The DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Experimental study on the influence of foam porosity and pore size on the melting of phase change materials
Abstract
Experimental study was carried out to study the phase change heat transfer within a composite of phase change material (PCM) infiltrated high thermal conductivity foam. An experimental setup was built to measure the temperature profiles and capture the melting evolution of the PCM inside aluminum foams. Aluminum foams were used as the porous material, and low melting temperature paraffin wax was used as the PCM. It was observed from the results that the system parameters of the wax/foam composite had a significant influence on its heat transfer behavior. By using higher porosity aluminum foam, the steady-state temperature was reached faster as compared to the foams with lower porosity. Similarly for the bigger pore size foams the steady state was attained faster as compared to the smaller pore size foams. This was due to the greater effect of convection in both the higher porosity and bigger pore size foams. However, for the lower porosity foams the heater temperature was comparatively lower than the higher porosity foams due to greater heat conduction through the foam material. Therefore, an optimal value should be selected for the foam porosity and pore size such that the effects of both conduction and convection heat transfers can be completely utilized to have a greater and improved thermal performance for the wax/aluminum foam composite.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Thermophysical Properties of Matter
Touloukian, Y. S. (1995) · CERN Document Server (European Organization for Nuclear Research) · Cited by 3,282
The Physics of Flow Through Porous Media
SCHEIDEGGER, A. E. (1958) · Soil Science · doi:10.1097/00010694-195812000-00015 · Cited by 2,596
Velraj, R., Seeniraj, R. V., Hafner, B., Faber, C., & Schwarzer, K. (1999) · Solar Energy · doi:10.1016/s0038-092x(98)00128-5 · Cited by 476
Thermal conductivity enhancement of energy storage media using carbon fibers
Fukai, J., Kanou, M., Kodama, Y., & Miyatake, O. (2000) · Energy Conversion and Management · doi:10.1016/s0196-8904(99)00166-1 · Cited by 395
An experimental study of enhanced heat transfer in rectangular PCM thermal storage
Stritih, U. (2004) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2004.02.001 · Cited by 304
Heat transfer enhancement in water when used as PCM in thermal energy storage
Cabeza, L. F., Mehling, H., Hiebler, S., & Ziegler, F. (2002) · Applied Thermal Engineering · doi:10.1016/s1359-4311(02)00035-2 · Cited by 281
Eichenauer, W. (1971) · Berichte der Bunsengesellschaft für physikalische Chemie · doi:10.1002/bbpc.19710751034 · Cited by 207
Heat and mass transfer in consolidated reacting beds for thermochemical systems
Mauran, S., Prades, P., & L'Haridon, F. (1993) · Heat Recovery Systems and CHP · doi:10.1016/0890-4332(93)90055-z · Cited by 189
Effect of carbon-fiber brushes on conductive heat transfer in phase change materials
Fukai, J., Hamada, Y., Morozumi, Y., & Miyatake, O. (2002) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(02)00179-5 · Cited by 186
Hamada, Y., Ohtsu, W., & Fukai, J. (2003) · Solar Energy · doi:10.1016/j.solener.2003.07.028 · Cited by 113
Cited by
Preparation and thermal characterization of paraffin/metal foam composite phase change material
Xiao, X., Zhang, P., & Li, M. (2013) · Applied Energy · doi:10.1016/j.apenergy.2013.04.050 · Cited by 627
Ji, H., Sellan, D. P., Pettes, M. T., Kong, X., Ji, J., Shi, L., & Ruoff, R. S. (2014) · Energy Environ. Sci. · doi:10.1039/c3ee42573h · Cited by 592
Ibrahim, N. I., Al-Sulaiman, F. A., Rahman, S., Yilbas, B. S., & Sahin, A. Z. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.01.169 · Cited by 580
Zhang, F., Feng, Y., & Feng, W. (2020) · Materials Science and Engineering: R: Reports · doi:10.1016/j.mser.2020.100580 · Cited by 566
Ling, Z., Zhang, Z., Shi, G., Fang, X., Wang, L., Gao, X., Fang, Y., Xu, T., Wang, S., & Liu, X. (2014) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2013.12.017 · Cited by 558
Metadata
- Authors
- Lafdi, K., Mesalhy, O., & Shaikh, S.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2007-10-15
- Volume
- 102
- Issue
- 8
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W1984301776
- Cited by
- 291
- References
- 14
- FWCI
- 3.07
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Experimental study on the influence of foam porosity and pore size on the melting of phase change materials. https://app.cochat.ai/papers/10.1063/1.2802183
- The paper
- Lafdi, K., Mesalhy, O., & Shaikh, S. (2007). Experimental study on the influence of foam porosity and pore size on the melting of phase change materials. Journal of Applied Physics. https://doi.org/10.1063/1.2802183
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.