CoChat

Surface Properties of Pt and PtCo Electrocatalysts and Their Influence on the Performance and Degradation of High-Temperature Polymer Electrolyte Fuel Cells

Salvatore Aricò, Antonino, Stassi, Alessandro, Gatto, Irene, Monforte, Giuseppe, Passalacqua, Enza, Antonucci, Vincenzo · 2010 · The Journal of Physical Chemistry C

The DOI matches its Crossref record; 58 of the 58 references it cites were found in a registry or an index.

Abstract

An investigation of the behavior of carbon-supported Pt and PtCo cathode electrocatalysts was carried out with the aim to evaluate their performance and resistance to degradation under high temperature (110−130 °C) operation in a polymer electrolyte membrane fuel cell (PEMFC) based on a new ionomer membrane (Aquivion). Nanosized Pt and PtCo catalysts with similar crystallite size (2.7−2.9 nm) were prepared by using a colloidal route. A suitable degree of alloying and a face-centered-cubic (fcc) structure were obtained for the PtCo catalysts by using a carbothermal reduction. The surface properties were investigated by X-ray photoelectron spectroscopy (XPS) and low-energy ion scattering spectroscopy (LE-ISS, 3 He + at 1 kV). The formation of a Pt skin layer on the surface of the alloy electrocatalyst was obtained by using a preleaching procedure. Furthermore, the amount of Pt oxides on outermost atomic layers was much smaller in the PtCo than in the Pt catalyst. These characteristics appeared to influence catalysts’ performance and degradation. Accelerated tests (electrochemical cycling) at 130 °C in a pressurized PEMFC showed a better stability for the PtCo alloy as compared to Pt. Furthermore, better performance was obtained at high temperatures for the preleached PtCo/C as compared to the Pt/C cathode catalyst. At a moderate pressure of 1.5 bar (abs), maximum power densities of 800 and 700 mW cm −2 at 110 °C (H 2 −O 2 ) were achieved for the PtCo cathode with 50% and 25% relative humidity (RH), respectively, by using 0.3 mg Pt cm −2 loading. At high pressure of 3 bar (abs), a maximum power density exceeding 1000 mW cm −2 was obtained at 130 °C and 100% RH.

Overview

Integrity signals

Registry

Crossref · 10.1021/jp104528q

Cites

58 of 58 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Citations

Cites

Show all 58 references

Research works printed but not linked: 6

  1. Ren, X.; Sringer, T. E.; Gottesfeld, S.InProton Conducting Membrane Fuel Cells - Second International Symposium;Gottesfeld, S.; Fuller, T. F., Eds.The Electrochemical Society:Pennington, NJ, 1999; Vol. 98-27, p341.
  2. Zinola C. F., 1994, J. Appl. Electrochem., 24, 119
  3. Zhang J., 2005, Angew. Chem., Int. Ed., 44, 2
  4. Jaffray, C.; Hards, G. A.InHandbook of Fuel Cells—Fundamentals, Technology and Applications;Vielstich, W.; Lamm, A.; Gasteiger, H., Eds.Wiley:Chichester, UK, 2003; Vol. 3, Chapter 41, p509.
  5. Mukerjee, S.; Srinivasan, S.InHandbook of Fuel Cells—Fundamentals, Technology and Applications;Vielstich, W.; Lamm, A.; Gasteiger, H., Eds.Wiley:Chichester, UK, 2003; Vol. 2,Chapter 34, p502.
  6. Thompsett, D.InHandbook of Fuel Cells—Fundamentals, Technology and Applications;Vielstich, W.; Gasteiger, H.; Lamm, A., Eds.Wiley:Chichester, UK, 2003; Vol. 3,Chapter 37, p467.

Cited by

See all 59

Metadata

Authors
Salvatore Aricò, A., Stassi, A., Gatto, I., Monforte, G., Passalacqua, E., & Antonucci, V.
Affiliations
  • Istituto di Tecnologie Avanzate per l’Energia “Nicola Giordano”-CNR-ITAE, Via Salita S. Lucia sopra Contesse 5, 98126 Messina, Italy
  • Institute for Advanced Energy Technologies (IT)
Venue
The Journal of Physical Chemistry C
Published
2010-08-30
Volume
114
Issue
37
Pages
15823-15836
ISSN
  • 1932-7447 (ISSN-L)
  • 1932-7455
OpenAlex
W2024222031
Cited by
59
References
57
Citations by year
2026: 2 · 2025: 1 · 2022: 5 · 2021: 2 · 2020: 4 · 2019: 1 · 2018: 2 · 2017: 2 · 2016: 4 · 2015: 8 · 2014: 8 · 2013: 7 · 2012: 10
FWCI
5.04
Type
journal article
Language
en
Open access
closed
Locations
  • The Journal of Physical Chemistry C (publishedVersion)
  • CNR ExploRA (submittedVersion)
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Fuel Cells and Related Materials
  • Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
  • Physical Sciences › Materials Science › Materials Chemistry › Catalytic Processes in Materials Science
Keywords
platinum electrocatalysts, high-temperature polymer electrolyte fuel cells, catalyst deactivation, surface properties, carbothermal reduction, colloidal synthesis, oxygen reduction reaction, cathode catalysts, low-energy ion scattering, X-ray photoelectron spectroscopy

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.