The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Surface Speciation Models of Calcite and Dolomite/Aqueous Solution Interfaces and Their Spectroscopic Evaluation
Abstract
The composition and density of surface hydroxyl and carbonate groups on calcite and dolomite after contact at 25 °C with solutions of different pH (3 to 12) and carbonate concentration (10 - 4 ≤ ∑CO 2 ≤ 0.1 M) were monitored by means of diffuse reflectance infrared (DRIFT) spectroscopy. Both for calcite and dolomite, broad high-intensity absorbance bands at about 3400 and 1600 cm - 1 were observed at pH below 6 and carbonate concentration below 10 - 3 M. These bands are assigned to hydroxyl groups present at the mineral surfaces. At higher pH and ∑CO 2, the intensity of these bands significantly decreases. On the contrary the intensity of the broad double band at about 1400 cm - 1 due to carbonate species (surface and bulk) for both minerals was found to increase significantly with increasing solution pH and carbonate concentration, being the lowest at pH ≤ 5 and ∑CO 2 ≤ 10 - 3 M. These observations correlate well with the surface speciation for calcite or dolomite/aqueous solution interface predicted based on surface complexation models (SCM). These models were proposed based on the electrokinetics and surface titration experimental results and they postulate the formation of >CaOH 2 +, >MgOH 2 +, >CaHCO 3 o, >MgHCO 3 o, >CaCO 3 -, >MgCO 3 -, >CO 3 Ca +, >CO 3 Mg +, and >CO 3 - surface species from two primary hydration sites, >CaOH o (>MgOH o ) and >CO 3 H o . Very good relationships were found between the predicted concentration of the surface OH groups (>MeOH 2 + ) and the measured density of the surface hydroxyl groups corresponding to a band at around 3400 cm - 1 . Moreover, the experimental ratio of band intensities I 3400 / I 1420 (OH/CO 3 ) was found to correlate well with the predicted concentration ratio of the adsorbed surface hydroxyl and carbonate groups, {>MeOH 2 + }/{>MeHCO 3 o + >MeCO 3 - }. External addition of Mg 2+ or Ca 2+ ions to alkaline dolomite suspensions leads to an increase of the surface density of the OH groups. This increase is explained, in accordance with the SCM, by the formation of >CO 3 Me + × n H 2 O outer sphere species that yield an increase of surface adsorbed water.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Pokrovsky, O. S., & Schott, J. (1999) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(99)00013-7 · Cited by 153
Teng, H. H., & Dove, P. M. (1997) · American Mineralogist · doi:10.2138/am-1997-9-1005 · Cited by 122
Cited by
The Link Between Mineral Dissolution/Precipitation Kinetics and Solution Chemistry
Schott, J., Pokrovsky, O. S., & Oelkers, E. H. (2009) · Reviews in Mineralogy and Geochemistry · doi:10.2138/rmg.2009.70.6 · Cited by 414
Self-citationMineral–water interfacial structures revealed by synchrotron X-ray scattering
Fenter, P., & Sturchio, N. C. (2004) · Progress in Surface Science · doi:10.1016/j.progsurf.2004.12.001 · Cited by 392
Zeta potential of artificial and natural calcite in aqueous solution
Al Mahrouqi, D., Vinogradov, J., & Jackson, M. D. (2017) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2016.12.006 · Cited by 377
Surface Chemistry and Dissolution Kinetics of Divalent Metal Carbonates
Pokrovsky, O. S., & Schott, J. (2002) · Environmental Science & Technology · doi:10.1021/es010925u · Cited by 336
Self-citationStructure and reactivity of the calcite–water interface
Heberling, F., Trainor, T. P., Lützenkirchen, J., Eng, P., Denecke, M. A., & Bosbach, D. (2011) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2010.10.047 · Cited by 303
Metadata
- Authors
- Pokrovsky, O. S., Mielczarski, J. A., Barres, O., & Schott, J.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2000-01-25
- Volume
- 16
- Issue
- 6
- Pages
- 2677-2688
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2000698443
- Cited by
- 216
- References
- 2
- FWCI
- 5.81
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.