Fuel cell cathode catalyst layers from “green” catalyst inks
The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.
Abstract
Fuel cell cathode catalyst layers deposited from a water-based catalyst ink formulation, using high water content and minimum volatile organic compounds, are investigated. Cathodes fabricated from a dispersion medium containing 96 wt% water are compared with cathodes fabricated from conventional alcohol-based inks containing 1-propanol–water 3 : 1 (w/w). The morphology of the two catalyst layers are similar, as are electrochemically-active surface areas at relative humidities of 100, 70 and 30% RH. Oxygen reduction kinetics obtained under fully humidified H2/O2 conditions exhibit similar Tafel slopes, 67 ± 3 mV per dec. However, cathodes prepared from water-based inks exhibit a lower H2/air fuel cell performance under 100, 70 and 30% RH while its porosity, obtained using mercury porosimetry, is slightly higher. EIS measurements obtained under high current density indicate that the mass transport resistance of the water-based catalyst layer is lower, which is consistent with porosimetric data, and suggests that factors other than mass transport limit the performance of the water-based cathode. The protonic resistance of the catalyst layers was found to be 105 and 145 mΩ cm2 for the propanol- and water-based catalyst layers, respectively. The differences are more pronounced when RH is decreased from 100 to 30%. This trend is consistent with the observed decrease in fuel cell performance under conditions of lower RH, and indicates that the higher proton resistance of the water-based catalyst layer is the cause of its lower fuel cell performance.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
State of Understanding of Nafion
Mauritz, K. A., & Moore, R. B. (2004) · Chemical Reviews · doi:10.1021/cr0207123 · Cited by 4,791
Parallel cylindrical water nanochannels in Nafion fuel-cell membranes
Schmidt-Rohr, K., & Chen, Q. (2008) · Nature Materials · doi:10.1038/nmat2074 · Cited by 1,371
Shin, S.-J., Lee, J.-K., Ha, H.-Y., Hong, S.-A., Chun, H.-S., & Oh, I.-H. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(01)01045-x · Cited by 205
Dual cohesive energy densities of perfluorosulphonic acid (Nafion) membrane
Yeo, R. S. (1980) · Polymer · doi:10.1016/0032-3861(80)90015-4 · Cited by 117
Fabrication of a thin catalyst layer using organic solvents
Yang, T.-H., Yoon, Y.-G., Park, G.-G., Lee, W.-Y., & Kim, C.-S. (2004) · Journal of Power Sources · doi:10.1016/j.jpowsour.2003.09.018 · Cited by 74
Chisaka, M., & Daiguji, H. (2006) · Electrochimica Acta · doi:10.1016/j.electacta.2006.01.018 · Cited by 52
Performance enhancement of PEMFC through temperature control in catalyst layer fabrication
Park, H.-S., Cho, Y.-H., Cho, Y.-H., Jung, C. R., Jang, J. H., & Sung, Y.-E. (2007) · Electrochimica Acta · doi:10.1016/j.electacta.2007.07.046 · Cited by 46
Cited by
Xu, J., Gao, P., & Zhao, T. S. (2012) · Energy Environ. Sci. · doi:10.1039/c1ee01431e · Cited by 515
Fuel Cell Catalyst Layers: A Polymer Science Perspective
Holdcroft, S. (2014) · Chemistry of Materials · doi:10.1021/cm401445h · Cited by 481
Self-citationTakahashi, S., Mashio, T., Horibe, N., Akizuki, K., & Ohma, A. (2015) · ChemElectroChem · doi:10.1002/celc.201500131 · Cited by 143
Self-citationShukla, S., Bhattacharjee, S., Weber, A. Z., & Secanell, M. (2017) · Journal of The Electrochemical Society · doi:10.1149/2.0961706jes · Cited by 137
Zamel, N. (2016) · Journal of Power Sources · doi:10.1016/j.jpowsour.2016.01.091 · Cited by 93
Metadata
- Authors
- Xie, Z., Zhao, X., Adachi, M., Shi, Z., Mashio, T., Ohma, A., Shinohara, K., Holdcroft, S., & Navessin, T.
- Venue
- Energy & Environmental Science
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2008
- Volume
- 1
- Issue
- 1
- Pages
- 184
- ISSN
- 1754-5692 (ISSN-L)
- 1754-5706
- OpenAlex
- W2005620692
- Cited by
- 86
- References
- 7
- FWCI
- 3.59
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.