The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
Effect of Digestion Time and Alkali Addition Rate on Physical Properties of Magnetite Nanoparticles
Abstract
We investigate the effect of digestion time and alkali addition rate on the size and magnetic properties of precipitated magnetite nanoparticles. It is observed that the time required to complete the growth process for magnetite nanocrystals is very short (approximately 300 s), compared to long digestion times (20-190 min) required for MnO and CdSe nanocrystals. The rapid growth of magnetite nanoparticles suggests that Oswald ripening is insignificant during the precipitation stage, due to the low solubility of the oxides and the domination of a solid-state reaction where high electron mobility between Fe2+ and Fe3+ ions drives a local cubic close-packed ordering. During the growth stage (0-300 s), the increase in the particle size is nominal (6.7-8.2 nm). The effect of alkali addition rate on particle size reveals that the nanocrystal size decreases with increasing alkali addition rate. The particle size decreases from 11 to 6.8 nm as the alkali addition rate is increased from 1 to 80 mL/s. During the size decrease, the lattice parameter decreases from 0.838 to 0.835 nm, which is attributed to an increase in the amount of Fe3+ atoms at the surface due to oxidation. As the alkali addition rate increases, the solution reaches supersaturation state rapidly leading to the formation of large number of initial nuclei at the nucleation stage, resulting in large number of particles with smaller size. When alkali addition rate is increased from 1 to 80 mL/s, the saturation magnetization of the particles decreases from 60 to 46 emu/g due to the reduced particle size.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Monodisperse FePt Nanoparticles and Ferromagnetic FePt Nanocrystal Superlattices
Sun, S., Murray, C. B., Weller, D., Folks, L., & Moser, A. (2000) · Science · doi:10.1126/science.287.5460.1989 · Cited by 6,137
Peng, X., Wickham, J., & Alivisatos, A. P. (1998) · Journal of the American Chemical Society · doi:10.1021/ja9805425 · Cited by 1,895
Sugimoto, T. (2000) · Colloids and Surfaces A: Physicochemical and Engineering Aspects · doi:10.1016/s0927-7757(99)00366-0 · Cited by 120
Cited by
Rajput, S., Pittman, C. U., & Mohan, D. (2016) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2015.12.008 · Cited by 746
Functionalisation of nanoparticles for biomedical applications
Thanh, N. T. K., & Green, L. A. W. (2010) · Nano Today · doi:10.1016/j.nantod.2010.05.003 · Cited by 705
Mascolo, M., Pei, Y., & Ring, T. (2013) · Materials · doi:10.3390/ma6125549 · Cited by 620
Pereira, C., Pereira, A. M., Fernandes, C., Rocha, M., Mendes, R., Fernández-García, M. P., Guedes, A., Tavares, P. B., Grenèche, J.-M., Araújo, J. P., et al. (2012) · Chemistry of Materials · doi:10.1021/cm300301c · Cited by 518
Review on thermal properties of nanofluids: Recent developments
Angayarkanni, S. A., & Philip, J. (2015) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2015.08.014 · Cited by 492
Self-citation
Metadata
- Authors
- Gnanaprakash, G., Philip, J., Jayakumar, T., & Raj, B.
- Venue
- The Journal of Physical Chemistry B
- Publisher
- American Chemical Society (ACS)
- Published
- 2007-06-20
- Volume
- 111
- Issue
- 28
- Pages
- 7978-7986
- ISSN
- 1520-5207 (ISSN-L)
- 1520-6106
- OpenAlex
- W2033030812
- Cited by
- 171
- References
- 3
- FWCI
- 6.40
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.