The DOI matches its Crossref record; 2 of the 2 references it cites were found in a registry or an index.
A nonlinear rheology model for mid‐ocean ridge axis topography
Abstract
This paper describes a mechanical model of the mid‐ocean ridge axis based on a nonlinear rheology. The oceanic lithosphere is modeled as a strongly temperature‐dependent “power law” material with the Byerlee's friction law describing the brittle behavior of the upper oceanic lithosphere. We examined two simple models. A mantle‐only model predicted an axial rift valley 1–2 km deep and 10–15 km wide at slow half‐rates of 5–25 mm/yr which is in fair agreement with observations. However, the rift valley did not completely vanish at fast spreading rates even though its width and relief became much smaller. Thus, the mantle‐only model failed to explain the observed transition in axial topography with spreading rate. By including a uniform thickness oceanic crust with theological properties different from the mantle, our second model produced the first order variation of axial topography with spreading rate: a pronounced rift valley with 1–2 km relief at slow rates, a smaller relief (<500 m) rift valley at intermediate rates, and no rift valley at fast rates. There are two additional results of the nonlinear rheology model which are distinctively different from the previous uniform viscosity mantle models. First, horizontal velocity at the seafloor changes sharply in a very narrow zone at the ridge axis, i.e., the stresses are concentrated in a very narrow zone for the nonlinear rheology. This conclusion is remarkably independent of the boundary conditions at the seafloor. Second, the computed width of the axial plastic failure zone decreases with spreading rate, a result very different from that of a uniform viscosity model. This is caused by the strong temperature dependence of the power law rheology and the fact that the temperature of the oceanic lithosphere depends greatly on the spreading rate. Beyond some distance from the ridge axis, the brittle plate (roughly the region above the 750°C isotherm) deforms very little; both the horizontal strain rate ė 11 and the maximum shear strain rate ė max are less than 10−17 s−1 which is in good agreement with the 10−18 s−1 average for oceanic brittle plate deformation inferred from seismic moment data. Within the ductile region (area beneath the 750°C isotherm) the strain rates are in the range of 10−14–10−16 s−1, except within a narrow band near the ridge axis where higher strain rates are located. We found that the thermal structure of the oceanic lithosphere is not very sensitive to the details of the mantle flow pattern (or the rheology) but is very sensitive to the cooling by hydrothermal circulation near the ridge axis. Axial structure is also influenced by factors other than the spreading rate. Within the range of slow and intermediate rates, our calculations show that the size of an axial rift valley decreases with an increase in either the thickness of the oceanic crust or the mantle temperature; in other words, a thinner crust or a cooler mantle temperature will produce a more pronounced rift valley. In the vicinity of hotspots, the absence of an axial rift valley even at slow spreading rates, such as the Reykjanes Ridge, can be well explained by the anomalously thicker crust and higher mantle temperatures. In contrast, at the Australian‐Antarctic Discordance a deeper than normal section of an intermediate spreading ridge has very rough topography not present on the adjacent sections of the ridge; this can be explained by our model as due to an anomalously low mantle temperature as has been suggested or perhaps also due to a thinner oceanic crust
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Some remarks on heat flow and gravity anomalies
McKenzie, D. P. (1967) · Journal of Geophysical Research · doi:10.1029/jz072i024p06261 · Cited by 751
Transform fault earthquakes in the North Atlantic: Source mechanisms and depth of faulting
Bergman, E. A., & Solomon, S. C. (1988) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb093ib08p09027 · Cited by 104
Cited by
Mantle Melting and Melt Extraction Processes beneath Ocean Ridges: Evidence from Abyssal Peridotites
Niu, Y. (1997) · Journal of Petrology · doi:10.1093/petroj/38.8.1047 · Cited by 561
The genesis of oceanic crust: Magma injection, hydrothermal circulation, and crustal flow
Morgan, J. P., & Chen, Y. J. (1993) · Journal of Geophysical Research: Solid Earth · doi:10.1029/92jb02650 · Cited by 532
Self-citationEmplacement of mantle rocks in the seafloor at mid‐ocean ridges
Cannat, M. (1993) · Journal of Geophysical Research: Solid Earth · doi:10.1029/92jb02221 · Cited by 531
A geological model for the structure of ridge segments in slow spreading ocean crust
Tucholke, B. E., & Lin, J. (1994) · Journal of Geophysical Research: Solid Earth · doi:10.1029/94jb00338 · Cited by 420
Sleep, N. H. (1994) · Journal of Geophysical Research: Planets · doi:10.1029/94je00216 · Cited by 381
Metadata
- Authors
- Chen, Y., & Morgan, W. J.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 1990-10-10
- Volume
- 95
- Issue
- B11
- Pages
- 17583-17604
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2165933632
- Cited by
- 235
- References
- 2
- FWCI
- 13.46
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A nonlinear rheology model for mid‐ocean ridge axis topography. https://app.cochat.ai/papers/10.1029/jb095ib11p17583
- The paper
- Chen, Y., & Morgan, W. J. (1990). A nonlinear rheology model for mid‐ocean ridge axis topography. Journal of Geophysical Research: Solid Earth. https://doi.org/10.1029/jb095ib11p17583
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.