CoChat

Water-Based Dynamic Depsipeptide Chemistry: Building Block Recycling and Oligomer Distribution Control Using Hydration–Dehydration Cycles

Open access

The DOI matches its Crossref record; 55 of the 55 references it cites were found in a registry or an index.

Abstract

High Resolution Image Download MS PowerPoint Slide The high kinetic barrier to amide bond formation has historically placed narrow constraints on its utility in reversible chemistry applications. Slow kinetics has limited the use of amides for the generation of diverse combinatorial libraries and selection of target molecules. Current strategies for peptide-based dynamic chemistries require the use of nonpolar co-solvents or catalysts or the incorporation of functional groups that facilitate dynamic chemistry between peptides. In light of these limitations, we explored the use of depsipeptides: biorelevant copolymers of amino and hydroxy acids that would circumvent the challenges associated with dynamic peptide chemistry. Here, we describe a model system of N -(α-hydroxyacyl)-amino acid building blocks that reversibly polymerize to form depsipeptides when subjected to two-step evaporation–rehydration cycling under moderate conditions. The hydroxyl groups of these units allow for dynamic ester chemistry between short peptide segments through unmodified carboxyl termini. Selective recycling of building blocks is achieved by exploiting the differential hydrolytic lifetimes of depsipeptide amide and ester bonds, which we show are controllable by adjusting the solution pH, temperature, and time as well as the building blocks’ side chains. We demonstrate that the polymerization and breakdown of the depsipeptides are facilitated by cyclic morpholinedione intermediates, and further show how structural properties dictate half-lives and product oligomer distributions using multifunctional building blocks. These results establish a cyclic mode of ester-based reversible depsipeptide formation that temporally separates the polymerization and depolymerization steps for the building blocks and may have implications for prebiotic polymer chemical evolution.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1021/jacsau.2c00087

Cites

55 of 55 references verified0 citation errors · 0 not checkable

Statistics

Figures

Scheme 1 Reversible Depsipeptide Formation Enabled by Dry–Wet Cycling
Scheme 1 Reversible Depsipeptide Formation Enabled by Dry–Wet CyclingCC BY-NC-ND · PubMed Central
Figure 1 Depsipeptide formation following dry-heating and depsipeptide depolymerization (building block recycling) following a wet phase. (A) HPLC-UV chromatograms for building blocks dried from unbuffered solutions for 7 days at 65 °C to form depsipeptides. ″c(xX)″ denotes the 2,5-MD of a building block when observed. Numbers: polymer length, e.g., 4 = (gG)4. (B) Time-dependent recovery of building blocks gG, gA, aG, and aA during unbuffered (pH 3) aqueous incubations at 65 °C of 10 mM building block samples previously dried for 7 days at 65 °C.
Figure 1 Depsipeptide formation following dry-heating and depsipeptide depolymerization (building block recycling) following a wet phase. (A) HPLC-UV chromatograms for building blocks dried from unbuffered solutions for 7 days at 65 °C to form depsipeptides. ″c(xX)″ denotes the 2,5-MD of a building block when observed. Numbers: polymer length, e.g., 4 = (gG)4. (B) Time-dependent recovery of building blocks gG, gA, aG, and aA during unbuffered (pH 3) aqueous incubations at 65 °C of 10 mM building block samples previously dried for 7 days at 65 °C.CC BY-NC-ND · PubMed Central
Figure 2 Differential aqueous persistence of depsipeptide sequence motifs. (A) HPLC-UV chromatograms of a mixture of gG and aA (1:1 molar ratio) dried for 7 days at 65 °C, unbuffered (pH 3). (B) Abundances of the four possible 2-mers formed in panel A are shown following up to 10 days of 65 °C unbuffered wet-phase incubation. (C) Integrated absorbances over incubation time with each normalized to the respective initial integrated absorbances in panel B indicate xX-aA motif persistence over xX-gG.
Figure 2 Differential aqueous persistence of depsipeptide sequence motifs. (A) HPLC-UV chromatograms of a mixture of gG and aA (1:1 molar ratio) dried for 7 days at 65 °C, unbuffered (pH 3). (B) Abundances of the four possible 2-mers formed in panel A are shown following up to 10 days of 65 °C unbuffered wet-phase incubation. (C) Integrated absorbances over incubation time with each normalized to the respective initial integrated absorbances in panel B indicate xX-aA motif persistence over xX-gG.CC BY-NC-ND · PubMed Central
Figure 3 Structural factors influence building block polymerization and breakdown. (A) Time-dependent comparison of building block conversion to depsipeptides between gA and gβA, which can in principle form six- and seven-atom rings upon dehydration, respectively. Dashed lines were added to guide the eye. Bars: SD; n = 2. (B) Standards (gA)2 and (PA)AgA subject to pH 6, 65 °C aqueous incubation. (C) Structures of molecules used in panel B depicting depolymerization routes.
Figure 3 Structural factors influence building block polymerization and breakdown. (A) Time-dependent comparison of building block conversion to depsipeptides between gA and gβA, which can in principle form six- and seven-atom rings upon dehydration, respectively. Dashed lines were added to guide the eye. Bars: SD; n = 2. (B) Standards (gA)2 and (PA)AgA subject to pH 6, 65 °C aqueous incubation. (C) Structures of molecules used in panel B depicting depolymerization routes.CC BY-NC-ND · PubMed Central
Scheme 2 Bifunctional Building Blocks Allow for Variations in Depsipeptide Regiochemistry
Scheme 2 Bifunctional Building Blocks Allow for Variations in Depsipeptide RegiochemistryCC BY-NC-ND · PubMed Central
Figure 4 pH-controlled selectivity for side-chain-linked depsipeptides using bifunctional building blocks. (A) aD dry–wet cycled in pH 5.5 TEAOAc showed comparable abundances of both (aD)2 isomers formed following 24 h dry-heating phases (orange traces) and preferential preservation of β-(aD)2 following 18 h wet phases (blue traces). Peaks labeled [D/a(aD)2] displayed a mass consistent with a dehydration product from D/a + (aD)2. A stack plot of the chromatograms in panel A is provided in Figure S22 for clarity. (B) Integrated abundances of (aD)2 regioisomers and higher-order oligomer peaks (total integrated areas) from panel A over cycling time. Yellow regions indicate drying and heating at 75 °C (24 h). Blue regions indicate rehydration and incubation in the solution state at 65 °C (18 h). (C) Alignment with synthetic standards of α- and β-(aD)2 confirms regioisomer identities.
Figure 4 pH-controlled selectivity for side-chain-linked depsipeptides using bifunctional building blocks. (A) aD dry–wet cycled in pH 5.5 TEAOAc showed comparable abundances of both (aD)2 isomers formed following 24 h dry-heating phases (orange traces) and preferential preservation of β-(aD)2 following 18 h wet phases (blue traces). Peaks labeled [D/a(aD)2] displayed a mass consistent with a dehydration product from D/a + (aD)2. A stack plot of the chromatograms in panel A is provided in Figure S22 for clarity. (B) Integrated abundances of (aD)2 regioisomers and higher-order oligomer peaks (total integrated areas) from panel A over cycling time. Yellow regions indicate drying and heating at 75 °C (24 h). Blue regions indicate rehydration and incubation in the solution state at 65 °C (18 h). (C) Alignment with synthetic standards of α- and β-(aD)2 confirms regioisomer identities.CC BY-NC-ND · PubMed Central
Figure 5 Hydroxy acid side chain size dictates native α-depsipeptide selectivity. Unbuffered 7 day, 65 °C drying of xD and xE building blocks showing 2-mers and percent α-linkage by integration. The α and γ regioisomers of (gE)2 appear to overlap; thus, their relative abundances are indeterminate. Hydroxy acid side chains are shown in each panel. The identities of the α- and γ-linked 2-mers of fE were determined using synthetic standards (Figure S26), while the 2-mers of fD were identified using an α-linked standard and by analysis of the degradation profile of the 2-mers (Figures S26–S27). fD and fE samples underwent drying with 1 equiv of 2-hydroxypyridine to prevent precipitation (Figure S28).
Figure 5 Hydroxy acid side chain size dictates native α-depsipeptide selectivity. Unbuffered 7 day, 65 °C drying of xD and xE building blocks showing 2-mers and percent α-linkage by integration. The α and γ regioisomers of (gE)2 appear to overlap; thus, their relative abundances are indeterminate. Hydroxy acid side chains are shown in each panel. The identities of the α- and γ-linked 2-mers of fE were determined using synthetic standards (Figure S26), while the 2-mers of fD were identified using an α-linked standard and by analysis of the degradation profile of the 2-mers (Figures S26–S27). fD and fE samples underwent drying with 1 equiv of 2-hydroxypyridine to prevent precipitation (Figure S28).CC BY-NC-ND · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 55 references

