The DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Comparison of Methods for Determining the Mechanical Properties of Semiconducting Polymer Films for Stretchable Electronics
Abstract
This paper describes a comparison of two characterization techniques for determining the mechanical properties of thin-film organic semiconductors for applications in soft electronics. In the first method, the film is supported by water (film-on-water, FOW), and a stress–strain curve is obtained using a direct tensile test. In the second method, the film is supported by an elastomer (film-on-elastomer, FOE), and is subjected to three tests to reconstruct the key features of the stress–strain curve: the buckling test (tensile modulus), the onset of buckling (yield point), and the crack-onset strain (strain at fracture). The specimens used for the comparison are four poly(3-hexylthiophene) (P3HT) samples of increasing molecular weight ( M n = 15, 40, 63, and 80 kDa). The methods produced qualitatively similar results for mechanical properties including the tensile modulus, the yield point, and the strain at fracture. The agreement was not quantitative because of differences in mode of loading (tension vs compression), strain rate, and processing between the two methods. Experimental results are corroborated by coarse-grained molecular dynamics simulations, which lead to the conclusion that in low molecular weight samples ( M n = 15 kDa), fracture occurs by chain pullout. Conversely, in high molecular weight samples ( M n > 25 kDa), entanglements concentrate the stress to few chains; this concentration is consistent with chain scission as the dominant mode of fracture. Our results provide a basis for comparing mechanical properties that have been measured by these two techniques, and provide mechanistic insight into fracture modes in this class of materials.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
An ultra-lightweight design for imperceptible plastic electronics
Kaltenbrunner, M., Sekitani, T., Reeder, J., Yokota, T., Kuribara, K., Tokuhara, T., Drack, M., Schwödiauer, R., Graz, I., Bauer-Gogonea, S., et al. (2013) · Nature · doi:10.1038/nature12314 · Cited by 2,485
Kröger, M. (2005) · Computer Physics Communications · doi:10.1016/j.cpc.2005.01.020 · Cited by 459
Hoy, R. S., Foteinopoulou, K., & Kröger, M. (2009) · Physical Review E · doi:10.1103/physreve.80.031803 · Cited by 335
Primitive path networks generated by annealing and geometrical Methods: insights into differences
Shanbhag, S., & Kröger, M. (2007) · Macromolecules · doi:10.1021/ma062457k · Cited by 217
Cited by
K, N., & Rout, C. S. (2021) · RSC Advances · doi:10.1039/d0ra07800j · Cited by 1,354
Root, S. E., Savagatrup, S., Printz, A. D., Rodriquez, D., & Lipomi, D. J. (2017) · Chemical Reviews · doi:10.1021/acs.chemrev.7b00003 · Cited by 904
Self-citationRecent progress in flexible–wearable solar cells for self-powered electronic devices
Hashemi, S. A., Ramakrishna, S., & Aberle, A. G. (2020) · Energy & Environmental Science · doi:10.1039/c9ee03046h · Cited by 527
Transparent Electronics for Wearable Electronics Application
Won, D., Bang, J., Choi, S. H., Pyun, K. R., Jeong, S., Lee, Y., & Ko, S. H. (2023) · Chemical Reviews · doi:10.1021/acs.chemrev.3c00139 · Cited by 339
Kim, H.-J., Sim, K., Thukral, A., & Yu, C. (2017) · Science Advances · doi:10.1126/sciadv.1701114 · Cited by 274
Metadata
- Authors
- Rodriquez, D., Kim, J.-H., Root, S. E., Fei, Z., Boufflet, P., Heeney, M., Kim, T.-S., & Lipomi, D. J.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2017-03-02
- Volume
- 9
- Issue
- 10
- Pages
- 8855-8862
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2590095297
- Cited by
- 174
- References
- 4
- FWCI
- 7.83
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Comparison of Methods for Determining the Mechanical Properties of Semiconducting Polymer Films for Stretchable Electronics. https://app.cochat.ai/papers/10.1021/acsami.6b16115
- The paper
- Rodriquez, D., Kim, J.-H., Root, S. E., Fei, Z., Boufflet, P., Heeney, M., Kim, T.-S., & Lipomi, D. J. (2017). Comparison of Methods for Determining the Mechanical Properties of Semiconducting Polymer Films for Stretchable Electronics. ACS Applied Materials & Interfaces. https://doi.org/10.1021/acsami.6b16115
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.