The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.
Improving Dielectric Properties of PVDF Composites by Employing Surface Modified Strong Polarized BaTiO3 Particles Derived by Molten Salt Method
Abstract
BaTiO3/polyvinylidene fluoride (BT/PVDF) is the extensive reported composite material for application in modern electric devices. However, there still exists some obstacles prohibiting the further improvement of dielectric performance, such as poor interfacial compatibility and low dielectric constant. Therefore, in depth study of the size dependent polarization and surface modification of BT particle is of technological importance in developing high performance BT/PVDF composites. Here, a facile molten-salt synthetic method has been applied to prepare different grain sized BT particles through tailoring the calcination temperature. The size dependent spontaneous polarizationof BT particle was thoroughly investigated by theoretical calculation based on powder X-ray diffraction Rietveld refinement data. The results revealed that 600 nm sized BT particles possess the strong polarization, ascribing to the ferroelectric size effect. Furthermore, the surface of optimal BT particles has been modified by water-soluble polyvinylprrolidone (PVP) agent, and the coated particles exhibited fine core-shell structure and homogeneous dispersion in the PVDF matrix. The dielectric constant of the resulted composites increased significantly, especially, the prepared composite with 40 vol % BT loading exhibited the largest dielectric constant (65, 25 °C, 1 kHz) compared with the literature values of BT/PVDF at the same concentration of filler. Moreover, the energy storage density of the composites with tailored structure was largely enhanced at the low electric field, showing promising application as dielectric material in energy storage device. Our work suggested that introduction of strong polarized ferroelectric particles with optimal size and construction of core-shell structured coated fillers by PVP in the PVDF matrix are efficacious in improving dielectric performance of composites. The demonstrated approach can also be applied to the design and preparation of other polymers-based nanocomposites filled with ferroelectric particles to achieve desirable dielectric properties.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A Dielectric Polymer with High Electric Energy Density and Fast Discharge Speed
Chu, B., Zhou, X., Ren, K., Neese, B., Lin, M., Wang, Q., Bauer, F., & Zhang, Q. M. (2006) · Science · doi:10.1126/science.1127798 · Cited by 2,453
Dielectric properties of fine-grained barium titanate ceramics
Arlt, G., Hennings, D., & de With, G. (1985) · Journal of Applied Physics · doi:10.1063/1.336051 · Cited by 1,957
Fundamentals, processes and applications of high-permittivity polymer–matrix composites
Dang, Z.-M., Yuan, J.-K., Zha, J.-W., Zhou, T., Li, S.-T., & Hu, G.-H. (2012) · Progress in Materials Science · doi:10.1016/j.pmatsci.2011.08.001 · Cited by 1,783
Flexible Nanodielectric Materials with High Permittivity for Power Energy Storage
Dang, Z., Yuan, J., Yao, S., & Liao, R. (2013) · Advanced Materials · doi:10.1002/adma.201301752 · Cited by 1,454
Luo, B., Wang, X., Wang, Y., & Li, L. (2014) · J. Mater. Chem. A · doi:10.1039/c3ta14107a · Cited by 448
Environmentally Friendly Methodologies of Nanostructure Synthesis
Mao, Y., Park, T., Zhang, F., Zhou, H., & Wong, S. S. (2007) · Small · doi:10.1002/smll.200700048 · Cited by 348
Large-Scale Synthesis of Single-Crystalline Perovskite Nanostructures
Mao, Y., Banerjee, S., & Wong, S. S. (2003) · Journal of the American Chemical Society · doi:10.1021/ja038192w · Cited by 298
Luo, H., Zhang, D., Jiang, C., Yuan, X., Chen, C., & Zhou, K. (2015) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.5b00555 · Cited by 286
Layek, R. K., Samanta, S., Chatterjee, D. P., & Nandi, A. K. (2010) · Polymer · doi:10.1016/j.polymer.2010.09.067 · Cited by 285
