Frictional behavior and constitutive modeling of simulated fault gouge
The DOI matches its Crossref record; 17 of the 17 references it cites were found in a registry or an index.
Abstract
This paper presents an investigation of the factional properties and stability of frictional sliding for simulated fault gouge. In these experiments we sheared gouge layers (quartz sand) under saturated drained conditions and at constant normal stress (50–190 MPa) between either rough steel surfaces or Westerly granite surfaces in a triaxial apparatus. Surface roughness (60 to 320 grit) and gouge layer thickness (0–4.0 mm) were varied in the experiments with granite samples. Porosity ϕ was monitored continuously during shear. Our measurements indicate that granular gouge exhibits strain hardening and net compaction for shear strains γ less than 0.5–1.0. For γ > 0.5–1.0, sliding occurs at approximately constant shear stress and net compaction from one load/unload cycle to the next ceases. Dilatancy occurs at 1/3 to 1/2 the shear stress required for sliding and d2 ϕ/d γ 2 becomes negative at about the peak stress in a given loading cycle, indicating the onset of shear localization. Oblique shear bands appear in the layers at γ = 1.3–1.5. Experiments with an initial gouge layer exhibit velocity strengthening (the coefficient of friction increases with slip velocity), and initially bare granite surfaces exhibit velocity weakening. The magnitude of velocity strengthening varies inversely with normal stress and directly with gouge thickness and surface roughness. In the gouge experiments the dilatancy rate d ϕ/d γ also varies with slip rate. Using a simple energy balance to relate volume change and frictional resistance, we find quantitative agreement between the measured change in dilatancy rate and friction following changes in slip rate. This indicates that velocity strengthening within granular gouge is the result of dilatancy. The slip rate dependence of d ϕ/d γ increases with gouge thickness and surface roughness, in agreement with the friction data. Our data therefore suggest that slip within unconsolidated granular material, such as some natural fault gouges, is inherently stable. The results thus provide an explanation for (1) the tendency of gouge accumulation to stabilize slip in laboratory samples, and (2) the tendency for aseismic slip within shallow (< 3–5 km) unconsolidated fault gouge and within unconsolidated sediments such as shallow alluvium and accretionary prisms.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Slip instability and state variable friction laws
Ruina, A. (1983) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb088ib12p10359 · Cited by 3,280
Modeling of rock friction: 1. Experimental results and constitutive equations
Dieterich, J. H. (1979) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb084ib05p02161 · Cited by 3,049
Elementary Numerical Analysis: An Algorithmic Approach
W., J. W., & Conte, S. D. (1967) · Mathematics of Computation · doi:10.2307/2003277 · Cited by 1,327
Stability of Steady Frictional Slipping
Rice, J. R., & Ruina, A. L. (1983) · Journal of Applied Mechanics · doi:10.1115/1.3167042 · Cited by 1,120
Stick-Slip as a Mechanism for Earthquakes
Brace, W. F., & Byerlee, J. D. (1966) · Science · doi:10.1126/science.153.3739.990 · Cited by 1,083
Reynolds, O. (1885) · The London, Edinburgh, and Dublin Philosophical Magazine and Journal of Science · doi:10.1080/14786448508627791 · Cited by 1,047
Broad bandwidth study of the topography of natural rock surfaces
Brown, S. R., & Scholz, C. H. (1985) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb090ib14p12575 · Cited by 909
Self-citationGu, J., RICE, J. R., Ruina, A. L., & Tse, S. T. (1984) · Journal of the Mechanics and Physics of Solids · doi:10.1016/0022-5096(84)90007-3 · Cited by 577
Constitutive Properties of Faults With Simulated Gouge
Dieterich, J. H. (2013) · Geophysical Monograph Series · doi:10.1029/gm024p0103 · Cited by 488
The depth of seismic faulting and the upper transition from stable to unstable slip regimes
Marone, C., & Scholz, C. H. (1988) · Geophysical Research Letters · doi:10.1029/gl015i006p00621 · Cited by 458
Self-citationWear and gouge formation in brittle faulting
Scholz, C. H. (1987) · Geology · doi:10.1130/0091-7613(1987)15<493:wagfib>2.0.co;2 · Cited by 315
Self-citationEffect of humidity on time‐ and velocity‐dependent friction in rocks
Dieterich, J. H., & Conrad, G. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib06p04196 · Cited by 231
Earthquake aftereffects and triggered seismic phenomena
Rice, J. R., & Gu, J.-C. (1983) · pure and applied geophysics · doi:10.1007/bf02590135 · Cited by 173
On dilatancy in relation to seismic sources
Frank, F. C. (1965) · Reviews of Geophysics · doi:10.1029/rg003i004p00485 · Cited by 144
Frictional sliding of dolomite: A variation in constitutive behavior
Weeks, J. D., & Tullis, T. E. (1985) · Journal of Geophysical Research Atmospheres · doi:10.1029/jb090ib09p07821 · Cited by 123
The brittle-ductile transition in a deformation-mechanism map for halite
Chester, F. M. (1988) · Tectonophysics · doi:10.1016/0040-1951(88)90230-2 · Cited by 58
Dilatancy of quartz gouge in pure shear
Raleigh, B., & Marone, C. J. (1986) · Geophysical monograph · doi:10.1029/gm036p0001 · Cited by 14
Self-citation
Cited by
The mechanics of earthquakes and faulting
(1990) · Choice Reviews Online · doi:10.5860/choice.28-1579 · Cited by 3,569
Scholz, C. H. (1998) · Nature · doi:10.1038/34097 · Cited by 2,227
Self-citationThe Mechanics of Earthquakes and Faulting
Scholz, C. H. (2019) · Cambridge University Press eBooks · doi:10.1017/9781316681473 · Cited by 910
Self-citationOn the mechanics of earthquake afterslip
Marone, C. J., Scholtz, C. H., & Bilham, R. (1991) · Journal of Geophysical Research: Solid Earth · doi:10.1029/91jb00275 · Cited by 677
Self-citationFrictional slip of granite at hydrothermal conditions
Blanpied, M. L., Lockner, D. A., & Byerlee, J. D. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb00862 · Cited by 605
Metadata
- Authors
- Marone, C., Raleigh, C. B., & Scholz, C. H.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1990-05-10
- Volume
- 95
- Issue
- B5
- Pages
- 7007-7025
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2094152073
- Cited by
- 630
- References
- 17
- FWCI
- 8.64
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.