Photopatterning the mechanical properties of polydimethylsiloxane films
Open accessThe DOI matches its Crossref record.
Abstract
Silicone rubber films with graded and localized mechanical properties are prepared using two-part polydimethylsiloxane (PDMS) elastomer, photoinhibitor compounds and conventional photolithography. First the un-cross-linked PDMS is mixed with benzophenone. The resulting positive photosensitive material is then exposed through a mask to UV light from a conventional mask aligner. Cross-linking of the UV exposed elastomer is inhibited, leading to softer regions than the surrounding unexposed matrix. By empirically fitting the nonlinear, hyperelastic Mooney–Rivlin model to experimentally measured stress–strain curves we determine the equivalent tensile modulus (E) of the rubber film. We show the PDMS tensile modulus can then be adjusted in the 0.65–2.9 MPa range by decreasing the UV exposure dose (from 24 000 to 0 mJ cm−2). Further, using a patterned UV mask, we can locally define differential regions of tensile modulus within a single PDMS rubber film. We demonstrate that “hard islands” (E ≈ 2.9 MPa) of 100 μm minimum diameter can be patterned within a 100-μm-thick, single “soft” PDMS rubber membrane (E ≈ 0.65 MPa) cured at 150 °C for 24 h. Thin gold film conductors patterned directly onto the photopatterned PDMS are stretchable and withstand uniaxial cycling to tens of percent strain. The mechanically “pixellated” PDMS rubber film provides an improved substrate with built-in strain relief for stretchable electronics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Hammock, M. L., Chortos, A., Tee, B. C. ‐., Tok, J. B. ‐., & Bao, Z. (2013) · Advanced Materials · doi:10.1002/adma.201302240 · Cited by 2,396
Printable elastic conductors with a high conductivity for electronic textile applications
Matsuhisa, N., Kaltenbrunner, M., Yokota, T., Jinno, H., Kuribara, K., Sekitani, T., & Someya, T. (2015) · Nature Communications · doi:10.1038/ncomms8461 · Cited by 869
Materials for stretchable electronics
Wagner, S., & Bauer, S. (2012) · MRS Bulletin · doi:10.1557/mrs.2012.37 · Cited by 449
Harris, K. D., Elias, A. L., & Chung, H.-J. (2016) · Journal of Materials Science · doi:10.1007/s10853-015-9643-3 · Cited by 403
“demonstrated that the mechanical properties of PDMS could be photopatterned to locally soften the substrate in regions intended to support interconnects rather than rigid components [72].”
BackgroundPDMS‐Based Elastomer Tuned Soft, Stretchable, and Sticky for Epidermal Electronics
Jeong, S. H., Zhang, S., Hjort, K., Hilborn, J., & Wu, Z. (2016) · Advanced Materials · doi:10.1002/adma.201505372 · Cited by 363
Metadata
- Authors
- Cotton, D. P. J., Popel, A., Graz, I. M., & Lacour, S. P.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2011-03
- Volume
- 109
- Issue
- 5
- Pages
- 054905
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2003717814
- Cited by
- 58
- References
- 0
- FWCI
- 7.97
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Photopatterning the mechanical properties of polydimethylsiloxane films. https://app.cochat.ai/papers/10.1063/1.3552917
- The paper
- Cotton, D. P. J., Popel, A., Graz, I. M., & Lacour, S. P. (2011). Photopatterning the mechanical properties of polydimethylsiloxane films. Journal of Applied Physics. https://doi.org/10.1063/1.3552917
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.