The DOI matches its Crossref record.
Scaling Laws in Electrospinning of Polystyrene Solutions
Abstract
By tuning the processing variables and solution properties using four different solvents (dimethylformamide, o -dichlorobeneze, tetrahydrofuran, and chloroform), polystyrene (PS) fibers were prepared by the electrospinning process to study the effects of these governing parameters on the morphological changes of the charged cone and jet, as well as the diameter and birefringence of the fibers collected. Both jet diameter ( d j ) and fiber diameter ( d f ) were scaled with the processing variables, i.e., solution flow-rate ( Q ), applied voltage ( V ) and working distance ( H ), with a power law model. Knowledge of these exponents provided insight into how to manipulate the electrified jet and spun fibers for a given solution. Results showed that Q was the dominant factor in determining the fiber diameter and the Q dependences of d j and d f were approximately scaled with: d j ∼ Q 0.5 and d f ∼ Q 0.25 . The applied electric field ( V / H ) did affect the cone volume and the length of the electrified jet. Either increasing V or decreasing H produced a slightly thinner jet and smaller fiber, but the effects were not significant due to the limited processing range available for the stable cone-jet mode, and the nonuniformity of the electric field resulting from the point-to-plate electrode configuration used in this study. Regardless of the variations of the processing variables ( Q, V, and H ), a master curve between d j and d f was found for a solution with fixed properties, from which a simple equation was obtained and expressed by: d f ∼ md j 0.45 where m was a prefactor depending upon solution properties, such as the viscosity (η ο ), conductivity (κ) and surface tension. Values of m were found to be lower for solutions with lower viscosity and/or higher conductivity, and were successfully scaled to be as follows: m ∼ η o 0.38 κ -0.12 . As far as the solution properties were concerned, the concentration emerged as the most important parameter because of its interaction with all aspects of the electrospinning process. The rheological properties of the polymer solution showed a significant effect on the formation of smooth electrospun fibers. On the basis of the Graessley's concentration-molecular weight diagram, various PS fiber morphologies were discussed and the minimum polymer concentration at a given polymer molecular weight required for preparing smooth PS fibers could be estimated. For the present PS solutions, a scaling law was found between the fiber diameter and solution viscosity: d f ∼ η o 0.41, if other governing parameters ( Q, V, H, κ, and surface tension) were fixed.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Zhang, B., Kang, F., Tarascon, J.-M., & Kim, J.-K. (2016) · Progress in Materials Science · doi:10.1016/j.pmatsci.2015.08.002 · Cited by 720
Electrospinning of uniform polystyrene fibers: The effect of solvent conductivity
Uyar, T., & Besenbacher, F. (2008) · Polymer · doi:10.1016/j.polymer.2008.09.025 · Cited by 434
Electrospun nanocomposites from polystyrene loaded with cellulose nanowhiskers
Rojas, O. J., Montero, G. A., & Habibi, Y. (2009) · Journal of Applied Polymer Science · doi:10.1002/app.30011 · Cited by 198
Metadata
- Authors
- Wang, C., Hsu, C.-H., & Lin, J.-H.
- Venue
- Macromolecules
- Publisher
- American Chemical Society (ACS)
- Published
- 2006-10-01
- Volume
- 39
- Issue
- 22
- Pages
- 7662-7672
- ISSN
- 0024-9297 (ISSN-L)
- 1520-5835
- OpenAlex
- W2133104427
- Cited by
- 189
- References
- 0
- FWCI
- 4.89
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.