Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 405

The DOI matches its Crossref record; 65 of the 65 references it cites were found in a registry or an index.

Temperatures, heat flux, and frictional stress near major thrust faults

Molnar, Peter, England, Philip·1990·Journal of Geophysical Research: Solid Earth

Abstract

We examine the two‐dimensional advective and conductive transport of heat in a region of thrust faulting. Both simple theoretical considerations and numerical experiments show that the steady state temperatures near the fault are reduced by a divisor, below what they would be with the same heat sources but in the absence of advection. In this expression zƒ is the depth to the fault, V is the slip rate, δ is the component of the dip of the fault in the direction of underthrusting, κ is thermal diffusivity, and b is a dimensionless factor that is essentially equal to one for most forms of heating. Initial changes in temperatures near the fault are given by . These simple formulae are successful because of the neglible influence of lateral conduction of heat, at least for slip rates of a few mm/yr or more. Two time constants govern the transition from the initial change in temperature to steady state: t1 = uƒ/V, where uƒ is the distance along the fault in the direction of underthrusting from the surface to the depth in question, and , where zƒ is the depth to the fault. When elapsed times exceed the sum of these two time constants, temperatures differ from their steady state values by only about 10 percent. The numerical experiments indicate that the simple formulae are sufficiently accurate that sophisticiated numerical modeling of temperatures in specific regions is unwarranted. Putain. An application of these simple formulae to measurements of conductive heat flow at island arcs implies that shear stresses at island arcs approach 100 MPa and are greater than 30 MPa. Calculations of temperatures appropriate for the Himalaya suggest that shear stresses of 100 MPa on the Main Central Thrust probably are required to account for the Tertiary granites of the region, if melting took place after slip began on the thrust. Similarly, the cut‐off in seismicity at a depth of about 15 km in the Himalaya, if due to temperatures exceeding 350° to 450°C, implies a deviatoric stress close to 100 MPa.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1029/jb095ib04p04833

Cites

65 of 65 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 65 references

Cited by

See all 405

Metadata

Authors
Molnar, P., & England, P.
Venue
Journal of Geophysical Research: Solid Earth
Published
1990-04-10
Volume
95
Issue
B4
Pages
4833-4856
ISSN
0148-0227 (ISSN-L)
OpenAlex
W1989905077
Cited by
405
References
65
FWCI
14.29
Type
journal article
Language
en
Open access
closed

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Temperatures, heat flux, and frictional stress near major thrust faults. https://app.cochat.ai/papers/10.1029/jb095ib04p04833
The paper
Molnar, P., & England, P. (1990). Temperatures, heat flux, and frictional stress near major thrust faults. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/jb095ib04p04833

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.