The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
The Aksay segment of the northern Altyn Tagh fault: Tectonic geomorphology, landscape evolution, and Holocene slip rate
Open accessAbstract
Millennial slip rates have been determined for the Altyn Tagh fault (ATF) at three sites near Aksay (∼94°E) in northeastern Tibet by dating fluvial channels and terrace riser offsets with radiocarbon and 10 Be‐26 Al surface exposure dating. Up to nine main surfaces are defined on the basis of morphology, elevation, and dating. The abandonment age of some surfaces is constrained by radiocarbon dating, which typically coincides with the youngest cosmogenic ages for a particular surface. Older surface exposure ages are taken to represent the duration of terrace emplacement. Cumulative offsets range from 20 to 260 m and fall in distinct groups, indicative of climatically modulated regional landscape formation. Most samples are younger than ∼14 ka and postdate the Last Glacial Maximum. The end of the early Holocene optimum marks the boundary between the ages of the two main terrace levels at 5–6 ka. At this longitude the ATF is divided into a northern and southern branch. The northern ATF should thus yield a minimum rate for the ATF system. Slip rate estimates using the abandonment age of the overlying level for fill terraces or channels and the emplacement of the underlying level for strath terraces give 30 consistent results, yielding an average Holocene rate of 17.8 ± 3.6 mm/yr. It is ∼9 mm/yr less than the long‐term rate obtained near Tura at ∼87°E (26.9 ± 6.9 mm/yr), in keeping with the inference of an eastward decreasing rate on the ATF, due to increased thrusting to the south. However, it remains twice the rate determined by GPS studies.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Ballantyne, C. K. (2002) · Quaternary Science Reviews · doi:10.1016/s0277-3791(02)00005-7 · Cited by 1,203
Cited by
Cenozoic tectonic evolution of Asia: A preliminary synthesis
Yin, A. (2010) · Tectonophysics · doi:10.1016/j.tecto.2009.06.002 · Cited by 928
Taylor, M., & Yin, A. (2009) · Geosphere · doi:10.1130/ges00217.1 · Cited by 542
Cowgill, E. (2007) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2006.09.015 · Cited by 282
Crustal–lithospheric structure and continental extrusion of Tibet
Searle, M. P., Elliott, J. R., Phillips, R. J., & Chung, S.-L. (2011) · Journal of the Geological Society · doi:10.1144/0016-76492010-139 · Cited by 266
Metadata
- Authors
- Mériaux, A. ‐., Tapponnier, P., Ryerson, F. J., Xiwei, X., King, G., Van der Woerd, J., Finkel, R. C., Haibing, L., Caffee, M. W., Zhiqin, X., & Wenbin, C.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2005-04
- Volume
- 110
- Issue
- B4
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2103414293
- Cited by
- 214
- References
- 1
- FWCI
- 6.97
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.