Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 230

The DOI matches its Crossref record.

Effects of temperature on friction: Constitutive equations and experiments with quartz gouge

Chester, Frederick M.·1994·Journal of Geophysical Research: Solid Earth

Abstract

A state‐variable constitutive relation that can describe the dependence of friction on temperature at or near steady state conditions is presented. The relation is derived from existing state‐variable relations used to describe velocity dependence and the assumption that the micromechanisms of friction are thermally activated and follow an Arrhenius relationship. The relation adequately describes the transient and steady state friction behavior displayed in sliding experiments on 1.5‐mm‐thick layers of fine‐grained (<100 μm diameter) quartz gouge. Gouge layers were sheared up to 10 mm between rough steel surfaces at a constant effective confining pressure of 20 MPa and under room‐dry or water‐saturated conditions in a servo‐controlled triaxial apparatus. In each experiment, velocity was stepped between 4, 0.4, and 0.04 μm/s at constant temperature, and temperature was stepped between 24°, 57°, and 82°C at a constant velocity of 0.04 μm/s. Coefficient of friction was calculated from measurements of sample strength using corrections for all apparatus effects including the temperature and velocity dependent strength of the metal sleeves used to isolate the sample and of the graphite‐lubricated interface that allowed lateral slip of the sample halves. Experiments indicate that (1) an abrupt increase in temperature induces a transient friction response similar to that induced by a step decrease in velocity, (2) the transient friction response is relatively symmetric for steps up and steps down in temperature, and (3) the characteristic slip distance for friction to evolve to steady state after step changes in temperature is the same as after step changes in velocity. The apparent activation energy determined for wet quartz gouge at the test conditions is 89±23 kJ/mol. This value is consistent with models of friction involving failure of contact junctions by subcritical crack growth and time dependent strengthening of contact junctions by either increasing the true area of contact through subcritical cracking or by increasing the quality of contact junctions through healing.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/93jb03110

Cites

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cited by

See all 230

Metadata

Authors
Chester, F. M.
Venue
Journal of Geophysical Research: Solid Earth
Published
1994-04-10
Volume
99
Issue
B4
Pages
7247-7261
ISSN
0148-0227 (ISSN-L)
OpenAlex
W2087284097
Cited by
230
References
0
FWCI
3.42
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Effects of temperature on friction: Constitutive equations and experiments with quartz gouge. https://app.cochat.ai/papers/10.1029/93jb03110
The paper
Chester, F. M. (1994). Effects of temperature on friction: Constitutive equations and experiments with quartz gouge. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/93jb03110

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.