The DOI matches its Crossref record.
Effect of grain size on brittle and semibrittle strength: Implications for micromechanical modelling of failure in compression
Abstract
Triaxial experiments were performed at room temperature and confining pressures up to 450 MPa on four pure, dense calcite rocks whose average grain sizes range over four orders of magnitude. Volumetric strain was measured during some of the experiments and microstructural studies were conducted to identify the active deformation mechanisms. The brittle fracture strength and macroscopic initial “plastic” yield stress in the semibrittle field follow empirical Hall‐Petch relations. The confining pressure at the brittle‐ductile transition depends inversely on grain size, but the stress ratio σ 3/σ 1 at the transition is nearly the same for the different rocks. We assume that the initial flaw size scales with grain size and compare our experimental data to the fracture mechanics models of Ashby and Hallam (1986) for brittle fracture and Horii and Nemat‐Nasser (1986) for the brittle‐plastic transition in compression. The first model predicts that small confining pressures are sufficient to inhibit work softening behavior; however, our data indicate that localization occurs for significantly higher values of confining pressure than predicted. Furthermore, we find that localization is inhibited with increased confining pressure because of the increased activity of plastic flow mechanisms, rather than because of the increased difficulty of crack propagation alone. With certain assumptions, the model predicts the experimentally determined slope of the Hall‐Petch relation in the brittle field, although it underestimates the compressive strength of the rocks. The second model predicts that the stress ratio σ 3/σ 1 at the brittle‐plastic transition scales with the, square root of the grain size; however, the experimental data do not corroborate the model unless the square of the ratio of the mode I fracture toughness to the plastic yield stress in shear scales with the grain size. The stress ratio at the brittle‐ductile transition is apparently a constant for many different rock types; we suggest that the physical basis for this relationship is that the ductility of most mineral aggregates falls within a small range.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Strength of the lithosphere: Constraints imposed by laboratory experiments
Kohlstedt, D. L., Evans, B., & Mackwell, S. J. (1995) · Journal of Geophysical Research: Solid Earth · doi:10.1029/95jb01460 · Cited by 1,603
Self-citationFailure mode and weakening effect of water on sandstone
Baud, P., Zhu, W., & Wong, T. (2000) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2000jb900087 · Cited by 480
Self-citationEberhardt, E., Stimpson, B., & Stead, D. (1999) · Rock Mechanics and Rock Engineering · doi:10.1007/s006030050026 · Cited by 377
Some microstructural aspects of strength variation in rocks
Přikryl, R. (2001) · International Journal of Rock Mechanics and Mining Sciences · doi:10.1016/s1365-1609(01)00031-4 · Cited by 310
Wong, T.-F., Wong, R. H. C., Chau, K. T., & Tang, C. A. (2006) · Mechanics of Materials · doi:10.1016/j.mechmat.2005.12.002 · Cited by 303
Self-citation
Metadata
- Authors
- Fredrich, J. T., Evans, B., & Wong, T.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1990-07-10
- Volume
- 95
- Issue
- B7
- Pages
- 10907-10920
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2086552372
- Cited by
- 224
- References
- 0
- FWCI
- 2.25
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of grain size on brittle and semibrittle strength: Implications for micromechanical modelling of failure in compression. https://app.cochat.ai/papers/10.1029/jb095ib07p10907
- The paper
- Fredrich, J. T., Evans, B., & Wong, T. (1990). Effect of grain size on brittle and semibrittle strength: Implications for micromechanical modelling of failure in compression. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/jb095ib07p10907
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.