Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 264

The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.

On relating apparent stress to the stress causing earthquake fault slip

McGarr, A.·1999·Journal of Geophysical Research: Solid Earth

Abstract

Apparent stress τa is defined as , where is the average shear stress loading the fault plane to cause slip and η is the seismic efficiency, defined as E a/ W, where E a is the energy radiated seismically and W is the total energy released by the earthquake. The results of a recent study in which apparent stresses of mining‐induced earthquakes were compared to those measured for laboratory stick‐slip friction events led to the hypothesis that . This hypothesis is tested here against a substantially augmented data set of earthquakes for which can be estimated, mostly from in situ stress measurements, for comparison with τa. The expanded data set, which includes earthquakes artificially triggered at a depth of 9 km in the German Kontinentales Tiefbohrprogramm der Bundesrepublik Deutschland (KTB) borehole and natural tectonic earthquakes, covers a broad range of hypocentral depths, rock types, pore pressures, and tectonic settings. Nonetheless, over ∼14 orders of magnitude in seismic moment, apparent stresses exhibit distinct upper bounds defined by a maximum seismic efficiency of ∼0.06, consistent with the hypothesis proposed before. This behavior of τa and η can be expressed in terms of two parameters measured for stick‐slip friction events in the laboratory: the ratio of the static to the dynamic coefficient of friction and the fault slip overshoot. Typical values for these two parameters yield seismic efficiencies of ∼0.06. In contrast to efficiencies for laboratory events for which η is always near 0.06, those for earthquakes tend to be less than this bounding value because E a for earthquakes is usually underestimated due to factors such as band‐limited recording. Thus upper bounds on appear to be controlled by just a few fundamental aspects of frictional stick‐slip behavior that are common to shallow earthquakes everywhere. Estimates of from measurements of τa for suites of earthquakes, using , are found to be comparable in magnitude to estimates of shear stress on the basis of extrapolating in situ stress data to seismogenic depths.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/1998jb900083

Cites

24 of 24 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 24 references

Cited by

See all 264

Metadata

Authors
McGarr, A.
Venue
Journal of Geophysical Research: Solid Earth
Published
1999-02-10
Volume
104
Issue
B2
Pages
3003-3011
ISSN
0148-0227 (ISSN-L)
OpenAlex
W2010182219
Cited by
264
References
24
FWCI
8.02
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: On relating apparent stress to the stress causing earthquake fault slip. https://app.cochat.ai/papers/10.1029/1998jb900083
The paper
McGarr, A. (1999). On relating apparent stress to the stress causing earthquake fault slip. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/1998jb900083

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.