The DOI matches its Crossref record.
Strong velocity weakening and powder lubrication of simulated carbonate faults at seismic slip rates
Abstract
High‐velocity friction tests were conducted on solid and hollow cylinders of Carrara (calcite) marble, dolomite marble, silicate‐bearing calcite marble, and calcite gouge to investigate the strength of carbonate faults during seismic slip. The experiments, performed at normal stresses of 0.6–14.7 MPa, slip rates of 0.03–1.60 m/s, and room temperature in a rotary‐shear friction testing machine, yielded an extraordinarily low steady state friction coefficient (<0.1) at slip rates of ∼1.1–1.2 m/s. The slip‐weakening distance of 4–28 m became shorter at higher normal stress or frictional work rate. Strong velocity weakening was observed not only in steady state but also in nonsteady state friction, while the slip rate was changing; thus slip deceleration was accompanied by fault strength recovery. Large, rapid temperature rises in narrow shear localization zones (less than a few micrometers) induced carbonate decomposition, such as the breakdown of calcite into aggregates of CaO nanograins and CO 2 in Carrara marble. Scanning electron microscope observation revealed that the shear localization zone in the highly porous decomposition product was a layer of scattered small grains (mostly <1 μ m in diameter). These microstructures and the measured high permeability (∼10−14 m 2) of the decomposed marble indicate that the dominant weakening mechanism in our experiments was possibly powder lubrication. Powder rheology at high slip rates is not yet well understood, but the frictional behavior of nanograins appears to be strongly velocity dependent. If decarbonation occurs during seismic slip in natural carbonate faults, powder lubrication may make the faults slippery even under fluid‐drained conditions.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Do faults preserve a record of seismic slip: A second opinion
Rowe, C. D., & Griffith, W. A. (2015) · Journal of Structural Geology · doi:10.1016/j.jsg.2015.06.006 · Cited by 306
Temperatures and fluids on faults based on carbonate clumped-isotope thermometry
Swanson, E. M., Wernicke, B. P., Eiler, J. M., & Losh, S. (2012) · American Journal of Science · doi:10.2475/01.2012.01 · Cited by 42
Metadata
- Authors
- Han, R., Hirose, T., & Shimamoto, T.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2010-03
- Volume
- 115
- Issue
- B3
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2009296750
- Cited by
- 231
- References
- 0
- FWCI
- 16.91
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Strong velocity weakening and powder lubrication of simulated carbonate faults at seismic slip rates. https://app.cochat.ai/papers/10.1029/2008jb006136
- The paper
- Han, R., Hirose, T., & Shimamoto, T. (2010). Strong velocity weakening and powder lubrication of simulated carbonate faults at seismic slip rates. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/2008jb006136
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.