The DOI matches its Crossref record; 25 of the 25 references it cites were found in a registry or an index.
Soluble Electroluminescent Poly(phenylene vinylene)s with Balanced Electron- and Hole Injections
Abstract
We report a new route for the design of efficient soluble electroluminescent PPV-based copolymers bearing electron-deficient oxadiazole (OXD) moieties on side chains. The introduction of OXD through a long alkylene spacer with PPV backbone provides a molecular dispersion of OXD in the film; both the side chain OXD and the main chain PPV do retain their own electron-transport and emissive properties, respectively. The use of phenylene vinylene derivatives with asymmetric and branched substituents and a long spacer provides solubility for ease of device fabrication as well as amorphous structure to allow a well-mixing of OXD groups with the main chains. By properly adjusting the OXD content through copolymerization, we can tailor the chemical structure of electroluminescent material to give a balance of hole- and electron injections for various metal cathodes, such that the quantum efficiency is significantly improved and the turn-on voltage is reduced for the devices with aluminum and calcium. For the device with calcium fabricated in open air, a maximum brightness of 15000 cd/m(2) at 15 V/100 nm and a maximum luminance efficiency of 2.27 cd/A can be obtained, respectively, about 30 times brighter and 9.4 times more efficient than those with the corresponding homopolymer, poly[2-methoxy-5-(2'-ethylhexyloxy)-p-phenylenevinylene] (MEH-PPV). The use of physical blends to simulate the copolymers provides no significant improvement, since phase-separation structures appear, causing an inefficient utilization of OXD and sometimes voltage-dependent emission spectra. The present route permits a fabrication of single layer PLED with high brightness, high efficiency, and low turn-on voltage.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Light-emitting diodes based on conjugated polymers
Burroughes, J. H., Bradley, D. D. C., Brown, A. R., Marks, R. N., Mackay, K., Friend, R. H., Burns, P. L., & Holmes, A. B. (1990) · Nature · doi:10.1038/347539a0 · Cited by 11,393
Electroluminescence in conjugated polymers
Friend, R. H., Gymer, R. W., Holmes, A. B., Burroughes, J. H., Marks, R. N., Taliani, C., Bradley, D. D. C., Santos, D. A. D., Brédas, J. L., Lögdlund, M., et al. (1999) · Nature · doi:10.1038/16393 · Cited by 5,977
Electroluminescent Conjugated Polymers—Seeing Polymers in a New Light
Kraft, A., Grimsdale, A. C., & Holmes, A. B. (1998) · Angewandte Chemie International Edition · doi:10.1002/(sici)1521-3773(19980302)37:4<402::aid-anie402>3.0.co;2-9 · Cited by 3,124
Flexible light-emitting diodes made from soluble conducting polymers
Gustafsson, G., Cao, Y., Treacy, G. M., Klavetter, F., Colaneri, N., & Heeger, A. J. (1992) · Nature · doi:10.1038/357477a0 · Cited by 2,407
Efficient light-emitting diodes based on polymers with high electron affinities
Greenham, N. C., Moratti, S. C., Bradley, D. D. C., Friend, R. H., & Holmes, A. B. (1993) · Nature · doi:10.1038/365628a0 · Cited by 1,653
Carrier tunneling and device characteristics in polymer light-emitting diodes
Parker, I. D. (1994) · Journal of Applied Physics · doi:10.1063/1.356350 · Cited by 1,523
Bredas, J. L., Silbey, R., Boudreaux, D. S., & Chance, R. R. (1983) · Journal of the American Chemical Society · doi:10.1021/ja00360a004 · Cited by 1,238
Improved quantum efficiency for electroluminescence in semiconducting polymers
Cao, Y., Parker, I. D., Yu, G., Zhang, C., & Heeger, A. J. (1999) · Nature · doi:10.1038/17087 · Cited by 822
Brown, A. R., Bradley, D. D. C., Burroughes, J. H., Friend, R. H., Greenham, N. C., Burn, P. L., Holmes, A. B., & Kraft, A. (1992) · Applied Physics Letters · doi:10.1063/1.108094 · Cited by 672
