CoChat

Electrochemical behavior of rapidly synthesized amorphous 3d-VIIIB-metal aerogels as bifunctional electrocatalysts for water splitting

Open access

The DOI matches its Crossref record; 34 of the 34 references it cites were found in a registry or an index; none of the 16 sources its claims cite is checked for support yet.

Abstract

The intrinsic material properties play a more decisive role in governing electrocatalytic performance than the presence of abundant oxygen vacancies.

Overview

CoChat Summary

TL;DR

Amorphous, oxygen-vacancy-rich Fe, Co, and Ni aerogels were rapidly synthesized by a one-step NaBH₄ reduction route and tested as bifunctional water-splitting electrocatalysts. The Co aerogel showed the best alkaline OER/HER activity and durability, while Fe and Ni aerogels were largely inactive in neutral electrolyte despite high oxygen-vacancy content.

Key findings

  • The Co aerogel had the highest oxygen-vacancy percentage (89.4%) and largest BET surface area (134.461 m² g⁻¹), compared with Ni (86.1%; 103.382 m² g⁻¹) and Fe (72.9%; 94.128 m² g⁻¹).
  • In 0.5 M KOH, the Co aerogel required overpotentials of 383 mV for OER and 365 mV for HER at 100 mA cm⁻²; Ni required 475 mV (OER) and 463 mV (HER), and Fe required 630 mV (OER) and 526 mV (HER).
  • In neutral 0.5 M PBS, only the Co aerogel showed discernible OER activity; Fe and Ni OER currents overlapped with bare carbon cloth. Neutral HER overpotentials at 100 mA cm⁻² were 464 mV for Co, 526 mV for Ni, and 623 mV for Fe.
  • The Co aerogel showed long-term alkaline stability over 70 h: OER overpotential increased by about 130 mV, while HER overpotential at −100 mA cm⁻² remained nearly constant, with only a 20 mV decrease.

Methods

  • Fe, Co, and Ni aerogels were synthesized by mixing 0.1 M metal(II) chloride precursors with 0.1 M NaBH₄ under ambient conditions, followed by washing and vacuum drying at 60 °C.
  • Characterization included XRD, BET N₂ adsorption–desorption, FE-SEM, HR-TEM, and XPS.
  • Electrochemical tests used a three-electrode configuration with 1 mg cm⁻² catalyst on carbon cloth, Pt counter electrode, and Ag/AgCl or Hg/HgO reference electrodes in 0.5 M PBS (pH 7) or 0.5 M KOH (pH 13.2); CV, EIS, chronopotentiometry, Tafel analysis, and double-layer capacitance measurements were performed.

Limitations

  • The paper states that the amorphous aerogel is thermodynamically metastable and more prone to structural degradation or surface reconstruction under harsh continuous polarization than crystalline counterparts.
  • The paper states that vigorous O₂/H₂ gas evolution at high current densities causes bubble accumulation that blocks active sites and increases mass-transport resistance, and that testing in an undivided batch cell without pH correction causes local and bulk pH fluctuations that contribute to apparent potential increases.
  • The paper notes that Tafel analysis for Fe in neutral HER and for Fe and Ni in neutral OER is not physically meaningful because their polarization curves overlap with bare carbon cloth; it also states that ECSA values are used only for relative comparison within the same electrolyte, not for cross-electrolyte absolute comparisons.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1039/d6ma00391e

