Effect of Operating Parameters on the Direct Methanol Fuel Cell Using Air or Oxygen As an Oxidant Gas
The DOI matches its Crossref record; 15 of the 15 references it cites were found in a registry or an index.
Abstract
The objective of this study is to analyze the performance characteristics of the direct methanol fuel cell (DMFC) using air or oxygen as the oxidant gas at various operating conditions. In order to investigate the effect of various operating parameters on DMFC performance, experiments were performed with various parameters including cell temperature, methanol concentration, flow rate, cathode humidification temperature, and cathode backpressure. The membrane electrode assembly (MEA) used Nafion 117, by loading a Pt−Ru (4 mg/cm 2 ) catalyst at the anode and Pt−black (4 mg/cm 2 ) catalyst at the cathode. The performance of the DMFC was analyzed with a polarization curve, which was measured with the voltage−current density and power−current density. It was revealed that the performance of the DMFC was enhanced by increasing of the cell temperature, cathode flow rate, and cathode backpressure. Also, the methanol diffusion and transfer conversion rate of the fuel cell are analyzed by using the effective mass transfer coefficient and Damkohler number under various performance parameters. The comparison of the performance with both air and oxygen showed that using the oxygen resulted in higher performance than that of air by the active electrochemical reaction.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“although using oxygen versus air at the cathode will have an influence on the absolute values of the power density in DMFC”
From Acid–base blend membranes consisting of sulfonated poly(ether ether ketone) and 5-amino-benzotriazole tethered polysulfone for DMFC (2010) · cites this paper as [38]
In the citing paper
“by increasing the flow rate and back pressure of the air supply, DMFC performances similar to that obtained with oxygen as an oxidant could be achieved in a DMFC for the blend membrane [37,38].”
From Acid–base blend membranes consisting of sulfonated poly(ether ether ketone) and 5-amino-benzotriazole tethered polysulfone for DMFC (2010) · cites this paper as [38]
Citations
Cites
Methanol crossover in direct methanol fuel cells: a link between power and energy density
Gurau, B., & Smotkin, E. S. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00445-7 · Cited by 367
The impact of mass transport and methanol crossover on the direct methanol fuel cell
Scott, K., Taama, W. M., Argyropoulos, P., & Sundmacher, K. (1999) · Journal of Power Sources · doi:10.1016/s0378-7753(99)00303-1 · Cited by 297
Open circuit voltage and methanol crossover in DMFCs
Qi, Z., & Kaufman, A. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00268-9 · Cited by 199
Experimental studies of a direct methanol fuel cell
Ge, J., & Liu, H. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2004.11.022 · Cited by 177
06/01900 Experimental studies of a direct methanol fuel cell
(2006) · Fuel and Energy Abstracts · doi:10.1016/s0140-6701(06)81906-5 · Cited by 166
Performance of a direct methanol polymer electrolyte fuel cell
Hwan Jung, D., Hyeong Lee, C., Soo Kim, C., & Ryul Shin, D. (1998) · Journal of Power Sources · doi:10.1016/s0378-7753(97)02793-6 · Cited by 163
Self-citationLimiting current behaviour of the direct methanol fuel cell
Scott, K., Taama, W. M., Kramer, S., Argyropoulos, P., & Sundmacher, K. (1999) · Electrochimica Acta · doi:10.1016/s0013-4686(99)00285-6 · Cited by 106
Shukla, A. K., Christensen, P. A., Dickinson, A. J., & HAMNETT, A. (1998) · Journal of Power Sources · doi:10.1016/s0378-7753(98)00140-2 · Cited by 97
Study of operational parameters on the performance of micro PEMFCs with different flow fields
Hsieh, S., Yang, S.-H., Kuo, J., Huang, C.-F., & Tsai, H.-H. (2005) · Energy Conversion and Management · doi:10.1016/j.enconman.2005.10.011 · Cited by 86
Experimental investigations of the anode flow field of a micro direct methanol fuel cell
Wong, C. W., Zhao, T. S., Ye, Q., & Liu, J. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2005.04.028 · Cited by 83
Cited by
Kumar, P., Dutta, K., Das, S., & Kundu, P. P. (2014) · International Journal of Energy Research · doi:10.1002/er.3163 · Cited by 115
“Seo and Lee investigated the influence of operating temperature, CH3OH concentration, CH3OH flow rate, cathode flow rate and cathode backpressure on CH3OH crossover and efficiency of a DMFC [156].”
BackgroundZhang, Y., Gu, Y., Lin, S., Wei, J., Wang, Z., Wang, C., Du, Y., & Ye, W. (2011) · Electrochimica Acta · doi:10.1016/j.electacta.2011.07.094 · Cited by 99
Li, W., Manthiram, A., & Guiver, M. D. (2010) · Journal of Membrane Science · doi:10.1016/j.memsci.2010.06.059 · Cited by 75
“It is worth mentioning that although using oxygen versus air at the cathode will have an influence on the absolute values of the power density in DMFC, by increasing the flow rate and back pressure of the air supply, DMFC performances similar to that obtained with oxygen as an oxidant could be achieved in a DMFC for t…”
BackgroundLue, S. J., Wang, W., Mahesh, K. P. O., & Yang, C. (2010) · Journal of Power Sources · doi:10.1016/j.jpowsour.2010.06.049 · Cited by 61
Puthiyapura, V. K., Lin, W.-F., Russell, A. E., Brett, D. J. L., & Hardacre, C. (2018) · Topics in Catalysis · doi:10.1007/s11244-018-0893-6 · Cited by 53
Metadata
- Authors
- Seo, S. H., & Lee, C. S.
- Affiliations
- Hanyang University (KR)
- Corresponding author
- Lee, Chang Sik
- ORCID
- Lee, Chang Sik
- Venue
- Energy & Fuels
- Publisher
- American Chemical Society (ACS)
- Published
- 2008-02-09
- Volume
- 22
- Issue
- 2
- Pages
- 1212-1219
- ISSN
- 0887-0624 (ISSN-L)
- 1520-5029
- OpenAlex
- W2035501738
- Semantic Scholar
- d431aee21e0e0a7093a063e796330bf1c60f5f60
- Cited by
- 45
- References
- 15
- Citations by year
- 2025: 2 · 2024: 1 · 2023: 4 · 2022: 3 · 2021: 1 · 2020: 2 · 2019: 1 · 2018: 3 · 2016: 2 · 2015: 1 · 2014: 6 · 2013: 5 · 2012: 1
- FWCI
- 3.89
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Energy & Fuels (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Fuel Cells and Related Materials
- Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
- Physical Sciences › Materials Science › Materials Chemistry › Advancements in Solid Oxide Fuel Cells
- Keywords
- direct methanol fuel cells, air oxidant, oxygen oxidant, operating conditions, cell temperature, methanol concentration, cathode humidification, Nafion 117 membrane, Damköhler number, polarization curves, power density
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.