The DOI matches its Crossref record; 52 of the 53 references it cites were found in a registry or an index.
Comparison of surface roughness of oral hard materials to the threshold surface roughness for bacterial plaque retention: A review of the literature
Abstract
Objectives The roughness of intraoral hard surfaces can influence bacterial plague retention. The present review evaluates the initial surface roughness of several intraoral hard materials, as well as changes in this surface roughness as a consequence of different treatment modalities. Methods Articles found through Medline searches were included in this review if they met the following criteria: 1) stated threshold surface roughness values and reputed change in surface roughness due to different manipulation techniques; or 2) included standardized surface conditions that could be compared to the treated surface. Results Recently, some in vivo studies suggested a threshold surface roughness for bacterial retention (Ra = 0.2 micron) below which no further reduction in bacterial accumulation could be expected. An increase in surface roughness above this threshold roughness, however, resulted in a simultaneous increase in plaque accumulation, thereby increasing the risk for both caries and periodontal inflammation. The initial surface roughness of different dental materials (e.g., teeth, abutments, gold, amalgam, acrylic resin, resin composite, glass ionomer or compomer and ceramics) and the effect of different treatment modalities (e.g., polishing, scaling, brushing, condensing, glazing or finishing) on this initial surface roughness were analyzed and compared to the threshold surface roughness of 0.2 micron. The microbiological effects of these treatment modalities, if reporte…
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Experimental gingivitis in man: II. A Longitudinal Clinical and Bacteriological Investigation
Theilade, E., Wright, W. H., Jensen, S. B., & Löe, H. (1966) · Journal of Periodontal Research · doi:10.1111/j.1600-0765.1966.tb01842.x · Cited by 1,038
Quirynen, M., & Bollen, C. M. L. (1995) · Journal of Clinical Periodontology · doi:10.1111/j.1600-051x.1995.tb01765.x · Cited by 1,037
Self-citationThe influence of abutment surface roughness on plaque accumulation and peri‐implant mucositis
Bollen, C. M. L., Papaioanno, W., Van Eldere, J., Schepers, E., Quirynen, M., & Van Steenberghe, D. (1996) · Clinical Oral Implants Research · doi:10.1034/j.1600-0501.1996.070302.x · Cited by 661
Self-citationThe effect of surface roughening of polymers on measured contact angles of liquids
Busscher, H. J., van Pelt, A. W. J., de Boer, P., de Jong, H. P., & Arends, J. (1984) · Colloids and Surfaces · doi:10.1016/0166-6622(84)80175-4 · Cited by 516
Quirynen, M., Marechal, M., Busscher, H. J., Weerkamp, A. H., Darius, P. L., & van Steenberghe, D. (1990) · Journal of Clinical Periodontology · doi:10.1111/j.1600-051x.1990.tb01077.x · Cited by 504
Self-citationQuirynen, M., Bollen, C. M. L., Papaioannou, W., Eldere, J. V., & van Steenberghe, D. (1996) · PubMed · Cited by 431
Self-citationQuirynen, M., Van Der Mei, H. C., Bollen, C. M. L., Schotte, A., Marechal, M., Doornbusch, G. I., Naert, I., Busscher, H. J., & Van Steenberghe, D. (1993) · Journal of Dental Research · doi:10.1177/00220345930720090801 · Cited by 431
Self-citationWillems, G., Lambrechts, P., Braem, M., Celis, J. P., & Vanherle, G. (1992) · Dental Materials · doi:10.1016/0109-5641(92)90106-m · Cited by 339
Self-citationGladys, S., Van Meerbeek, B., Braem, M., Lambrechts, P., & Vanherle, G. (1997) · Journal of Dental Research · doi:10.1177/00220345970760041001 · Cited by 307
Self-citationApse, P., Ellen, R. P., Overall, C. M., & Zarb, G. A. (1989) · Journal of Periodontal Research · doi:10.1111/j.1600-0765.1989.tb00863.x · Cited by 292
Research works printed but not linked: 7
- Davidson, 1979, Enige aspecten van het afwerken van composieten, Belgisch Tijdschrift Tandheelkunde, 34, 83
- De Wet, 1980, Dental glazes — Surface roughness and plaque accumulation, Quintessence Int, 9, 127
- Fehér, 1995, Die Ausarbeitung van Keramikrestaurationen mit superfeinen Diamant-instrumenten, Schweiz Monatsschr Zahnmed, 105, 474
- Johannsen, 1989, Surface changes on dentál materials. I. The influence of two different dentifrices on surface roughness measured by laser reflexion and profilometric techniques, Swed Dent J, 13, 267
- Lutz, 1995, Prophylaxepasten-Das neue Abrasiv Perlit im Vergleich zu koventionellen Putzkörpern, Schweiz Monatsschrift Zahnmedizin, 105, 30
- Pröbster, 1992, Effect of fluoride prophylactic agents on titanium surfaces, Int J Oral & Maxillofac Implants, 7, 390
- Von Mierau, 1982, Rauhigkeitsuntersuchungen an vestibúläen und lingualen Zahnoberflächen, Deutsches zahnärztliches Zeitschrift, 37, 176
Cited by
Effect of material characteristics and/or surface topography on biofilm development
Teughels, W., Van Assche, N., Sliepen, I., & Quirynen, M. (2006) · Clinical Oral Implants Research · doi:10.1111/j.1600-0501.2006.01353.x · Cited by 1,358
“An Ra value of 0.2 mm was therefore suggested as a threshold surface roughness, below which bacterial adhesion cannot be reduced further (Bollen et al. 1997).”
