Enhanced deformation of limestone and sandstone in the presence of high fluids
Open accessThe DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Abstract
Geological repositories subject to the injection of large amounts of anthropogenic carbon dioxide will undergo chemical and mechanical instabilities for which there are currently little experimental data. This study reports on experiments where low and high (8 MPa) aqueous fluids were injected into natural rock samples. The experiments were performed in flow‐through triaxial cells, where the vertical and confining stresses, temperature, and pressure and composition of the fluid were separately controlled and monitored. The axial vertical strains of two limestones and one sandstone were continuously measured during separate experiments for several months, with a strain rate resolution of 10−11 s−1. Fluids exiting the triaxial cells were continuously collected and their compositions analyzed. The high fluids induced an increase in strain rates of the limestones by up to a factor of 5, compared to the low fluids. Injection of high fluids into the sandstone resulted in deformation rates one order of magnitude smaller than the limestones. The creep accelerating effect of high fluids with respect to the limestones was mainly due to the acidification of the injected fluids, resulting in a significant increase in solubility and reaction kinetics of calcite. Compared to the limestones, the much weaker response of the sandstone was due to the much lower solubility and reactivity of quartz in high fluids. In general, all samples showed a positive correlation between fluid flow rate and strain rate. X‐ray tomography results revealed significant increases in porosity at the inlet portion of each core; the porosity increases were dependent on the original lithological structure and composition. The overall deformation of the samples is interpreted in terms of simultaneous dissolution reactions in pore spaces and intergranular pressure solution creep.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Plummer, L. N., & Busenberg, E. (1982) · Geochimica et Cosmochimica Acta · doi:10.1016/0016-7037(82)90056-4 · Cited by 1,886
Lackner, K. S. (2003) · Science · doi:10.1126/science.1079033 · Cited by 1,290 · cited 2×
“order to advance our knowledge of the processes involved in the geological sequestration of CO2, one of the most important challenges facing geoscientists is to understand and quantify all of the mechano-chemical processes, at both short and long timescales, that are relevant to CO2 injection and storage in geological…”
BackgroundSpycher, N., Pruess, K., & Ennis-King, J. (2003) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(03)00273-4 · Cited by 991 · cited 1×
“Note that the critical point of pure CO2 occurs at T = 31 C and P = 7.35 MPa [Spycher et al., 2003].”
InfluentialPressure solution and the force of crystallization: a phenomenological theory
Weyl, P. K. (1959) · Journal of Geophysical Research · doi:10.1029/jz064i011p02001 · Cited by 593 · cited 2×
“…porous medium, (II) cataclastic strain, such as grain crushing, (III) compaction by subcritical crack growth [Atkinson, 1984; Lockner, 1993] or, (IV) compaction by pressure solution creep [Weyl, 1959; Spiers and Schutjens, 1990; Dewers and Hajash, 1995; Hellmann et al., 2002a; Renard et al., 2005].”
BackgroundMethodDissolution kinetics of calcite, dolomite and magnesite at 25 °C and 0 to 50 atm pCO2
Pokrovsky, O. S., Golubev, S. V., & Schott, J. (2005) · Chemical Geology · doi:10.1016/j.chemgeo.2004.12.012 · Cited by 423
Sleipner vest CO2 disposal, CO2 injection into a shallow underground aquifer
Baklid, A., Korbol, R., & Owren, G. (1996) · SPE Annual Technical Conference and Exhibition · doi:10.2118/36600-ms · Cited by 217
Cited by
The Geomechanics of CO2 Storage in Deep Sedimentary Formations
Rutqvist, J. (2012) · Geotechnical and Geological Engineering · doi:10.1007/s10706-011-9491-0 · Cited by 784
From Geodetic Imaging of Seismic and Aseismic Fault Slip to Dynamic Modeling of the Seismic Cycle
Avouac, J.-P. (2015) · Annual Review of Earth and Planetary Sciences · doi:10.1146/annurev-earth-060614-105302 · Cited by 419
Leakage risk assessment of a CO2 storage site: A review
Gholami, R., Raza, A., & Iglauer, S. (2021) · Earth-Science Reviews · doi:10.1016/j.earscirev.2021.103849 · Cited by 364
The Role of Pressure Solution Creep in the Ductility of the Earth’s Upper Crust
Gratier, J.-P., Dysthe, D. K., & Renard, F. (2013) · Advances in Geophysics · doi:10.1016/b978-0-12-380940-7.00002-0 · Cited by 298
Self-citationCalcite precipitation from CO2-H2O-Ca(OH)2 slurry under high pressure of CO2
Montes-Hernandez, G., Renard, F., Geoffroy, N., Charlet, L., & Pironon, J. (2007) · Journal of Crystal Growth · doi:10.1016/j.jcrysgro.2007.08.005 · Cited by 137
Self-citationChoens, R. C., Ilgen, A. G., Espinoza, D. N., Aman, M., Wilson, J., & Dewers, T. A. (2020) · International Journal of Greenhouse Gas Control · doi:10.1016/j.ijggc.2020.102982 · Cited by 12
Metadata
- Authors
- Le Guen, Y., Renard, F., Hellmann, R., Brosse, E., Collombet, M., Tisserand, D., & Gratier, J. ‐.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2007-05
- Volume
- 112
- Issue
- B5
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W1972813877
- Cited by
- 162
- References
- 6
- FWCI
- 4.48
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.