The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
Permeability of shaly sands
Open accessAbstract
The permeability of a sand shale mixture is analyzed as a function of shale fraction and the permeability of the two end‐members, i.e., the permeability of a clay‐free sand and the permeability of a pure shale. First, we develop a model for the permeability of a clay‐free sand as a function of the grain diameter, the porosity, and the electrical cementation exponent. We show that the Kozeny‐Carman‐type relation can be improved by using electrical parameters which separate pore throat from total porosity and effective from total hydraulic radius. The permeability of a pure shale is derived in a similar way but is strongly dependent on clay mineralogy. For the same porosity, there are 5 orders of magnitude of difference between the permeability of pure kaolinite and the permeability of pure smectite. The separate end‐members' permeability models are combined by filling the sand pores progressively with shale and then dispersing the sand grains in shale. The permeability of sand shale mixtures is shown to have a minimum at the critical shale content at which shale just fills the sand pores. Pure shale has a slightly higher permeability. Permeability decreases sharply with shale content as the pores of a sand are filled. The permeability of sand shale mixtures thus has a very strong dependence on shale fraction, and available data confirm this distinctive shale‐fraction dependence. In addition, there is agreement (within 1 order of magnitude) between the permeabilities predicted from our model and those measured over 11 orders of magnitude from literature sources. Finally, we apply our model to predict the permeabilities of shaly sand formations in the Gulf Coast. The predictions are compared to a data set of permeability determination made on side‐wall cores. The agreement between the theoretical predictions and the experimental data is very good.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Bruggeman, D. A. G. (1935) · Annalen der Physik · doi:10.1002/andp.19354160705 · Cited by 8,645
Huckenholz, H. G. (1963) · Journal of Sedimentary Research · doi:10.1306/74d70f74-2b21-11d7-8648000102c1865d · Cited by 165
Cited by
Binley, A., Hubbard, S. S., Huisman, J. A., Revil, A., Robinson, D. A., Singha, K., & Slater, L. D. (2015) · Water Resources Research · doi:10.1002/2015wr017016 · Cited by 800
Self-citationSoil properties influencing apparent electrical conductivity: a review
Friedman, S. P. (2005) · Computers and Electronics in Agriculture · doi:10.1016/j.compag.2004.11.001 · Cited by 798
Determination of permeability from spectral induced polarization in granular media
Revil, A., & Florsch, N. (2010) · Geophysical Journal International · doi:10.1111/j.1365-246x.2010.04573.x · Cited by 422
Self-citationSlater, L. (2007) · Surveys in Geophysics · doi:10.1007/s10712-007-9022-y · Cited by 364
Spectral induced polarization of shaly sands: Influence of the electrical double layer
Revil, A. (2012) · Water Resources Research · doi:10.1029/2011wr011260 · Cited by 293
Self-citation
Metadata
- Authors
- Revil, A., & Cathles, L. M.
- Venue
- Water Resources Research
- Publisher
- American Geophysical Union (AGU)
- Published
- 1999-03
- Volume
- 35
- Issue
- 3
- Pages
- 651-662
- ISSN
- 0043-1397 (ISSN-L)
- 1944-7973
- OpenAlex
- W2007188064
- Cited by
- 470
- References
- 2
- FWCI
- 13.37
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Permeability of shaly sands. https://app.cochat.ai/papers/10.1029/98wr02700
- The paper
- Revil, A., & Cathles, L. M. (1999). Permeability of shaly sands. Water Resources Research. https://doi.org/10.1029/98wr02700
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.