The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Geochemical constraints on initial and final depths of melting beneath mid‐ocean ridges
Abstract
The comparison of the composition and volume of mid‐ocean ridge basalts to predicted values inferred from experimental and theoretical studies is one of the primary tools for mapping thermal structure and the geometry of melting beneath mid‐ocean ridges. Several indicators of either the pressure or degree of melting are commonly employed: Na 2 O concentration in melts is roughly inversely proportional to the extent of melting; (Srn/Yb)N is affected by the proportion of melt that is generated in the garnet stability field (deeper than 60 km); and FeO content increases with increasing pressure of melting. Crustal thickness also depends on the geometry and extent of melting. K 2 O/TiO 2 is used as an indicator of the enrichment of the mantle source. For normal ridges, we find that regional averages of Fe(8) (FeO normalized to 8 wt % MgO to correct for fractionation) are strongly dependent on enrichment. Thus if Fe(8) is used to infer to the pressure of melting, correction for the effects of compositional heterogeneity of the source is needed. Even with the correction for heterogeneity, however, it is difficult to correct for all fractionation effects accurately enough to use FeO as a depth indicator except in the most extreme cases. Mantle heterogeneity also affects Na(8) and (Sm/Yb)N, but the correction for enrichment by linear regression of the Na(8) and (Sm/Yb)N to a common reference value of K 2 O/TiO 2 does not change the relationship between (Sm/Yb)N and Na(8) that is used to estimate depth and degree of melting. In simple melting models, the composition and crustal thickness depend on the rate of pressure release melting per kilometer of uplift; the initial depth of onset of melting; the final depth of termination of melting; the nature of melt equilibration, i.e., batch or fractional melting; and the geometry of upwelling, i.e., passive or dynamic flow. We find that melting beneath normal ridges commences in a narrow depth range in the spinel‐garnet transition zone (about 60–70 km in depth), suggesting a much smaller variation in potential temperature beneath normal ridges (<60°K) than previously suggested (250°K, Klein and Langmuir, 1987; Langmuir et al., 1992). The difference is due primarily to the component of Fe(8) variation caused by mantle heterogeneity in the global data set and to difficulties in correcting FeO for fractionation. The initial depth of melting beneath hotspots is greater than beneath normal ridges, indicating significantly higher temperatures. Instead of melting continuing to the base of the crust beneath normal ridges, it ceases at a variety of depths beneath the crust. Variations in final depth of melting may be due to cooling to the surface, effects of transform faults, and the local, relative importance of dynamic upwelling.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
The volume and composition of melt generated by extension of the lithosphere
McKENZIE, D., & BICKLE, M. J. (1988) · Journal of Petrology · doi:10.1093/petrology/29.3.625 · Cited by 2,951
Cited by
Hirth, G., & Kohlstedt, D. L. (1996) · Earth and Planetary Science Letters · doi:10.1016/0012-821x(96)00154-9 · Cited by 1,599
Temperatures in ambient mantle and plumes: Constraints from basalts, picrites, and komatiites
Herzberg, C., Asimow, P. D., Arndt, N., Niu, Y., Lesher, C. M., Fitton, J. G., Cheadle, M. J., & Saunders, A. D. (2007) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2006gc001390 · Cited by 905
Mantle solidus: Experimental constraints and the effects of peridotite composition
Hirschmann, M. M. (2000) · Geochemistry, Geophysics, Geosystems · doi:10.1029/2000gc000070 · Cited by 867
A possible role for garnet pyroxenite in the origin of the "garnet signature" in MORB
Hirschmann, M. M., & Stolper, E. M. (1996) · Contributions to Mineralogy and Petrology · doi:10.1007/s004100050184 · Cited by 829
Lee, C.-T. A., Luffi, P., Plank, T., Dalton, H., & Leeman, W. P. (2009) · Earth and Planetary Science Letters · doi:10.1016/j.epsl.2008.12.020 · Cited by 771
Metadata
- Authors
- Shen, Y., & Forsyth, D. W.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1995-02-10
- Volume
- 100
- Issue
- B2
- Pages
- 2211-2237
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2087663267
- Cited by
- 246
- References
- 1
- FWCI
- 14.81
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Geochemical constraints on initial and final depths of melting beneath mid‐ocean ridges. https://app.cochat.ai/papers/10.1029/94jb02768
- The paper
- Shen, Y., & Forsyth, D. W. (1995). Geochemical constraints on initial and final depths of melting beneath mid‐ocean ridges. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/94jb02768
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.