The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Biodegradable Polylactide/Chitosan Blend Membranes
Abstract
Biodegradable blend membranes based on polylactide and chitosan with various compositions were prepared via a two-step processing pathway. In the first step, solutions of each component were properly mixed and cast into a gelatinous membrane, and in the second step, the obtained membrane was immersed into a mixed solution for the solvent extraction followed by a drying procedure to finally generate a well-blended membrane. An acetic acid-acetone solvent system was selected for poly(DL-lactide)/chitosan membranes, and another solvent system for poly(L-lactide)/chitosan membranes consisted of acetic acid and dimethyl sulfoxide. Some processing parameters, such as the concentration of component solutions and the composition ratio of mixed solvents and extraction solvents, were optimized by primarily considering whether the directly visible phase separation occurred during the processing procedures. Morphologies of these blend membranes were viewed using SEM. It was found that the processing parameters exerted quite notable impacts on the morphology of the membranes. The hydrophilicity of membranes was examined by measuring their water contact angle and swelling index. These blend membranes were also investigated for their miscibility using IR spectra, X-ray diffractograms, TG, DSC, and dynamic mechanical analysis methods. Although the presence of phase separation at a microscopic level was detected for these membranes, pronounced interactions between components were confirmed. The obtained results shown that some membranes prepared under optimized processing conditions had a partially miscible structure.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Crystallinity and mechanical properties of optically pure polylactides and their blends
Sarasua, J. R., Arraiza, A. L., Balerdi, P., & Maiza, I. (2005) · Polymer Engineering & Science · doi:10.1002/pen.20331 · Cited by 214
Cited by
Poly(lactic acid) modifications
Rasal, R. M., Janorkar, A. V., & Hirt, D. E. (2010) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2009.12.003 · Cited by 2,204
Biodegradable Polymers-A Review on Recent Trends and Emerging Perspectives
Luckachan, G. E., & Pillai, C. K. S. (2011) · Journal of Polymers and the Environment · doi:10.1007/s10924-011-0317-1 · Cited by 767
Structure and properties of the nanocomposite films of chitosan reinforced with cellulose whiskers
Li, Q., Zhou, J., & Zhang, L. (2009) · Journal of Polymer Science Part B: Polymer Physics · doi:10.1002/polb.21711 · Cited by 311
Toughness decrease of PLA‐PHBHHx blend films upon surface‐confined photopolymerization
Rasal, R. M., & Hirt, D. E. (2009) · Journal of Biomedical Materials Research Part A · doi:10.1002/jbm.a.32009 · Cited by 120
Polyurethane-Grafted Chitosan as New Biomaterials for Controlled Drug Delivery
Mahanta, A. K., Mittal, V., Singh, N., Dash, D., Malik, S., Kumar, M., & Maiti, P. (2015) · Macromolecules · doi:10.1021/acs.macromol.5b00030 · Cited by 110
Metadata
- Authors
- Wan, Y., Wu, H., Yu, A., & Wen, D.
- Venue
- Biomacromolecules
- Publisher
- American Chemical Society (ACS)
- Published
- 2006-03-25
- Volume
- 7
- Issue
- 4
- Pages
- 1362-1372
- ISSN
- 1525-7797 (ISSN-L)
- 1526-4602
- OpenAlex
- W2008416496
- Cited by
- 247
- References
- 1
- FWCI
- 5.59
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.