The DOI matches its Crossref record.
Synthesis, Characterization, and Carbon Dioxide Adsorption of Covalently Attached Polyethyleneimine-Functionalized Single-Wall Carbon Nanotubes
Abstract
The reaction between fluorinated single-wall carbon nanotubes (F-SWNTs) and branched (M(w) = 600, 1800, 10000, and 25000 Da) or linear (M(w) = 25000 Da) polyethyleneimine (PEI) yields the covalent attachment of the polymer to the sidewalls of the nanotubes. The resulting PEI-functionalized SWNTs (PEI-SWNTs) were characterized by solid-state (13)C NMR, Raman spectroscopy, X-ray photoelectron spectroscopy, UV-vis spectroscopy, atomic force microscopy, transmission electron microscopy, and thermal gravimetric analysis studies. As expected, the number of polymer molecules per SWNT is larger for low molecular weight PEI than for high molecular weight PEI. However, above 1800 Da, the number of polymer molecules per SWNT does not vary as much. This is supported by Raman spectral data that shows the D:G ratio is relatively insensitive of the molecular weight for M(w) > 1800 Da. The PEI-SWNTs are shown to have solubility in aqueous media of up to 0.4 mg x mL(-1). Solid-state (13)C NMR shows the presence of carboxylate substituents that have been attributed to carbamate formation as a consequence of the reversable CO(2) absorption to the primary amine substituents of the PEI. Desorption of CO(2) is accomplished by heating under argon at 75 degrees C, while the dependence of the quantity of CO(2) absorbed on temperature and the molecular weight of the PEI is reported. Under the conditions investigated the maximum absorption of 9.2% w/w is observed for PEI(25000)-SWNT at 27 degrees C. The possible CO(2) absorption applications of the PEI-SWNTs is discussed.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Adsorbent Materials for Carbon Dioxide Capture from Large Anthropogenic Point Sources
Choi, S., Drese, J. H., & Jones, C. W. (2009) · ChemSusChem · doi:10.1002/cssc.200900036 · Cited by 2,596
Post-Combustion CO 2 Capture Using Solid Sorbents: A Review
Samanta, A., Zhao, A., Shimizu, G. K. H., Sarkar, P., & Gupta, R. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie200686q · Cited by 1,889
Ben-Mansour, R., Habib, M. A., Bamidele, O. E., Basha, M., Qasem, N. A. A., Peedikakkal, A., Laoui, T., & Ali, M. (2016) · Applied Energy · doi:10.1016/j.apenergy.2015.10.011 · Cited by 722
Carbon‐Nanotube‐Based Thermoelectric Materials and Devices
Blackburn, J. L., Ferguson, A. J., Cho, C., & Grunlan, J. C. (2018) · Advanced Materials · doi:10.1002/adma.201704386 · Cited by 684
Hao, G.-P., Li, W.-C., Qian, D., Wang, G.-H., Zhang, W.-P., Zhang, T., Wang, A.-Q., Schüth, F., Bongard, H.-J., & Lu, A.-H. (2011) · Journal of the American Chemical Society · doi:10.1021/ja203857g · Cited by 569
Metadata
- Authors
- Dillon, E. P., Crouse, C. A., & Barron, A. R.
- Venue
- ACS Nano
- Publisher
- American Chemical Society (ACS)
- Published
- 2008-01-04
- Volume
- 2
- Issue
- 1
- Pages
- 156-164
- ISSN
- 1936-0851 (ISSN-L)
- 1936-086X
- OpenAlex
- W1982807435
- Cited by
- 225
- References
- 0
- FWCI
- 4.72
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Synthesis, Characterization, and Carbon Dioxide Adsorption of Covalently Attached Polyethyleneimine-Functionalized Single-Wall Carbon Nanotubes. https://app.cochat.ai/papers/10.1021/nn7002713
- The paper
- Dillon, E. P., Crouse, C. A., & Barron, A. R. (2008). Synthesis, Characterization, and Carbon Dioxide Adsorption of Covalently Attached Polyethyleneimine-Functionalized Single-Wall Carbon Nanotubes. ACS Nano. https://doi.org/10.1021/nn7002713
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.