Greenham, N. C., Friend, R. H., & Bradley, D. D. C. (1994) · Advanced Materials · doi:10.1002/adma.19940060612 · Cited by 575
Organic electroluminescent device having a hole conductor as an emitting layer
Adachi, C., Tsutsui, T., & Saito, S. (1989) · Applied Physics Letters · doi:10.1063/1.101586 · Cited by 553
Tamoto, N., Adachi, C., & Nagai, K. (1997) · Chemistry of Materials · doi:10.1021/cm960391+ · Cited by 307
Hoofman, R. J. O. M., de Haas, M. P., Siebbeles, L. D. A., & Warman, J. M. (1998) · Nature · doi:10.1038/32118 · Cited by 293
Use of poly(phenyl quinoxaline) as an electron transport material in polymer light-emitting diodes
O’Brien, D., Weaver, M. S., Lidzey, D. G., & Bradley, D. D. C. (1996) · Applied Physics Letters · doi:10.1063/1.117975 · Cited by 225
Polymers with Bipolar Carrier Transport Abilities for Light Emitting Diodes
Peng, Z., Bao, Z., & Galvin, M. E. (1998) · Chemistry of Materials · doi:10.1021/cm970698o · Cited by 161
Cacialli, F., Friend, R. H., Bouché, C.-M., Barny, P. L. L., Facoetti, H., Soyer, F., & Robin, P. (1998) · Journal of Applied Physics · doi:10.1063/1.366977 · Cited by 101
Jandke, M., Strohriegl, P., Berleb, S., Werner, E., & Brütting, W. (1998) · Macromolecules · doi:10.1021/ma9806054 · Cited by 97
Song, S.-Y., Jang, M., Shim, H., Hwang, D., & Zyung, T. (1999) · Macromolecules · doi:10.1021/ma981452n · Cited by 89
New Oxadiazole-Containing Conjugated Polymer for Single-Layer Light-Emitting Diodes
Peng, Z., & Zhang, J. (1999) · Chemistry of Materials · doi:10.1021/cm981087e · Cited by 88
Bao, Z., Peng, Z., Galvin, M. E., & Chandross, E. A. (1998) · Chemistry of Materials · doi:10.1021/cm970774n · Cited by 84
Blue-green organic light-emitting diodes based on fluorene-oxadiazole compounds
Antoniadis, H., Inbasekaran, M., & Woo, E. P. (1998) · Applied Physics Letters · doi:10.1063/1.122670 · Cited by 82
Enhanced efficiency of polymer light emitting diodes utilizing oxadiazole polymers
Karg, S., Rieß, W., Schwoerer, M., Buchwald, E., Meier, M., Pösch, P., Rieß, W., Schmidt, H., Strohriegl, P., & Schwoerer, M. (1995) · Advanced Materials · doi:10.1002/adma.19950071004 · Cited by 81
Polyquinoxaline as an excellent electron injecting material for electroluminescent device
Fukuda, T., Kanbara, T., Yamamoto, T., Ishikawa, K., Takezoe, H., & Fukuda, A. (1996) · Applied Physics Letters · doi:10.1063/1.115853 · Cited by 74
Meng, H., Yu, W., & Huang, W. (1999) · Macromolecules · doi:10.1021/ma9907439 · Cited by 73
Electron injection polymer for polymer light-emitting diodes
Yang, Y., & Pei, Q. (1995) · Journal of Applied Physics · doi:10.1063/1.359401 · Cited by 71
Cited by
Synthesis of Light-Emitting Conjugated Polymers for Applications in Electroluminescent Devices
Grimsdale, A. C., Leok Chan, K., Martin, R. E., Jokisz, P. G., & Holmes, A. B. (2009) · Chemical Reviews · doi:10.1021/cr000013v · Cited by 2,640
Electron Transport Materials for Organic Light-Emitting Diodes
Kulkarni, A. P., Tonzola, C. J., Babel, A., & Jenekhe, S. A. (2004) · Chemistry of Materials · doi:10.1021/cm049473l · Cited by 1,624
Polymers for flexible displays: From material selection to device applications
Choi, M.-C., Kim, Y., & Ha, C.-S. (2008) · Progress in Polymer Science · doi:10.1016/j.progpolymsci.2007.11.004 · Cited by 981
Metadata
- Authors
- Lee, Y.-Z., Chen, X., Chen, S.-A., Wei, P.-K., & Fann, W.-S.
- Venue
- Journal of the American Chemical Society
- Publisher
- American Chemical Society (ACS)
- Published
- 2001-02-14
- Volume
- 123
- Issue
- 10
- Pages
- 2296-2307
- ISSN
- 0002-7863 (ISSN-L)
- 1520-5126
- OpenAlex
- W2022321554
- Cited by
- 280
- References
- 25
- FWCI
- 15.89
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.