The DOI matches its Crossref record.
Improvement in Al2O3 dielectric behavior by using ozone as an oxidant for the atomic layer deposition technique
Abstract
We have prepared Al2O3 films by the atomic layer deposition technique using trimethylaluminum as the precursor for aluminum and O3, instead of commonly used H2O, as an oxidant. We show that even without any postdeposition annealing or any preventive layer between the Al2O3 film and Si substrate to suppress the formation of metallic clusters, the Al2O3 films prepared using O3 have significantly less amount of defect states like Al–Al and OH bonds compared with those prepared by H2O. The films show device quality leakage characteristics, with Al2O3 film prepared with O3 showing a leakage current density one or two orders lower and a smaller flatband voltage shift than that of Al2O3 film prepared with H2O, demonstrating improved interface characteristics. The former also shows a very low wet etch rate.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Atomic Layer Deposition: An Overview
George, S. M. (2010) · Chemical Reviews · doi:10.1021/cr900056b · Cited by 5,814
Surface chemistry of atomic layer deposition: A case study for the trimethylaluminum/water process
Puurunen, R. L. (2005) · Journal of Applied Physics · doi:10.1063/1.1940727 · Cited by 2,609
Crystallinity of inorganic films grown by atomic layer deposition: Overview and general trends
Miikkulainen, V., Leskelä, M., Ritala, M., & Puurunen, R. L. (2013) · Journal of Applied Physics · doi:10.1063/1.4757907 · Cited by 1,413
Catalyst Design with Atomic Layer Deposition
O’Neill, B. J., Jackson, D. H. K., Lee, J., Canlas, C., Stair, P. C., Marshall, C. L., Elam, J. W., Kuech, T. F., Dumesic, J. A., & Huber, G. W. (2015) · ACS Catalysis · doi:10.1021/cs501862h · Cited by 782
Self-citationRitala, M., & Leskelä, M. (2002) · Handbook of Thin Films · doi:10.1016/b978-012512908-4/50005-9 · Cited by 451
Metadata
- Authors
- Kim, J. B., Kwon, D. R., Chakrabarti, K., Lee, C., Oh, K. Y., & Lee, J. H.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2002-12-01
- Volume
- 92
- Issue
- 11
- Pages
- 6739-6742
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W1963550018
- Cited by
- 170
- References
- 0
- FWCI
- 4.56
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Improvement in Al2O3 dielectric behavior by using ozone as an oxidant for the atomic layer deposition technique. https://app.cochat.ai/papers/10.1063/1.1515951
- The paper
- Kim, J. B., Kwon, D. R., Chakrabarti, K., Lee, C., Oh, K. Y., & Lee, J. H. (2002). Improvement in Al2O3 dielectric behavior by using ozone as an oxidant for the atomic layer deposition technique. Journal of Applied Physics. https://doi.org/10.1063/1.1515951
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.