The DOI matches its Crossref record; 53 of the 53 references it cites were found in a registry or an index.
Removal of transition metals from rare earths by solvent extraction with an undiluted phosphonium ionic liquid: separations relevant to rare-earth magnet recycling
Open accessAbstract
An environmentally friendly process for the separation of the transition metals copper, cobalt, iron, manganese and zinc from rare earths by solvent extraction with the ionic liquid trihexyl(tetradecyl)phosphonium chloride has been developed. The solvent extraction process is carried out without the use of organic diluents or extra extraction agents and it can be applied as a sustainable hydrometallurgical method for removing transition metals from neodymium–iron–boron or samarium–cobalt permanent magnets. The recycling of rare earths is of high importance because of the possible supply risk of these elements in the near future. The method was tested for the removal of cobalt and iron from samarium and neodymium, respectively. The highest distribution ratios for cobalt and iron were found with 8.5 and 9 M HCl. At the tested conditions, the concentrations of neodymium and samarium in the ionic liquid were below 0.5 mg L−1 (0.5 ppm), even for feed concentrations of 45 g L−1. The separation factors of Nd/Fe and Sm/Co are 5.0 × 106 and 8.0 × 105, respectively. The percentage extraction of iron is still higher than 99.98% at loadings of the ionic liquids with 70 g L−1 of iron. The viscosity of the ionic liquid containing the tetrachloroferrate(III) complex [FeCl4]− is lower, and less depending on the feed concentration, than in the case with a tetrachlorocobaltate(II) anion [CoCl4]2−. After extraction, cobalt can be stripped very easily from the ionic liquid phase with water. However, due to the very high distribution ratio, iron could only be stripped by forming a water-soluble iron complex with ethylenediaminetetraacetic acid (EDTA). Also the possibility to extract chromium, nickel, aluminium, calcium and magnesium with trihexyl(tetradecyl)phosphonium chloride has been investigated, but the distribution ratios of these elements are very low in the tested conditions.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Room-Temperature Ionic Liquids: Solvents for Synthesis and Catalysis. 2
Hallett, J. P., & Welton, T. (2011) · Chemical Reviews · doi:10.1021/cr1003248 · Cited by 12,578
Room-Temperature Ionic Liquids. Solvents for Synthesis and Catalysis
Welton, T. (1999) · Chemical Reviews · doi:10.1021/cr980032t · Cited by 11,852
Ionic Liquids—New “Solutions” for Transition Metal Catalysis
Wasserscheid, P., & Keim, W. (2000) · Angewandte Chemie · doi:10.1002/1521-3773(20001103)39:21<3772::aid-anie3772>3.0.co;2-5 · Cited by 5,720
Applications of ionic liquids in the chemical industry
Plechkova, N. V., & Seddon, K. R. (2008) · Chem. Soc. Rev. · doi:10.1039/b006677j · Cited by 5,686
Hydrophobic, Highly Conductive Ambient-Temperature Molten Salts
Bonhôte, P., Dias, A.-P., Papageorgiou, N., Kalyanasundaram, K., & Grätzel, M. (1996) · Inorganic Chemistry · doi:10.1021/ic951325x · Cited by 4,358
Ionic Liquids--Solvents of the Future?
Rogers, R. D., & Seddon, K. R. (2003) · Science · doi:10.1126/science.1090313 · Cited by 4,130
(2002) · Wiley eBooks · doi:10.1002/3527600701 · Cited by 3,960
Magnetic Materials and Devices for the 21st Century: Stronger, Lighter, and More Energy Efficient
Gutfleisch, O., Willard, M. A., Brück, E., Chen, C. H., Sankar, S. G., & Liu, J. P. (2011) · Advanced Materials · doi:10.1002/adma.201002180 · Cited by 3,809
Huddleston, J. G., Visser, A. E., Reichert, W. M., Willauer, H. D., Broker, G. A., & Rogers, R. D. (2001) · Green Chemistry · doi:10.1039/b103275p · Cited by 3,712
Recycling of rare earths: a critical review
Binnemans, K., Jones, P. T., Blanpain, B., Van Gerven, T., Yang, Y., Walton, A., & Buchert, M. (2013) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2012.12.037 · Cited by 2,382
Self-citation
Cited by
REE Recovery from End-of-Life NdFeB Permanent Magnet Scrap: A Critical Review
Yang, Y., Walton, A., Sheridan, R., Güth, K., Gauß, R., Gutfleisch, O., Buchert, M., Steenari, B.-M., Van Gerven, T., Jones, P. T., et al. (2017) · Journal of Sustainable Metallurgy · doi:10.1007/s40831-016-0090-4 · Cited by 650
Self-citationIonic liquid gel materials: applications in green and sustainable chemistry
Marr, P. C., & Marr, A. C. (2016) · Green Chemistry · doi:10.1039/c5gc02277k · Cited by 472
Sethurajan, M., van Hullebusch, E. D., Fontana, D., Akcil, A., Deveci, H., Batinic, B., Leal, J. P., Gasche, T. A., Ali Kucuker, M., Kuchta, K., et al. (2019) · Critical Reviews in Environmental Science and Technology · doi:10.1080/10643389.2018.1540760 · Cited by 412
Halometallate ionic liquids – revisited
Estager, J., Holbrey, J. D., & Swadźba-Kwaśny, M. (2014) · Chem. Soc. Rev. · doi:10.1039/c3cs60310e · Cited by 308
Swain, N., & Mishra, S. (2019) · Journal of Cleaner Production · doi:10.1016/j.jclepro.2019.02.094 · Cited by 278
A comparative state-of-technology review and future directions for rare earth element separation
Opare, E. O., Struhs, E., & Mirkouei, A. (2021) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2021.110917 · Cited by 271
Are ionic liquids a proper solution to current environmental challenges?
Cevasco, G., & Chiappe, C. (2014) · Green Chemistry · doi:10.1039/c3gc42096e · Cited by 267
Metadata
- Authors
- Vander Hoogerstraete, T., Wellens, S., Verachtert, K., & Binnemans, K.
- Venue
- Green Chemistry
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2013
- Volume
- 15
- Issue
- 4
- Pages
- 919
- ISSN
- 1463-9262 (ISSN-L)
- 1463-9270
- OpenAlex
- W2158460233
- Cited by
- 360
- References
- 53
- FWCI
- 51.81
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.