BackgroundInfluentialSelf-citationBeyond Risk: Bacterial Biofilms and Their Regulating Approaches
Muhammad, M. H., Idris, A. L., Fan, X., Guo, Y., Yu, Y., Jin, X., Qiu, J., Guan, X., & Huang, T. (2020) · Frontiers in Microbiology · doi:10.3389/fmicb.2020.00928 · Cited by 860
A review on the wettability of dental implant surfaces II: Biological and clinical aspects
Gittens, R. A., Scheideler, L., Rupp, F., Hyzy, S. L., Geis-Gerstorfer, J., Schwartz, Z., & Boyan, B. D. (2014) · Acta Biomaterialia · doi:10.1016/j.actbio.2014.03.032 · Cited by 849
Infectious risks for oral implants: a review of the literature
Quirynen, M., De Soete, M., & Van Steenberghe, D. (2002) · Clinical Oral Implants Research · doi:10.1034/j.1600-0501.2002.130101.x · Cited by 665
Self-citationRupp, F., Scheideler, L., Olshanska, N., de Wild, M., Wieland, M., & Geis‐Gerstorfer, J. (2006) · Journal of Biomedical Materials Research Part A · doi:10.1002/jbm.a.30518 · Cited by 651
Metadata
- Authors
- Bollenl, C. M. L., Lambrechts, P., & Quirynen, M.
- Affiliations
- UCLouvain (BE)
- Corresponding author
- Bollenl, Curd M.L.
- Venue
- Dental Materials
- Publisher
- Elsevier BV
- Published
- 1997-07
- Volume
- 13
- Issue
- 4
- Pages
- 258-269
- ISSN
- 0109-5641 (ISSN-L)
- OpenAlex
- W2144742986
- Semantic Scholar
- ea71e437137c9719ca605a5a6589eeec175820ba
- Cited by
- 1,911
- References
- 53
- Citations by year
- 2026: 184 · 2025: 143 · 2024: 125 · 2023: 117 · 2022: 141 · 2021: 115 · 2020: 124 · 2019: 114 · 2018: 118 · 2017: 94 · 2016: 93 · 2015: 72 · 2014: 72 · 2013: 50 · 2012: 56
- FWCI
- 2.14
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- www.elsevier.com/tdm/userlicense/1.0/ (tdm)
- www.elsevier.com/legal/tdmrep-license (tdm)
- Locations
- Dental Materials (publishedVersion)
- PubMed (publishedVersion)
- Funders
- National Institute of Dental and Craniofacial Research (YO1 DE30001, P50DE009322)
- Topics
- Health Sciences › Dentistry › General Dentistry › Dental materials and restorations
- Health Sciences › Dentistry › Periodontics › Oral microbiology and periodontitis research
- Health Sciences › Dentistry › Oral Surgery › Dental Implant Techniques and Outcomes
- Keywords
- surface roughness, oral hard tissue, polishing, scaling, brushing, glazing, composite resin, glass ionomer cement, gold restorations, amalgam, ceramics, caries risk, periodontal inflammation
- MeSH terms
- Dental Abutments, Acrylic Resins, Bacterial Adhesion, Ceramics, Composite Resins, Dental Amalgam, Dental Caries, Dental Materials, Dental Plaque, Glass Ionomer Cements, Gold Alloys, Humans, Periodontitis, Risk Factors, Surface Properties, Tooth, Compomers
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Comparison of surface roughness of oral hard materials to the threshold surface roughness for bacterial plaque retention: A review of the literature. https://app.cochat.ai/papers/10.1016/s0109-5641(97)80038-3
- The paper
- Bollenl, C. M. L., Lambrechts, P., & Quirynen, M. (1997). Comparison of surface roughness of oral hard materials to the threshold surface roughness for bacterial plaque retention: A review of the literature. Dental Materials. https://doi.org/10.1016/s0109-5641(97)80038-3
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.