The DOI matches its Crossref record.
Mixed Micelle Formation and Solubilization Behavior toward Polycyclic Aromatic Hydrocarbons of Binary and Ternary Cationic−Nonionic Surfactant Mixtures
Abstract
Water solubility enhancements of polycyclic aromatic hydrocarbons (PAHs), viz., naphthalene, anthracene and pyrene, by micellar solutions at 25 degrees C using two series of surfactants, each involving two cationic and one nonionic surfactant in their single as well as equimolar binary and ternary mixed states, were measured and compared. The first series was composed of three surfactants, benzylhexadecyldimethylammonium chloride (C16BzCl), hexadecyltrimethylammonium bromide (C16Br), and polyoxyethylene(20)mono-n-hexadecyl ether (Brij-58) with a 16-carbon (C16) hydrophobic chain; the second series consisted of dodecyltrimethylammonium bromide (C12Br), dodecylethyldimethylammonium bromide (C12EBr), and polyoxyethylene(4)mono-n-dodecyl ether (Brij-30) with a 12-carbon (C12) chain. Solubilization capacity has been quantified in terms of the molar solubilization ratio, the micelle-water partition coefficient, the first stepwise association constant between solubilizate monomer and vacant micelle, and the average number of solubilizate molecules per micelle, determined employing spectrophoto-, tensio-, and flourimetric techniques. Cationic surfactants exhibited lesser solubilization capacity than nonionics in each series of surfactants with higher efficiency in the C16 series compared to the C12 series. Increase in hydrophobicity of head groups of cationics by incorporation of ethyl or benzyl groups enhanced their solubilization capacity. The mixing effect of surfactants on mixed micelle formation and solubilization efficiency has been discussed in light of the regular solution approximation (RSA). Cationic-nonionic binary combinations showed better solubilization capacity than pure cationics, nonionics, or cationic-cationic mixtures, which, in general, showed increase with increased hydrophobicity of PAHs. Equimolar cationic-cationic-nonionic ternary surfactant systems showed lower solubilization efficiency than their binary cationic-nonionic counterparts but higher than cationic-cationic ones. In addition, use of RSA has been extended, with fair success, to predict partition coefficients of ternary surfactant systems using data of binary surfactants systems. Mixed surfactants may improve the performance of surfactant-enhanced remediation of soils and sediments by decreasing the applied surfactant level and thus remediation cost.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
A Review of Polymeric Micelles and Their Applications
Perumal, S., Atchudan, R., & Lee, W. (2022) · Polymers · doi:10.3390/polym14122510 · Cited by 390
Solubilization of Hydrophobic Dyes in Surfactant Solutions
Tehrani-Bagha, A., & Holmberg, K. (2013) · Materials · doi:10.3390/ma6020580 · Cited by 287
Mir, M. A., Chat, O. A., Najar, M. H., Younis, M., Dar, A. A., & Rather, G. M. (2011) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2011.07.093 · Cited by 31
Self-citation
Metadata
- Authors
- Dar, A. A., Rather, G. M., & Das, A. R.
- Venue
- The Journal of Physical Chemistry B
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-03-01
- Volume
- 111
- Issue
- 12
- Pages
- 3122-3132
- ISSN
- 1520-5207 (ISSN-L)
- 1520-6106
- OpenAlex
- W1993983125
- Cited by
- 179
- References
- 0
- FWCI
- 5.54
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.