The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Carbon Dioxide Adsorption on Amine-Impregnated Mesoporous SBA-15 Sorbents: Experimental and Kinetics Study
Abstract
In this work, an experimental and theoretical investigation was conducted on the adsorptive removal of CO 2 onto tetraethylenepentamine (TEPA) functionalized mesoporous SBA-15. The functionalization of SBA-15 silica with TEPA was achieved using a conventional wet impregnation technique. The structural properties of the mesoporous silica sorbents were characterized by nitrogen adsorption/desorption, SAXS, SEM, TEM, and FTIR techniques. The adsorption of CO 2 on the amine-impregnated sorbent was measured by thermogravimetric method over a CO 2 partial pressure range of 10–100 kPa and a temperature range of 30–100 °C under atmospheric pressure. The effects on CO 2 adsorption capacity of temperature, partial pressure of CO 2, amine loading, and moisture were evaluated. All the impregnated SBA-15 sorbents showed reversible CO 2 adsorption behaviors with fast adsorption kinetics. The CO 2 adsorption capacity measured at different temperatures suggests that the optimal adsorption temperature is 75 °C. The CO 2 uptake of the amine-impregnated sorbent increased significantly in the presence of moisture. SBA-15 containing 60 wt % TEPA showed the highest CO 2 adsorption capacity of 5.22 mmol/g in pure and humid CO 2 at 75 °C. Temperature swing adsorption/desorption cycles were also explored using simulated flue gas in both dry and humid conditions, and it was found that CO 2 uptake after ten cycles was within 90% of CO 2 uptake of the first cycle. Different adsorption kinetic models have also been investigated to analyze the experimental data of CO 2 uptake. The model was validated with the experimental results of isothermal adsorption measurements of CO 2 on SBA-15/TEPA. It has been found that Fractional Order kinetic model ( Chem. Eng. J. 2011, 173, 72) is very good over the entire adsorption region of the study with a maximum average absolute deviation between experimental CO 2 uptake and that calculated from the model of about 2.42%.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Post-Combustion CO 2 Capture Using Solid Sorbents: A Review
Samanta, A., Zhao, A., Shimizu, G. K. H., Sarkar, P., & Gupta, R. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie200686q · Cited by 1,889
Self-citation
Cited by
Amine-Based CO2 Capture Technology Development from the Beginning of 2013—A Review
Dutcher, B., Fan, M., & Russell, A. G. (2015) · ACS Applied Materials & Interfaces · doi:10.1021/am507465f · Cited by 981
Sorbents for the Direct Capture of CO 2 from Ambient Air
Shi, X., Xiao, H., Azarabadi, H., Song, J., Wu, X., Chen, X., & Lackner, K. S. (2020) · Angewandte Chemie International Edition · doi:10.1002/anie.201906756 · Cited by 679
Direct Air Capture of CO2 by Physisorbent Materials
Kumar, A., Madden, D. G., Lusi, M., Chen, K., Daniels, E. A., Curtin, T., Perry, J. J., & Zaworotko, M. J. (2015) · Angewandte Chemie International Edition · doi:10.1002/anie.201506952 · Cited by 588
Effective Removal of Anionic Textile Dyes Using Adsorbent Synthesized from Coffee Waste
Wong, S., Ghafar, N. A., Ngadi, N., Razmi, F. A., Inuwa, I. M., Mat, R., & Amin, N. A. S. (2020) · Scientific Reports · doi:10.1038/s41598-020-60021-6 · Cited by 394
Trace CO 2 capture by an ultramicroporous physisorbent with low water affinity
Mukherjee, S., Sikdar, N., O’Nolan, D., Franz, D. M., Gascón, V., Kumar, A., Kumar, N., Scott, H. S., Madden, D. G., Kruger, P. E., et al. (2019) · Science Advances · doi:10.1126/sciadv.aax9171 · Cited by 253
Metadata
- Authors
- Zhao, A., Samanta, A., Sarkar, P., & Gupta, R.
- Venue
- Industrial & Engineering Chemistry Research
- Publisher
- American Chemical Society (ACS)
- Published
- 2013-05-03
- Volume
- 52
- Issue
- 19
- Pages
- 6480-6491
- ISSN
- 0888-5885 (ISSN-L)
- 1520-5045
- OpenAlex
- W2322277694
- Cited by
- 186
- References
- 1
- FWCI
- 22.14
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.