The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
Redox Investigation of Some Oxides of Transition-State Metals Ni, Cu, Fe, and Mn Supported on SiO2 and MgAl2O4
Abstract
Chemical-looping combustion (CLC) and chemical-looping reforming (CLR) involve the use of a metal oxide as an oxygen carrier which transfers oxygen from combustion air to the fuel. Two interconnected fluidized beds, a fuel reactor, and an air reactor are used in both processes. In the fuel reactor, the fuel is oxidized by a metal oxide, and in the air reactor, the reduced metal is oxidized back to the original phase. In CLC, a high conversion of the fuel to CO 2 and H 2 O is required in the fuel reactor, whereas only a partial oxidation of the fuel is desired in CLR. Oxides of Ni, Cu, Fe, and Mn supported on SiO 2 and MgAl 2 O 4 were prepared by dry impregnation and investigated under alternating reducing and oxidizing conditions in a thermogravimetric analyzer at 800−1000 °C using fuel (10% CH 4, 10% H 2 O, and 5% CO 2 ) and oxidizing gas (5% O 2 ). NiO and CuO supported on both SiO 2 and MgAl 2 O 4 showed very high reactivity. However, the reactivity of NiO/SiO 2 decreased as a function of the cycle number at 950 °C but was avoided below 850 °C. SiO 2 -supported Mn and Fe oxides may not be feasible oxygen carriers to be used in the process because of the formation of irreversible silicates at high temperatures. However, iron and manganese oxide supported on MgAl 2 O 4 showed a rather high reactivity during reduction and oxidation and can possibly be used in the process. The amount of material needed in air and fuel reactors was estimated in the range of 127−350 kg/MW th, and the recirculation rate of the oxygen carrier necessary between the two reactors was 1.5−8.0 kg MW th - 1 s - 1 for CLC.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Lyngfelt, A., Leckner, B., & Mattisson, T. (2001) · Chemical Engineering Science · doi:10.1016/s0009-2509(01)00007-0 · Cited by 1,032
Self-citationSelection of Oxygen Carriers for Chemical-Looping Combustion
Adánez, J., de Diego, L. F., García-Labiano, F., Gayán, P., Abad, A., & Palacios, J. M. (2004) · Energy & Fuels · doi:10.1021/ef0301452 · Cited by 754
Evaluation of a chemical-looping-combustion power-generation system by graphic exergy analysis
Ishida, M., Zheng, D., & Akehata, T. (1987) · Energy · doi:10.1016/0360-5442(87)90119-8 · Cited by 572
Mattisson, T., Järdnäs, A., & Lyngfelt, A. (2003) · Energy & Fuels · doi:10.1021/ef020151i · Cited by 331
Self-citationA Novel Chemical-Looping Combustor without NOx Formation
Ishida, M., & Jin, H. (1996) · Industrial & Engineering Chemistry Research · doi:10.1021/ie950680s · Cited by 319
Zafar, Q., Mattisson, T., & Gevert, B. (2005) · Industrial & Engineering Chemistry Research · doi:10.1021/ie048978i · Cited by 292
Self-citationGarcía-Labiano, F., de Diego, L. F., Adánez, J., Abad, A., & Gayán, P. (2004) · Industrial & Engineering Chemistry Research · doi:10.1021/ie0493311 · Cited by 250
Cited by
Progress in Chemical-Looping Combustion and Reforming technologies
Adanez, J., Abad, A., Garcia-Labiano, F., Gayan, P., & de Diego, L. F. (2012) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2011.09.001 · Cited by 2,230
Chemical-looping combustion (CLC) for inherent CO2 separations—a review
Hossain, M. M., & de Lasa, H. I. (2008) · Chemical Engineering Science · doi:10.1016/j.ces.2008.05.028 · Cited by 961
Biomass-based chemical looping technologies: the good, the bad and the future
Zhao, X., Zhou, H., Sikarwar, V. S., Zhao, M., Park, A.-H. A., Fennell, P. S., Shen, L., & Fan, L.-S. (2017) · Energy & Environmental Science · doi:10.1039/c6ee03718f · Cited by 558
Metadata
- Authors
- Zafar, Q., Mattisson, T., & Gevert, B.
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2005-12-01
- Volume
- 20
- Issue
- 1
- Pages
- 34-44
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2077438722
- Cited by
- 273
- References
- 7
- FWCI
- 4.34
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.