The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
Stress overshoot in a simple yield stress fluid: An extensive study combining rheology and velocimetry
Open accessAbstract
We report a large amount of experimental data on the stress overshoot phenomenon which takes place during start-up shear flows in a simple yield stress fluid, namely a carbopol microgel. A combination of classical rheological measurements and ultrasonic velocimetry makes it possible to get physical insights on the transient dynamics of both the stress σ(t) and the velocity field across the gap of a rough cylindrical Couette cell during the start-up of shear under an applied shear rate . (i) At small strains (γ < 1), σ(t) increases linearly and the microgel undergoes homogeneous deformation. (ii) At a time tm, the stress reaches a maximum value σm which corresponds to the failure of the microgel and to the nucleation of a thin lubrication layer at the moving wall. (iii) The microgel then experiences a strong elastic recoil and enters a regime of total wall slip while the stress slowly decreases. (iv) Total wall slip gives way to a transient shear-banding phenomenon, which occurs on timescales much longer than that of the stress overshoot and has been described elsewhere [Divoux et al., Phys. Rev. Lett., 2010, 104, 208301]. This whole sequence is very robust to concentration changes in the explored range (0.5 ≤ C ≤ 3%w/w). We further demonstrate that the maximum stress σm and the corresponding strain γm = tm both depend on the applied shear rate and on the waiting time tw between preshear and shear start-up: they remain roughly constant as long as is smaller than some critical shear rate w ∼ 1/tw and they increase as weak power laws of for > w. Finally, by changing the boundary conditions from rough to smooth, we show that there exists a critical shear rate s fixed by the wall surface roughness below which slip at both walls allows for faster stress relaxation and for stress fluctuations strongly reminiscent of stick-slip. Interestingly, the value of s is observed to coincide with the shear rate below which the flow curve displays a kink attributed to wall slip.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Shear yielding of amorphous glassy solids: Effect of temperature and strain rate
Rottler, J., & Robbins, M. O. (2003) · Physical Review E · doi:10.1103/physreve.68.011507 · Cited by 182
Cited by
Yield stress materials in soft condensed matter
Bonn, D., Denn, M. M., Berthier, L., Divoux, T., & Manneville, S. (2017) · Reviews of Modern Physics · doi:10.1103/revmodphys.89.035005 · Cited by 899
Self-citationDeformation and flow of amorphous solids: Insights from elastoplastic models
Nicolas, A., Ferrero, E. E., Martens, K., & Barrat, J.-L. (2018) · Reviews of Modern Physics · doi:10.1103/revmodphys.90.045006 · Cited by 498
On different ways of measuring “the” yield stress
Dinkgreve, M., Paredes, J., Denn, M. M., & Bonn, D. (2016) · Journal of Non-Newtonian Fluid Mechanics · doi:10.1016/j.jnnfm.2016.11.001 · Cited by 423
Random critical point separates brittle and ductile yielding transitions in amorphous materials
Ozawa, M., Berthier, L., Biroli, G., Rosso, A., & Tarjus, G. (2018) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.1806156115 · Cited by 298
Metadata
- Authors
- Divoux, T., Barentin, C., & Manneville, S.
- Venue
- Soft Matter
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2011
- Volume
- 7
- Issue
- 19
- Pages
- 9335
- ISSN
- 1744-683X (ISSN-L)
- 1744-6848
- OpenAlex
- W1983789195
- Cited by
- 158
- References
- 1
- FWCI
- 5.85
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Stress overshoot in a simple yield stress fluid: An extensive study combining rheology and velocimetry. https://app.cochat.ai/papers/10.1039/c1sm05740e
- The paper
- Divoux, T., Barentin, C., & Manneville, S. (2011). Stress overshoot in a simple yield stress fluid: An extensive study combining rheology and velocimetry. Soft Matter. https://doi.org/10.1039/c1sm05740e
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.