Cited by

See all 22

Metadata

Authors
C, M., Frenkel-Pinter, M., Smith, K. H., Rivera-Santana, V. F., Sargon, A. B., Jacobson, K. C., Guzman-Martinez, A., Williams, L. D., Leman, L. J., Liotta, C. L., Grover, M. A., & Hud, N. V.
Affiliations
  • NSF/NASA Center for Chemical Evolution, Atlanta, Georgia 30332, United States
  • Georgia Institute of Technology (US)
  • University of Puerto Rico-Mayaguez (PR)
  • Department of Chemistry, University of Puerto Rico, Mayagüez, Puerto Rico 00681, United States
  • Scripps Research Institute (US)
Corresponding author
Hud, Nicholas V.
Venue
JACS Au
Published
2022-05-17
Volume
2
Issue
6
Pages
1395-1404
ISSN
2691-3704 (ISSN-L)
OpenAlex
W4280589729
Cited by
22
References
54
Citations by year
2026: 8 · 2025: 7 · 2024: 2 · 2023: 4 · 2022: 1
FWCI
1.14
Type
journal article
Language
en
Open access
Locations
  • JACS Au (publishedVersion, cc-by-nc-nd)
  • PubMed Central (publishedVersion, cc-by-nc-nd)
  • PubMed (publishedVersion)
Funders
  • Division of Chemistry (CHE-1504217)
  • National Aeronautics and Space Administration
Topics
  • Physical Sciences › Chemistry › Organic Chemistry › Chemical Synthesis and Analysis
  • Physical Sciences › Chemistry › Organic Chemistry › Advanced Polymer Synthesis and Characterization
  • Physical Sciences › Chemistry › Organic Chemistry › Supramolecular Chemistry and Complexes
Keywords
depsipeptides, dynamic covalent chemistry, ester hydrolysis, reversible polymerization

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Water-Based Dynamic Depsipeptide Chemistry: Building Block Recycling and Oligomer Distribution Control Using Hydration–Dehydration Cycles. https://app.cochat.ai/papers/10.1021/jacsau.2c00087
The paper
C, M., Frenkel-Pinter, M., Smith, K. H., Rivera-Santana, V. F., Sargon, A. B., Jacobson, K. C., Guzman-Martinez, A., Williams, L. D., Leman, L. J., Liotta, C. L., Grover, M. A., & Hud, N. V. (2022). Water-Based Dynamic Depsipeptide Chemistry: Building Block Recycling and Oligomer Distribution Control Using Hydration–Dehydration Cycles. JACS Au. https://doi.org/10.1021/jacsau.2c00087

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.