The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Mg-Doped ZnO Nanoparticles for Efficient Sunlight-Driven Photocatalysis
Abstract
Magnesium-doped ZnO (ZMO) nanoparticles were synthesized through an oxalate coprecipitation method. Crystallization of ZMO upon thermal decomposition of the oxalate precursors was investigated using differential scanning calorimetry (DSC) and X-ray diffraction (XRD) techniques. XRD studies point toward a significant c-axis compression and reduced crystallite sizes for ZMO samples in contrast to undoped ZnO, which was further confirmed by HRSEM studies. X-ray photoelectron spectroscopy (XPS), UV/vis spectroscopy and photoluminescence (PL) spectroscopy were employed to establish the electronic and optical properties of these nanoparticles. (XPS) studies confirmed the substitution of Zn(2+) by Mg(2+), crystallization of MgO secondary phase, and increased Zn-O bond strengths in Mg-doped ZnO samples. Textural properties of these ZMO samples obtained at various calcination temperatures were superior in comparison to the undoped ZnO. In addition to this, ZMO samples exhibited a blue-shift in the near band edge photoluminescence (PL) emission, decrease of PL intensities and superior sunlight-induced photocatalytic decomposition of methylene blue in contrast to undoped ZnO. The most active photocatalyst 0.1-MgZnO obtained after calcination at 600 °C showed a 2-fold increase in photocatalytic activity compared to the undoped ZnO. Band gap widening, superior textural properties and efficient electron-hole separation were identified as the factors responsible for the enhanced sunlight-driven photocatalytic activities of Mg-doped ZnO nanoparticles.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Shannon, R. D. (1976) · Acta Crystallographica Section A · doi:10.1107/s0567739476001551 · Cited by 66,145
A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films
O'Regan, B., & Grätzel, M. (1991) · Nature · doi:10.1038/353737a0 · Cited by 28,599
Growth of Arrayed Nanorods and Nanowires of ZnO from Aqueous Solutions
Vayssieres, L. (2003) · Advanced Materials · doi:10.1002/adma.200390108 · Cited by 2,706
Transparent conductors—A status review
Chopra, K. L., Major, S. S., & Pandya, D. K. (1983) · Thin Solid Films · doi:10.1016/0040-6090(83)90256-0 · Cited by 2,700
Meeting the Clean Energy Demand: Nanostructure Architectures for Solar Energy Conversion
Kamat, P. V. (2007) · The Journal of Physical Chemistry C · doi:10.1021/jp066952u · Cited by 2,249
Daylight Photocatalysis by Carbon‐Modified Titanium Dioxide
Sakthivel, S., & Kisch, H. (2003) · Angewandte Chemie International Edition · doi:10.1002/anie.200351577 · Cited by 2,067
Liqiang, J., Yichun, Q., Baiqi, W., Shudan, L., Baojiang, J., Libin, Y., Wei, F., Honggang, F., & Jiazhong, S. (2006) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2005.11.007 · Cited by 1,942
Solar photocatalytic degradation of azo dye: comparison of photocatalytic efficiency of ZnO and TiO2
Sakthivel, S., Neppolian, B., Shankar, M. V., Arabindoo, B., Palanichamy, M., & Murugesan, V. (2003) · Solar Energy Materials and Solar Cells · doi:10.1016/s0927-0248(02)00255-6 · Cited by 1,684
Solid state chemistry and its applications
Beruto, D. (1984) · Materials Chemistry and Physics · doi:10.1016/0254-0584(84)90072-5 · Cited by 1,562
Photocatalytic degradation of model textile dyes in wastewater using ZnO as semiconductor catalyst
CHAKRABARTI, S., & DUTTA, B. (2004) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2004.05.013 · Cited by 1,209
Cited by
Recent developments of zinc oxide based photocatalyst in water treatment technology: A review
Lee, K. M., Lai, C. W., Ngai, K. S., & Juan, J. C. (2016) · Water Research · doi:10.1016/j.watres.2015.09.045 · Cited by 2,341
Visible-light activation of TiO2 photocatalysts: Advances in theory and experiments
Etacheri, V., Di Valentin, C., Schneider, J., Bahnemann, D., & Pillai, S. C. (2015) · Journal of Photochemistry and Photobiology C: Photochemistry Reviews · doi:10.1016/j.jphotochemrev.2015.08.003 · Cited by 1,475
Self-citationReview on the improvement of the photocatalytic and antibacterial activities of ZnO
Qi, K., Cheng, B., Yu, J., & Ho, W. (2017) · Journal of Alloys and Compounds · doi:10.1016/j.jallcom.2017.08.142 · Cited by 1,226
Kumar, S. G., & Rao, K. S. R. K. (2015) · RSC Advances · doi:10.1039/c4ra13299h · Cited by 885
Kumar, S. G., & Rao, K. S. R. K. (2017) · Applied Surface Science · doi:10.1016/j.apsusc.2016.07.081 · Cited by 800
Medhi, R., Marquez, M. D., & Lee, T. R. (2020) · ACS Applied Nano Materials · doi:10.1021/acsanm.0c01035 · Cited by 383
Kuriakose, S., Satpati, B., & Mohapatra, S. (2014) · Physical Chemistry Chemical Physics · doi:10.1039/c4cp01315h · Cited by 364
Subash, B., Krishnakumar, B., Swaminathan, M., & Shanthi, M. (2013) · Langmuir · doi:10.1021/la303842c · Cited by 355
Cai, Z., Dwivedi, A. D., Lee, W.-N., Zhao, X., Liu, W., Sillanpää, M., Zhao, D., Huang, C.-H., & Fu, J. (2018) · Environmental Science: Nano · doi:10.1039/c7en00644f · Cited by 338
Shah, N. S., Khan, J. A., Sayed, M., Khan, Z. U. H., Rizwan, A. D., Muhammad, N., Boczkaj, G., Murtaza, B., Imran, M., Khan, H. M., et al. (2018) · Chemical Engineering Journal · doi:10.1016/j.cej.2018.06.111 · Cited by 275
Etacheri, V., Michlits, G., Seery, M. K., Hinder, S. J., & Pillai, S. C. (2013) · ACS Applied Materials & Interfaces · doi:10.1021/am302676a · Cited by 263
Self-citationMoqbel, R. A., Gondal, M. A., Qahtan, T. F., & Dastageer, M. A. (2018) · Materials Research Express · doi:10.1088/2053-1591/aab6ec · Cited by 23
Metadata
- Authors
- Etacheri, V., Roshan, R., & Kumar, V.
- Venue
- ACS Applied Materials & Interfaces
- Publisher
- American Chemical Society (ACS)
- Published
- 2012-05-10
- Volume
- 4
- Issue
- 5
- Pages
- 2717-2725
- ISSN
- 1944-8244 (ISSN-L)
- 1944-8252
- OpenAlex
- W2001967060
- Cited by
- 547
- References
- 29
- FWCI
- 9.99
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.