Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 228

The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.

Harzburgite melting with and without H2O: Experimental data and predictive modeling

Open access
Parman, Stephen W., Grove, Timothy L. · 2004 · Journal of Geophysical Research: Solid Earth

Abstract

The effect of H 2 O on harzburgite‐saturated melts has been quantified with a series of hydrous and anhydrous melting experiments using a piston‐cylinder device. Experimental conditions were 1.2–2.2 GPa and 1175–1500°C. Melt H 2 O contents range from 0 to 10 wt %. The effects of temperature, pressure, and bulk composition (including H 2 O) on the SiO 2 content of the experimental melts have been evaluated using SiO 2 activity coefficients. The results suggest a two‐lattice‐type model for the melt phase in which H 2 O mixes nearly ideally with other network modifiers (MgO, FeO, etc.) but does not mix on the network‐forming lattice site and so has little effect on SiO 2 activity coefficients. The effect of H 2 O on SiO 2 activity is too small to produce the high SiO 2 contents observed in mafic andesite magmas. It is proposed that the SiO 2‐rich character of hydrous, subduction‐related magmas is the result of the low temperatures at which hydrous melting occurs relative to anhydrous melting. Partition coefficients for MgO and FeO increase at lower temperatures, while the partition coefficient for SiO 2 is nearly constant and is buffered by olivine‐orthopyroxene equilibria. Therefore the SiO 2/(MgO + FeO) ratios of harzburgite saturated melts increase as temperature falls in both hydrous and anhydrous systems. The results suggest that H 2 O contents of andesitic magmas may be far higher (>7 wt %) than is generally accepted. Experimentally measured mineral/melt partition coefficients (this study and literature data) have been parameterized in terms of pressure, temperature, and melt H 2 O content. These expressions have been used to construct a Gibbs‐Duhem‐based numerical model that predicts the compositions of hydrous and anhydrous olivine‐orthopyroxene‐saturated melts. Comparisons with experimental data not included in the model indicate that it is the most accurate model available for predicting the compositions of high‐degree mantle melts, with or without H 2 O.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/2003jb002566

Cites

1 of 1 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Cited by

See all 228

Metadata

Authors
Parman, S. W., & Grove, T. L.
Venue
Journal of Geophysical Research: Solid Earth
Published
2004-02
Volume
109
Issue
B2
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1988824964
Cited by
228
References
1
FWCI
4.10
Type
journal article
Language
en
Open access
bronze

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.