Guo, N., DiBenedetto, S. A., Tewari, P., Lanagan, M. T., Ratner, M. A., & Marks, T. J. (2010) · Chemistry of Materials · doi:10.1021/cm902852h · Cited by 280
Ghosh, D., Sakata, A., Carter, J., Thomas, P. A., Han, H., Nino, J. C., & Jones, J. L. (2014) · Advanced Functional Materials · doi:10.1002/adfm.201301913 · Cited by 217
Liu, H., Hu, C., & Wang, Z. L. (2006) · Nano Letters · doi:10.1021/nl061253e · Cited by 210
Yang, K., Huang, X., Zhu, M., Xie, L., Tanaka, T., & Jiang, P. (2014) · ACS Applied Materials & Interfaces · doi:10.1021/am4048267 · Cited by 184
Self-citationCalame, J. P. (2006) · Journal of Applied Physics · doi:10.1063/1.2188032 · Cited by 139
Optical properties of silver-dispersed PVP thin film
Zheng, M.-P., Gu, M., Jin, Y., et al. (2001) · Materials Research Bulletin · doi:10.1016/s0025-5408(01)00525-6 · Cited by 135
Self-citationZhang, W., Xu, X.-L., Yang, J., et al. (2014) · Composites Science and Technology · doi:10.1016/j.compscitech.2014.10.019 · Cited by 98
Shift of morphotropic phase boundary in high-performance fine-grained PZN–PZT ceramics
Zheng, M., Hou, Y., Zhu, M., Zhang, M., & Yan, H. Y. (2014) · Journal of the European Ceramic Society · doi:10.1016/j.jeurceramsoc.2014.02.041 · Cited by 84
Self-citationA Novel, Controlled, and High-Yield Solvothermal Drying Route to Nanosized Barium Titanate Powders
Kolen’ko, Y. V., Kovnir, K. A., Neira, I. S., Taniguchi, T., Ishigaki, T., Watanabe, T., Sakamoto, N., & Yoshimura, M. (2007) · The Journal of Physical Chemistry C · doi:10.1021/jp0678103 · Cited by 74
General surfactant-free synthesis of MTiO3 (M = Ba, Sr, Pb) perovskite nanostrips
Deng, H., Qiu, Y., & Yang, S. (2009) · Journal of Materials Chemistry · doi:10.1039/b815698k · Cited by 71
Reverse boundary layer capacitor model in glass/ceramic composites for energy storage applications
Wei, X., Yan, H., Wang, T., Hu, Q., Viola, G., Grasso, S., Jiang, Q., Jin, L., Xu, Z., & Reece, M. J. (2013) · Journal of Applied Physics · doi:10.1063/1.4775493 · Cited by 68
Self-citationAchaby, M. E., Arrakhiz, F. Z., Vaudreuil, S., Essassi, E. M., Qaiss, A. E. K., & Bousmina, M. (2012) · Polymer Engineering and Science · doi:10.1002/pen.23236 · Cited by 61
Kobayashi, Y., Kosuge, A., & Konno, M. (2008) · Applied Surface Science · doi:10.1016/j.apsusc.2008.08.006 · Cited by 44
Size dependence of the polarization and dielectric properties of KNbO 3 nanoparticles
Ge, H., Huang, Y., Hou, Y., Han, X., & Zhu, M. (2014) · RSC Advances · doi:10.1039/c4ra03613a · Cited by 30
Self-citationZhao, S., Gao, H. T., Ren, X., Yuan, G., & Lü, Y. (2011) · Journal of Materials Chemistry · doi:10.1039/c1jm13115j · Cited by 22
Cited by
Interface design for high energy density polymer nanocomposites
Luo, H., Zhou, X., Ellingford, C., Zhang, Y., Chen, S., Zhou, K., Zhang, D., Bowen, C. R., & Wan, C. (2019) · Chemical Society Reviews · doi:10.1039/c9cs00043g · Cited by 799
Yang, Y., Pan, H., Xie, G., Jiang, Y., Chen, C., Su, Y., Wang, Y., & Tai, H. (2020) · Sensors and Actuators A: Physical · doi:10.1016/j.sna.2019.111789 · Cited by 496
An overview of lead-free piezoelectric materials and devices
Wei, H., Wang, H., Xia, Y., Cui, D., Shi, Y., Dong, M., Liu, C., Ding, T., Zhang, J., Ma, Y., et al. (2018) · Journal of Materials Chemistry C · doi:10.1039/c8tc04515a · Cited by 393
Insights into the Role of Ferroelectric Polarization in Piezocatalysis of Nanocrystalline BaTiO3
Wu, J., Xu, Q., Lin, E., Yuan, B., Qin, N., Thatikonda, S. K., & Bao, D. (2018) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.8b01991 · Cited by 357
Luo, S., Shen, Y., Yu, S., Wan, Y., Liao, W.-H., Sun, R., & Wong, C.-P. (2017) · Energy & Environmental Science · doi:10.1039/c6ee03190k · Cited by 313
Metadata
- Authors
- Fu, J., Hou, Y., Zheng, M., Wei, Q., Zhu, M., & Yan, H.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2015-10-29
- Volume
- 7
- Issue
- 44
- Pages
- 24480-24491
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2324793451
- Cited by
- 350
- References
- 24
- FWCI
- 12.27
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.