The DOI matches its Crossref record.
On the births of film drops from bubbles bursting on seawater surfaces
Abstract
The parameters describing the birth of film droplets originating from bubbles bursting on seawater surfaces are presented. Results are given for bubble sizes Db from 2 to 14.6 mm equivalent volume diameter. It is shown, contrary to earlier reports, that the films of all bubbles with Db up to at least 14.6 mm burst in an orderly manner in which a hole appears at a well‐defined location, usually the film's edge, and propagates from there gathering up the film's mass into a toroidal ring as it progresses. This process is enabled because surface tension provides the force required to sustain the centripetal accelerations. Film drops are created when beads, of sufficient size, form along the length of the toroidal ring and surface tension is insufficient to maintain the centripetal accelerations at these accumulation points. Pieces of the ring break loose and leave the toroidal ring along paths tangential to the bubble's cap. It is shown that only bubbles larger than 2.4 mm diameter can launch film droplets by this means and that this begins when the film has rolled up through an angle of about 31° independent of both bubble size and (theoretically) surface tension. Film drop spray patterns recorded on MgO‐coated cylindrical shells surrounding the burst bubbles yield film drop numbers and trajectories. In addition, film drop size distributions, their speed of launch, and the speed at which the film opens have been determined as a function of bubble size. The droplet sizes cited here are substantially larger than most previous estimates, and with a high probability, these droplets follow downward trajectories which lead them to impact the surface. A strong inference may be drawn that these impacts give birth to secondary droplets that are smaller than their parents and which have upward velocity components.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Sea Salt Aerosol Production: Mechanisms, Methods, Measurements and Models—A Critical Review
Lewis, R., & Schwartz, E. (2004) · Geophysical Monograph Series · doi:10.1029/gm152 · Cited by 658
Laboratory simulations and parameterization of the primary marine aerosol production
Mårtensson, E. M., Nilsson, E. D., de Leeuw, G., Cohen, L. H., & Hansson, H. ‐. (2003) · Journal of Geophysical Research: Atmospheres · doi:10.1029/2002jd002263 · Cited by 592
Veron, F. (2015) · Annual Review of Fluid Mechanics · doi:10.1146/annurev-fluid-010814-014651 · Cited by 435
Chemistry and Related Properties of Freshly Emitted Sea Spray Aerosol
Quinn, P. K., Collins, D. B., Grassian, V. H., Prather, K. A., & Bates, T. S. (2015) · Chemical Reviews · doi:10.1021/cr500713g · Cited by 421
Global transport of perfluoroalkyl acids via sea spray aerosol
Johansson, J. H., Salter, M. E., Acosta Navarro, J. C., Leck, C., Nilsson, E. D., & Cousins, I. T. (2019) · Environmental Science: Processes & Impacts · doi:10.1039/c8em00525g · Cited by 158
Metadata
- Authors
- Spiel, D. E.
- Venue
- Journal of Geophysical Research: Oceans
- Publisher
- American Geophysical Union (AGU)
- Published
- 1998-10-15
- Volume
- 103
- Issue
- C11
- Pages
- 24907-24918
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W4245843083
- Cited by
- 181
- References
- 0
- FWCI
- 2.97
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: On the births of film drops from bubbles bursting on seawater surfaces. https://app.cochat.ai/papers/10.1029/98jc02233
- The paper
- Spiel, D. E. (1998). On the births of film drops from bubbles bursting on seawater surfaces. Journal of Geophysical Research: Oceans. https://doi.org/10.1029/98jc02233
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.