Cites

34 of 34 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Fig. 1 Structural and morphology characterization of the as-synthesized aerogel. (a) XRD patterns. N2 adsorption-desorption isotherms of (b) Fe aerogel, (c) Co aerogel, and (d) Ni aerogel. FESEM images of (e) Fe aerogel, (f) Co aerogel, (g) Ni aerogel, and HRTEM images of (h) Fe aerogel, (i) Co aerogel, and (j) Ni aerogel.
Fig. 1 Structural and morphology characterization of the as-synthesized aerogel. (a) XRD patterns. N2 adsorption-desorption isotherms of (b) Fe aerogel, (c) Co aerogel, and (d) Ni aerogel. FESEM images of (e) Fe aerogel, (f) Co aerogel, (g) Ni aerogel, and HRTEM images of (h) Fe aerogel, (i) Co aerogel, and (j) Ni aerogel.CC-BY-NC · From the PDF
Fig. 2 High-resolution XPS spectra: (a) Fe 2p of Fe aerogel, (b) Co 2p of Co aerogel, (c) Ni 2p of Ni aerogel; and O 1s XPS spectra of (d) Fe aerogel, (e) Co aerogel, and (f) Ni aerogel.
Fig. 2 High-resolution XPS spectra: (a) Fe 2p of Fe aerogel, (b) Co 2p of Co aerogel, (c) Ni 2p of Ni aerogel; and O 1s XPS spectra of (d) Fe aerogel, (e) Co aerogel, and (f) Ni aerogel.CC-BY-NC · From the PDF
Fig. 3 Anodic OER electrocatalytic performance of as-prepared catalysts: iR -corrected CV ( v = 5 mV s  1 ; 3rd scan) in (a) 0.5 M KOH (pH = 13.2) and (d) 0.5 M PBS (pH = 7); Nyquist plots of the EIS data collected (b) at 1.52 V vs. RHE in 0.5 M KOH and (e) at 1.31 V vs. RHE in 0.5 M PBS; short-term CP collected at different current densities in (c) 0.5 M KOH and (f) 0.5 M PBS.
Fig. 3 Anodic OER electrocatalytic performance of as-prepared catalysts: iR -corrected CV ( v = 5 mV s 1 ; 3rd scan) in (a) 0.5 M KOH (pH = 13.2) and (d) 0.5 M PBS (pH = 7); Nyquist plots of the EIS data collected (b) at 1.52 V vs. RHE in 0.5 M KOH and (e) at 1.31 V vs. RHE in 0.5 M PBS; short-term CP collected at different current densities in (c) 0.5 M KOH and (f) 0.5 M PBS.CC-BY-NC · From the PDF
Fig. 4 The cathodic HER electrocatalytic performance of as-prepared catalysts: cyclic voltammograms ( v = 5 mV s  1 ; 3rd scan) in (a) 0.5 M KOH (pH = 13.2) and (d) 0.5 M PBS (pH = 7); Nyquist plots of the EIS data collected (b) at  0.3 V vs. RHE in 0.5 M KOH and (e) at  0.5 V vs. RHE in 0.5 M PBS; shortterm CP collected at different current densities in (c) 0.5 M KOH and (f) 0.5 M PBS.
Fig. 4 The cathodic HER electrocatalytic performance of as-prepared catalysts: cyclic voltammograms ( v = 5 mV s 1 ; 3rd scan) in (a) 0.5 M KOH (pH = 13.2) and (d) 0.5 M PBS (pH = 7); Nyquist plots of the EIS data collected (b) at 0.3 V vs. RHE in 0.5 M KOH and (e) at 0.5 V vs. RHE in 0.5 M PBS; shortterm CP collected at different current densities in (c) 0.5 M KOH and (f) 0.5 M PBS.CC-BY-NC · From the PDF
Fig. 5 (a) Anodic OER Tafel slopes of Co aerogel in neutral and alkaline electrolytes, (b) performance comparison of the Tafel slope and overpotential at j = 100 mA cm  2 among different reported Co-based catalysts for anodic OER performance in alkaline environments (see detailed information in Table S6, SI). (c) Cathodic HER Tafel slope of Co aerogel in neutral and alkaline electrolytes, (d) performance comparison of the Tafel slope and overpotential at j = 100 mA cm  2 among different reported Co-based catalysts for cathodic HER performance in alkaline environments (see detailed information in Table S7, SI).
Fig. 5 (a) Anodic OER Tafel slopes of Co aerogel in neutral and alkaline electrolytes, (b) performance comparison of the Tafel slope and overpotential at j = 100 mA cm 2 among different reported Co-based catalysts for anodic OER performance in alkaline environments (see detailed information in Table S6, SI). (c) Cathodic HER Tafel slope of Co aerogel in neutral and alkaline electrolytes, (d) performance comparison of the Tafel slope and overpotential at j = 100 mA cm 2 among different reported Co-based catalysts for cathodic HER performance in alkaline environments (see detailed information in Table S7, SI).CC-BY-NC · From the PDF
Fig. 6 (a) C dl values of Co aerogel in neutral and alkaline environments. Long-term stability before and after 200 CV cycles (scan rate: 5 mV s  1 ) for (b) anodic OER in 0.5 M KOH and (c) cathodic HER in 0.5 M KOH. Time-dependent CP curves of Co aerogel (d) in anodic OER in 0.5 M KOH and (e) in cathodic HER in 0.5 M KOH.
Fig. 6 (a) C dl values of Co aerogel in neutral and alkaline environments. Long-term stability before and after 200 CV cycles (scan rate: 5 mV s 1 ) for (b) anodic OER in 0.5 M KOH and (c) cathodic HER in 0.5 M KOH. Time-dependent CP curves of Co aerogel (d) in anodic OER in 0.5 M KOH and (e) in cathodic HER in 0.5 M KOH.CC-BY-NC · From the PDF

Verification

Claims the paper makes

0 Valid · 1 Not valid · 9 Not checked · 40 Own results and interpretations

20 more claims

Create a free account to see all 50 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 24
  • The quote only partly states this claim. 1
  • Probably not a substantial claim. 1

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

3 of 3

Citations

Cites

Cited by

See all 2

Metadata

Authors
Phu, T. K. C., Nguyen, N.-T., Nguyen, P. L., Le, N. N., & Phung, T. V. B.
Affiliations
  • VinUniversity (VN)
  • Van Lang University (VN)
Corresponding author
  • Le, Ngan Nguyen
  • Phung, Thi Viet Bac
Venue
Materials Advances
Published
2026
Volume
7
Issue
13
Pages
6528-6536
ISSN
2633-5409 (ISSN-L)
OpenAlex
W7161111376
Cited by
2
References
34
Citations by year
2026: 2
FWCI
1.73
Type
journal article
Language
en
Open access
Locations
Materials Advances (publishedVersion, cc-by-nc)
Topics
  • Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Electrocatalysts for Energy Conversion
  • Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › CO2 Reduction Techniques and Catalysts
  • Physical Sciences › Materials Science › Electronic, Optical and Magnetic Materials › Supercapacitor Materials and Fabrication
Keywords
rapid synthesis, bifunctional electrocatalysts, water splitting, oxygen vacancies, electrochemical properties

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

A language model drew the claims from the paper on 2026-10-11, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-11 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.