The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Numerical simulations of granular shear zones using the distinct element method: 2. Effects of particle size distribution and interparticle friction on mechanical behavior
Open accessAbstract
Two dimensional (2‐D) numerical simulations were conducted using the distinct element method (DEM) to explore the influences of particle size distribution (PSD), defined by 2‐D power law exponent D, and of interparticle friction μp on mechanical behavior and strength of granular shear zones. The value of D ranged from 0.81 (a coarse breccia) to 2.60 (fine‐grained gouge); μp was assigned to 0.10, 0.50, or 0.75; normal stresses on the shear zone walls, σn, varied from 40 to 140 MPa; assemblages were sheared to 200% strain. Fault friction, defined as the ratio of shear to normal stress, μf = τ/σn, was quite low for all experiments. Low μp suites yielded μf ≈ 0.20–0.25, while higher μp values resulted in only slightly higher values for μf ≈ 0.25–32. The stress‐strain response of the latter experiments was similar to that of overconsolidated granular assemblages: a peak strength was reached by about 10% strain, followed by a period of strain weakening to 30–50% strain, and finally stabilizing at a residual strength for the rest of the experiment. The transitional phases were accompanied by increasing shear zone dilation of up to about 1.5%. The low μp suites behaved more as normally consolidated assemblages; they showed no noticeable strain weakening and relatively minor dilation of about 0.2%. The anomalously low strengths of the simulated assemblages can be explained largely by high degrees of particle rolling. Periodic drops in shear strength during residual deformation phase of the experiments correlated directly with reduced rates of dilation and the localization of strain. Fault strength also showed second‐order variations with D: the low μp suites showed a steady decline in maximum residual strength μfmax with increasing D due to the importance of interparticle sliding in all configurations; in the higher μp suites, μfmax decreased for D values less than a characteristic value of 1.60, then leveled out for increasing D. This may be explained by the increasing importance of particle rolling as small particles became more abundant with increasing D; the particles began to self‐organize and strain became more localized. Although the simulations lack particle fracture, they offer insight into how micromechanics control the mechanical evolution of granular shear zones.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A discrete numerical model for granular assemblies
Cundall, P. A., & Strack, O. D. L. (1979) · Géotechnique · doi:10.1680/geot.1979.29.1.47 · Cited by 17,527
Cited by
Rheophysics of dense granular materials: Discrete simulation of plane shear flows
da Cruz, F., Emam, S., Prochnow, M., Roux, J.-N., & Chevoir, F. (2005) · Physical Review E · doi:10.1103/physreve.72.021309 · Cited by 1,321
Ben‐Zion, Y. (2008) · Reviews of Geophysics · doi:10.1029/2008rg000260 · Cited by 493
Billi, A., Salvini, F., & Storti, F. (2003) · Journal of Structural Geology · doi:10.1016/s0191-8141(03)00037-3 · Cited by 355
Morgan, J. K., & Boettcher, M. S. (1999) · Journal of Geophysical Research: Solid Earth · doi:10.1029/1998jb900056 · Cited by 269
Self-citation
Metadata
- Authors
- Morgan, J. K.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1999-02-10
- Volume
- 104
- Issue
- B2
- Pages
- 2721-2732
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2068968988
- Cited by
- 186
- References
- 1
- FWCI
- 8.28
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Numerical simulations of granular shear zones using the distinct element method: 2. Effects of particle size distribution and interparticle friction on mechanical behavior. https://app.cochat.ai/papers/10.1029/1998jb900055
- The paper
- Morgan, J. K. (1999). Numerical simulations of granular shear zones using the distinct element method: 2. Effects of particle size distribution and interparticle friction on mechanical behavior. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/1998jb900055
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.