere.2008.05.013 · Cited by 567
Bauxite residue issues: III. Alkalinity and associated chemistry
Gräfe, M., Power, G., & Klauber, C. (2011) · Hydrometallurgy · doi:10.1016/j.hydromet.2011.02.004 · Cited by 513
Metadata
- Authors
- Li, Y., Liu, C., Luan, Z., Peng, X., Zhu, C., Chen, Z., Zhang, Z., Fan, J., & Jia, Z.
- Venue
- Journal of Hazardous Materials
- Publisher
- Elsevier BV
- Published
- 2006-09
- Volume
- 137
- Issue
- 1
- Pages
- 374-383
- ISSN
- 0304-3894 (ISSN-L)
- OpenAlex
- W2086660480
- Cited by
- 337
- References
- 29
- FWCI
- 20.63
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.